The work described was undertaken to provide data for nuclear safety studies concerning NPF reprocessing equipment. The original objective was to determine the uranium density and water (hydrogen) content of UO2-H2O mixtures ranging from compact centrifuge cakes to dilute slurries. The scope was later expanded to include mixtures of UO2 with hydrocarbon oil and mixtures of UO3-H2O.

This report discusses properties of the Redox process. Density, apparent molar volumes and viscosity are all described.

"This is a bibliography of journal articles relating to beryllium oxide. Sources consulted include; Chemical Abstracts, 1951-1955; Physics Abstracts, 1951-1955; Industrial Arts Index, 1955-Jan, 1957; and the library card catalog. Starred articles are available in the library.

This report follows the study of the oxidation of plutonium III and IV to the plutonyl state.

This report discusses methods for preparing thin films of plutonium on metallic disks, which are used for alpha energy analysis, fission counting, and preparation of geometry standards in ordinary counting. Various methods of preparation were tested and analyzed, but electrodeposition was the most effective method. Deposition was then tested, but the yields were "somewhat erratic".

Below Richland, Washington there is a gradual decrease in the concentration of beta particle emitters in the Columbia River water. The concentration of alpha particle emitters in Columbia River water averages 5 X 10⁻⁹ μl/ml at all locations. The activity of alpha particle emitters in mud samples was less than the detection limit of 3 x 10⁻⁶ μl/gm; the average activity density of beta particle emitters approximates those reported for the previous quarter.

From introduction: "This investigation was undertaken with the general objective of determining whether uranium core could be sheathed with aluminum by an extrusion-cladding process. The ultimate objective of this work was to determine the feasibility of extrusion cladding flat plates of uranium."

In order to test the effect of chromate ion on the corrosion of Zircaloy-2, a 0.04 m uranyl sulfate solution (enriched) containing added acid, copper sulfate and 557 ppm of Cr (VI) was autoclaved with rocking at 280 degrees C for about eight days in the HB-5 facility of the LITR. The average corrosion rate established by the rate of consumption of oxygen was 9.9 mpy at a power density of 4.9 w/ml. It is indicated by comparison with a previous corrosion study under LITR radiation that the presence of Cr (VI) had no significant effect on the radiation corrosion of Zircaloy-2 by enriched uranyl sulfate solutions. However, the data are not conclusive and may be interpreted as showing a low corrosion rate for a limited period (i.e. a short term inhibition) followed by correspondingly rapid corrosion.

In order to test the effect of chromate ion on the corrosion of Zircaloy-2 a 0.04 m uranyl sulfate solution (enriched) containing added acid, copper sulfate and 557 ppm Cr (VI) was autoclaved with rocking at 280 C for about eight days in the HB-5 facility of the LITR. The average corrosion rate established by the a rate of consumption of oxygen was 9.9 mpy at a power density of 4.9 w/ml. It is indicated by comparison with a previous corrosion study under LITR radiation that the presence of Cr (VI) had no significant effect on the radiation corrosion of Zircaloy-2 by enriched uranyl sulfate solutions. However, the data are not conclusive and may be interpreted as showing a low corrosion rate for a limited period (i.e. a short term inhibition) followed by a correspondingly rapid corrosion.