From Introduction: "This report investigates some of the problems involved in scheduling the tailpipe temperature to avoid stall during acceleration. The object of this report is to investigate the dynamics of a closed-loop acceleration control that follows a schedule of tailpipe temperature with rotor speed."

Report presenting testing of gaseous hydrogen fuel burned in a connected-pipe combustor with a cross section equal to 35 degrees sector of a 28-inch diameter. Eleven shrouded fuel-injector configurations were used to obtain combustion data at specified high-altitude ramjet combustor conditions. Results regarding shroud air blockage, mixing tabs, higher equivalence-ratio burning, injector size, flameholder durability, burner length, combustion efficiency, and temperature profile are provided.

"A turbojet engine incorporating a conventional-type afterburner was operated over a range of afterburner pressure levels from 1000 to 2000 pounds per square foot absolute and a range of engine-inlet water-air ratios from 0 to 0.08. At each pressure level and water-air ratio, the afterburner fuel flow was varied from lean blowout to maximum burner-outlet temperature" (p. 1).

Report presenting testing of a turbojet engine incorporating a conventional-type afterburner over a range of afterburner pressure levels and engine-inlet water-air ratios. At each pressure level and water-air ratio, the afterburner fuel flow was varied from lean blowout to maximum burner-outlet temperature. Results regarding the effects of water vapor on engine performance, effects of water vapor on afterburner performance, and high Mach number performance with water injection are provided.

Memorandum presenting performance calculations for hypothetical hydrogen expansion engines in which only a small part of the engine airflow passes through the heat exchanger. The flight path was representative of those for long-range, high-speed aircraft. Results regarding the off-design operation and engine performance are provided.

Memorandum presenting performance calculations made for hypothetical hydrogen expansion engines in which only a small part of the engine airflow passes through the heat exchanger. The prescribed flight path was representative of those for long-range, high-speed aircraft. Results regarding the off-design operation and engine performance are provided.

Report presenting some measurements of the vortex movements with time about an airfoil undergoing a blast of sufficient strength to exceed the stall angle by a large amount. Measurements were also obtained without flight simulation but with blast orientation and strength and compared to the first test. Results regarding Schileren photographs, presentation of results, and discussion of results are provided.

Report presenting measurements of aerodynamic heat transfer at a number of stations along a cone-cylinder-flare model with 15 degree total-angle conical nose and a 10 degree half-angle flare skirt. Results regarding temperature measurements and heating rates, local flow parameters, heat transfer with theoretical recovery factors, experimental recovery factors, prediction of skin temperatures, and transition are provided.

Report described five short multielement turbojet combustors for use with hydrogen fuel and their performance. Information about the combustion efficiency, temperature profiles, pressure loss, durability, and comparison with previous short combustors is included.

Report presenting an investigation of five short multielement turbojet combustors designed for use with hydrogen fuel tested in a quarter-annulus duct. One combustor had an array of U-gutter flame-holders, while the other four were manifold arrays of swirl-can combustor elements. Results regarding combustion efficiency, temperature profiles, pressure loss, durability, comparison with previous short combustors, and operation with propane fuel are provided.

Memorandum presenting the results of a simulator stud of the factors affecting the design of a device, a stick pusher, for preventing a representative supersonic airplane from entering the pitch-up region. The effects of varying the stick-pusher-activation boundaries, sensing parameters, and magnitude of stick-pusher force on the controllability of the airplane pitch-up were investigated.

Report presenting the results of an investigation of the static longitudinal stability and control characteristics of a canard airplane configuration without analysis for a range of Mach numbers. Data are presented for a variety of angles of attack and canard angles.