Introduction: "A limited test progress for the evaluation of type 347 stainless steel pipe which failed the Huey (?) test has been complicated. The tests reported herein were similar in scope to those reported in document number EW-20765, Corrosion Tests on Stainless Steel Plate, Waste Metal Recovery Process. Material tested was obtained on order number EWC-8553, National Tube Company Heat #3X9741. Lots 9789 and 9790."

The Redox process uses or produces only a very few materials that are hazardous for reasons other than radioactivity. The conditions under which these materials become hazardous were carefully taken into consideration in the development of the process and design of the equipment. A considerable about of information on the hazardous properties of the process materials was obtained so that the pertinent material could be incorporated into the process specifications. Providing the equipment is operating properly and the process is being carried out within specification limits, no hazardous conditions can be created by the process. The purpose of this report is to assemble in a single, readily available document all of the information on the normal concentration limits and safe handling procedures needed to adequately control the use and storage of these materials. This report should be helpful in preparing safety bulletins and provide guidance in case of unusual incidents, malfunctioning of equipment, or contemplated changes in either the process or equipment. It is important to remember that a maximum allowable concentration (MAC) is only a limit on the concentration of a toxic material which cannot be exceeded in the air to which workers are constantly exposed to every working …

The major portion of transfers and inventory in the Chemical Processing Department are dependent on volume measurement. Good volume measurements are therefore essential to good SS material control. Considerable attention has been given to the volume problem especially on primary transfer points. Document HW-57888 discusses the biasing effect pf temperature on manometer oil. HW- 57866 given the procedure for vessel calibration. Other undocumented correspondence has discussed recent calibrations and certain aspects of temperature considerations in the volume determinations. However, there is a need to document for future reference the consideration given temperature and provide at the same time information which covers the temperature angle on all volume methods used in the Chemical Processing Department.