The Schroedinger Integral Equation is derived for an N-body system, and solutions for required Green's functions are obtained. The initial method of numerical solution has yielded the correct ground states and lower excited states of He (test case) and dt..mu... Steps are being taken to improve the numerical accuracy.

The effect of transverse displacements of combined function magnets is investigated where the disperion in not matched due to roll. This dispersion function is perturbed by displacement of combined function magnets either singly or coherently. In the latter case the effect of a systematic (or DC) offset of magnets is examined. This type of error can occur due to systematics in the placement or the readout of Beam Position Monitors or equivalently by correcting the orbit of a beam of the wrong momentum with respect to the Arc magnet excitation. 5 refs., 18 figs.

This paper presents a design chart to aid designers in the selection of a wall thickness for long cylindrical shells having atmospheric pressure outside the shell and a pressure less than atmospheric inside the shell. The chart indicates a conservative value for the minimum wall thickness for a given shell diameter and material when the shell is completely evacuated.

The electron-photon transport code SANDYL has been used to calculate the x-ray flux for a simplified Flash X-Ray Machine (FXR) bullnose geometry. Four different thicknesses (24.5, 36.75, 49, and 61.25 mils) were used for the tantalum bremsstrahlung target in order to study the effect of target thickness on the FXR output. The calculations were performed for a parallel 17 MeV electron beam, and the resulting angular distributions were then used to compute the forward flux for the more realistic case of a converging beam. Over the range of thicknesses studied, the x-ray energy content per steradian on axis was essentially independent of target thickness. The main reason for this is that, while the total x-ray flux coming out of the target increases with increasing target thickness, the angular width of that flux also increases. The implications for target wheel design are discussed. 3 refs., 7 figs.

This report contains the results of calculations for a resized nozzle on the D-Zero test cryostat. The nozzle neck in the inner vessel with be 6-inch schedule 10S pipe and 8-inch 10S will be used for the outer vessel. On top of the nozzle will be placed the D-Zero Endcap Calorimeter signal board feedthru dewar box. This box weighs approximately 250 lbs but the weight was conservatively taken to be 500 lbs. The allowable pressure from above does not exceed 15 psig per ASME, but it does exceed 7.5 psig required by CGA-341 therefore reinforcement is not required. Note that the reinforcement provided by the nozzle neck in combination with the excess shell thickness is probably sufficient to satisfy the ASME requirements.

Weekly report of the Texas Agricultural Statistics Service on broiler chick numbers in Texas and compared with other states. It includes compiled statistics across six consecutive weeks, from the week ending September 13 to the week ending October 18, during 1985 and 1986 for broiler eggs set, chicks hatched, and chicks placed.

Weekly report of the Texas Crop and Livestock Reporting Service on broiler chick numbers in Texas and compared with other states. It includes compiled statistics across six consecutive weeks, the week ending on December 14 to the week ending on January 18, during 1984, 1985, and 1986 for broiler eggs set, chicks hatched, and chicks placed.

"This Info Pack includes a summary of the [Tax Reform Act of 1986] and provides information on the following topics: general provisions affecting individuals, treatment of real estate and second homes, retirement savings provisions and pensions, [and] corporate tax change overview" (p. 1).