For a number of investigations, including fundamental studies of radiation effects on living tissues and therapeutic utilization of radioisotopes, it is valuable to have methods for the selective localization of radioisotopes in certain tissues. Finely dispersed anhydrous chromic phosphate has been found useful by Jones, Wrobel, and Lyons in selectively irradiating the liver and spleen with p{sup 32} beta particles. The present studies, reported in this and the following communication, are concerned with methods for controlled selective localization of colloids (incorporating radioisotopes) in the liver, spleen, or bone marrow, and with an analysis of some of the factors involved in the phenomenon of localization.

Several workers have shown that certain colloidally dispered materials are removed from the blood stream by the liver and spleen. Jones, Wrobel, and Lyons have utilized suspensions of anhydrous chromic phosphate for the selective irradiation of the liver and spleen with p{sup 32} beta particles. Gersh demonstrated that colloidal calcium phosphate is taken up by the liver and spleen. He stressed the failure of bone marrow phagocytes to take up this colloid in rats and dogs (though he referred to possible uptake in the marrow of rabbits under special conditions), and commented on the relative 'refractoriness' in general of the bono marrow as compared with liver and spleen with respect to the uptake of colloidal dyes from the blood stream. Some histological data indicate that 'Thorotrast' (a colloidal thorium dioxide preparation) is deposited in the bone marrow as well as in the liver and spleen, but no quantitative data as to the relative distribution are available. In the preceding communication the methods for the preparation of colloids incorporating radioisotopes of yttrium, columbium, and zirconium were given. The present studies are concerned with the localization of such colloids primarily in the bone marrow or primarily in the spleen and liver, with …

None

None

Report presenting an investigation of a one-eighth segment of an annular combustor suitable for use as a component of an experimental turbojet engine. Due to the small space available for the combustor, a special design involving a minimum of obstructions in the combustion chamber was created. Results regarding the temperature-rise efficiency, total-pressure loss, and exhaust-gas temperature variation for several simulated engine operating conditions are provided.

From Introduction: "This paper presents the results of the investigation of wing-alone and wing-fuselage combinations employing a wing with the quarter-chord line swept back 35^o, aspect ratio 4, taper ratio 0.6, and NACA 65A006 airfoil section."

Report presenting testing on parabolic bodies of revolution of two fineness ratios in the transonic and supersonic range. One had a body fineness ratio of 7.87 and one had a ratio of 12 and were tested under different Mach number ranges. Experimental results and drag estimates of various portions of the body are provided.

Technical report abstract: Since UNH is a highly dissociated compound which ionizes to NO3 and (UO2), the latter ion being very weakly basic, a solution of pure UNH is quite acid (pH about 3). It is possible to titrate to a phenolphthalein and point with standard caustic solution and obtain a figure which represents the free acid plus the NO3 from the the UNH. However, titration of the free nitric acid alone in such a solution presents quite a problem. By precipitating and removing uranium from solution by means of potassium ferrocyanide, the residual free acid may be titrated directly by means of standard caustic using either methyl red or phenolphthalein indicators, with an error of less than 4%. A method is given to determine formic acid, should that acid be present in the mixture.

An attempt is made to estimate the influence of operation upon the mechanical properties of tubealloy. It is to be emphasized that the work is highly speculative, being base upon a set of judicious assumptions regarding the transport material within the metal and should not be used as a substitute for a set of well-planned experiments. The two principal effects considered are the hardening which results from the atomic displacement produced by the fission fragments and the changes in mechanical properties arising from the presence of the fission products. The principal conclusion to be drawn is that the disruption of the metal which accompanies operation takes place at at sufficiently high rate that it could readily cause serious changes in the mechanical properties of the slups. the reversal of the disruption resulting from thermal effects probably is sufficiently high to prevent serious embrittlement as a consequence of displacement through most of the volume of the slug if not at the surface. On the other hand, the migration of atoms also appears to be sufficiently high that the rare gas products may have time to diffuse to cracks and produce embrittlement.