From Summary: "In order to give the large-scale characteristics of a variety of airfoils in a form which will be of maximum value, both for airplane design and for the study of airfoil characteristics, a collection has been made of the results of airfoil tests made at full-scale values of the Reynolds number in the variable density wind tunnel of the National Advisory Committee for Aeronautics. They have been corrected for tunnel wall interference and are presented not only in the conventional form but also in a form which facilitates the comparison of airfoils and from which corrections may be easily made to any aspect ratio. An example showing the method of correcting the results to a desired aspect ratio has been given for the convenience of designers. In addition, the data have been analyzed with a view to finding the variation of the aerodynamic characteristics of airfoils with their thickness and camber."

"This reports presents the results of pressure distribution tests on a thick, tapered and twisted monoplane wing model. The investigation was conducted for the purpose of obtaining data on the aerodynamic characteristics of the new wing and to provide additional information suitable for use in the design of tapered cantilever wings. The tests included angles of attack up to 90 degrees. The span loading over the wing was approximately of elliptical shape, which gave rise to relatively small bending moments about the root" (p. 97).

"An investigation conducted to determine the factors which control the combustion in a high-speed compression-ignition engine is presented. Indicator cards were taken with the Farnboro indicator and analyzed according to the tangent method devised by Schweitzer. The analysis show that in a quiescent combustion chamber increasing the time lag of auto-ignition increases the maximum rate of combustion. Increasing the maximum rate of combustion increases the tendency for detonation to occur" (p. 63).

This is the second report giving the results obtained in the NACA 20-foot wind tunnel on the drag due to landing gears. The present report gives the results of tests of nonretractable and partly retractable landing gears intended for heavier low-wing monoplanes of the transport and bomber type.

The tests reported in this report conclude the investigation of landing-gear drag that has been carried out in the NACA 20-foot wind tunnel. They supplement earlier tests (reported in Technical Report No. 485) made with full-scale dummy wheels, wheel fairings, and landing gears intended for airplanes of 3,000 pounds gross weight and include tests of tail wheels and tail skids.

"A series of wind tunnel tests of a rectangular Clark Y wing was made with the NACA spinning balance as part of a general program of research on airplane spinning. All six components of the aerodynamic force and moment were measured throughout the range of angles of attack, angles of sideslip, and values omega b/2v likely to be attained by a spinning airplane; the results were reduced to coefficient form. It is concluded that a conventional monoplane with a rectangular Clark y wing can be made to attain spinning equilibrium throughout a wide range of angles of attack but that provision of a yawing moment coefficient of -0.02 (against the spin) by the tail, fuselage, and interferences will insure against attainment of equilibrium in a steady spin" (p. 231).

Report presents the results of an experimental investigation made in the NACA full-scale wind tunnel to determine the effect of wing span on nacelle-propeller characteristics and, reciprocally, the lateral extent of nacelle and propeller influence on a monoplane wing. The results provide a check on the validity of the previous research on nacelles and propellers with 15-foot-span wings tested in the 20-foot wind tunnel and reported in technical reports 415, 462, 505, 506, and 507.

Tables are given for determining the load distribution of tapered wings with partial-span flaps placed either at the center or at the wing tips. Seventy-two wing-flap combinations, including two aspect ratios, four taper ratios, and nine flap lengths, are included. The distributions for the flapped wing are divided into two parts, one a zero lift distribution due primarily to the flaps and the other an additional lift distribution due to an angle of attack of the wing as a whole. Comparison between theoretical and experimental results for wings indicate that the theory may be used to predict the load distribution with sufficient accuracy for structural purposes.

From Summary: "Section characteristics for use in wing design are presented for the NACA 23012 airfoil with plain and split flaps of 20 percent wing chord at a value of the effective Reynolds number of about 8,000,000. The flap deflections covered a range from 60 degrees upward to 75 degrees downward for the plain flap and from neutral to 90 degrees downward for the split flap. The split flap was aerodynamically superior to the plain flap in producing high maximum lift coefficients and in having lower profile-drag coefficients at high lift coefficients."

Report discussing an analysis has been made by the NACA of the effects of heat and compressibility in the flow through the internal systems of aircraft along with equations and charts are developed whereby the flow characteristics at key stations in a typical internal system may be readily obtained.

Report discussing an investigation of the flight qualities of the Bell P-39D-1 airplane. Information about the longitudinal stability and control characteristics, lateral and directional stability and control, stalling characteristics, and control friction is provided.

Report discussing tests on the effect of 2-percent additions of 13 aromatic amines on the knock-limited performance of 28-R fuel in a CFR engine. The amines tested gave good rich mixture response at standard F-4 operating conditions, but were sensitive to engine severity at lean fuel-air ratios.

Report discussing an investigation to determine whether the crank angle for maximum rate of pressure rise can be used to indicate maximum-economy spark advance. Information about spark-advance tests at constant inlet-air pressure and fuel-air-ratio test results are provided.

Report discussing an investigation into several types and sizes of flaps and spoilers located forward of the elevators on the upper surface of the horizontal stabilizer of a model of a radial-engine pursuit airplane. Information about the elevator characteristics, elevator-fixed and elevator-free balance lift coefficient, and trim drag coefficient for a range of Mach numbers is provided.

"The theory of the hydraulic analogy -- that is, the analogy between water flow with a free surface and two-dimensional compressible gas flow -- and the limitations and conditions of the analogy are discussed. A test was run using the hydraulic analogy as applied to the flow about circular cylinders of various diameters at subsonic velocities extending into the supercritical range. The apparatus and techniques used in this application are described and criticized" (p. 311).

"A flight investigation was made to determine the effect of various vertical-tail modifications and of some combinations of these modifications on the directional stability and control characteristics of a propeller-driven fighter airplane. Six different vertical-tail configurations were investigated to determine the lateral-directional oscillation characteristics, the sideslip characteristics, the yaw due to ailerons in rudder-fixed rolls from turns and pull-outs, the trim changes due to speed changes, and the trim changes due to power changes. Results of the tests showed that increasing the aspect ratio of the vertical tail by 40 percent while increasing the area by only 12 percent approximately doubled the directional stability of the airplane" (p. 453).

"On the basis of a recently developed theory for finite sweptback wings at supersonic speeds, calculations of the supersonic wave drag at zero lift were made for a series of wings having thin symmetrical biconvex sections with untapered plan forms and various angles of sweepback and aspect ratios. The results are presented in a unified form so that a single chart permits the direct determination of the wave drag for this family of airfoils for an extensive range of aspect ratio and sweepback angle for stream Mach numbers up to a value corresponding to that at which the Mach line coincides with the wing leading edge. The calculations showed that in general the wave-drag coefficient decreased with increasing sweepback" (p. 1).

"An investigation was conducted to compare the knock-limited performance of a 20-percent triptane blend in 28-K fuel with that of 28-R and 33-R fuels at high engine speeds, cruising speeds, and two compression ratios in an K-1830-94 multicylinder engine. Data were obtained with the standard compression ratio of 6.7 and with a compression ratio of 3.0. The three fuels were investigated at engine speeds of 1800, 2250, 2600, and 2800 rpm at high and low blower ratios" (p. 1).

Report presenting testing of a series of thin, triangular plan-form wings, including eight triangular wings of vertex angles and three swept-back wings with circular-arc sections. Results regarding lift, center of pressure, and ideal operation of different types of wings are provided.

From Summary: "The combustion performance, and particularly the phenomenon of altitude operational limits, was studied by operating the annular combustor of a turbojet engine over a range of conditions of air flow, inlet pressure, inlet temperature, and fuel flow. Information was obtained on the combustion efficiencies, the effect on combustion of inlet variables, the altitude operational limits with two different fuels, the pressure losses in the combustor, the temperature and velocity profiles at the combustor outlet, the extent of afterburning, the fuel-injection characteristics, and the condition of the combustor basket."

Report presenting part of the results obtained to determine the effects of compressibility at high Mach numbers on a model of the Bell XS-1 transonic research airplane. General trends that can be qualitatively analyzed for level-flight Mach numbers up to 0.93 are given. Results regarding force characteristics and a comparison of results with wing-flow investigation are also provided.

"The tests reported herein were made for the purpose of determining the high-speed load distribution on the wing of a 3/16 scale model of a scout-bomber airplane. Comparisons are made between the root bending-moment and section torsional-moment coefficients as obtained experimentally and derived analytically. The results show good correlation for the bending-moment coefficients but considerable disagreement for the torsional-moment coefficients" (p. 1).

Effect of inlet-air pressure and temperature on the performance of the X24-2 10-Stage Axial-Flow Compressor from the X24C-2 turbojet engine was evaluated. Speeds of 80, 89, and 100 percent of equivalent design speed with inlet-air pressures of 6 and 12 inches of mercury absolute and inlet-air temperaures of approximately 538 degrees, 459 degrees,and 419 degrees R ( 79 degrees, 0 degrees, and minus 40 degrees F). Results were compared with prior investigations.

"For about the past year, American Airlines has been engaged in obtaining data on various uses of airborne radar under routine operating conditions. This work is under contract to the Navy Department, Bureau of Ships, and includes the investigation of radar as a navigational aid and terrain collision warning device and its use in icing and turbulence detection. In view of the work of the National Advisory Committee for Aeronautics on atmospheric turbulence, the NACA was requested to participate in the tests to the extent of obtaining and evaluating the turbulence data for use in the turbulence-detection phase of the work" (p. 1).