A multi-purpose program for processing exponential data has been prepared for the 709 computer. The main purposes of the program is to compute the material buckling from raw data (given counts, time, and counter information) or from previously calculated Athermal's. It is also possible to compute only CeCh (end and harmonic corrections) for a given B11 or series if B11's no counting data being entered. In every case, pile measurements must be submitted as input for corrections.

The purpose of the test was to determine the internal temperature of the valve position detector for the 1A reactor inlet hydraulic valve with the plant at normal pressure and temperature and at power. The normal operating temperatures for the valve position detector on the 1A reactor inlet hydraulic valve range from a minimum of 287 F to a maximum of 294.7 F.

From abstract: Absolute cross sections for the production of charged secondary particles is the bombardments of aluminum, nickel, silver, and gold by 332-Mev protons, 187-deuterons, and 380-Mev alpha particles have been determined.

An addendum to report HW-30390 a additional power generation calculation for P, the rate of energy release, in kilowatts, was derived.

A preliminary design study, Phase I of the ALPR project, has been made in accordance with the Army Reactors Branch specifications for a nuclear "package" power plant with a 200-260-kw electric and 400 kw heating capacity. The plant is to be installed at the Idaho Reactor Testing Station as a prototype for remote arctic installations. The "conventional" power plant as well as the exterior reactor components are described in the accompanying report and cost estimate by Pioneer Service and Engineering Company, Architect-Engineers for the project."Nuclear" components of the reactor are designed by Argonne National Laboratory as described in the present report.

Abstract. Some recent analysis of certain Lid Tank fast neutron dose rates measured in oil and water indicates that there are some basic inconsistencies with reported oxygen and carbon removal cross sections and the reported data. These inconsistencies may be explained in several ways: (1) The reported carbon removal cross section is wrong. (2) The reported oil composition is wrong. (3) The reported oxygen removal cross section is wrong since it is based on an assumed rather than a measured oil composition. (4) Some of the experimental data are wrong. It is not possible to determine which of the above is most likely on the basis of analysis alone but the possibilities are pointed out and, based on the assumption that all the experimental data are correct, it appears most likely that the oil composition assumed in ORNL 2197 was in error.

Summary. The analysis of the motion of a six-bar linkage is difficult because of the large number of variables involved and the large number of calculations that have to be made for each position of the linkage. If a digital computer is used to make the calculations required for a multi-position analysis of a mechanism, it is feasible to design by analyzing a large numbers of similar linkages and selecting the optimum configuration. In this paper expressions have been derived for the output angle as a function of the input angle and the transmission angle as a function of the input angle for any single-degree-of-freedom six-bar linkage for which the parameters are known An example showing the usefulness of a six-bar computer program as a mechanism design tool is discussed.

Summary: A method was found for determining calcium concentrations in TBP process streams in spite of serious interferences bysodium, ferrous, uranyl, sulfate, phosphate, and sulfamate ions as well as by TBP. The precision attainable varied from sample to sample, depending upon its composition. In general, errors of 20% or greater occurred. The smallest determinable amount of calcium was about 10 mg/1.

Abstract. Methods of analysis for thorium, calcium, and nitric acid in solutions from thorium extraction purification columns are described and the results and errors are outlined. A brief description of methods of analysis that were not successful is included.

From introduction: The present report describes further refinements of the apparatus and the method to meet a need for a sensitive determination of carbon in plutonium.

From introduction: "This report presents the apparent viscosities of supernate-sludge slurries prepared synthetically to simulate the conditions known to exist in the waste storage tanks, but with fission products and plutonium absent."

Summary: The use of dimensionless-parameter frequency response diagrams to determine accuracies of lumped-parameter approximations is demonstrated by two examples: calculation of the heat flux at the surface of a semi-infinite solid due to temperature fluctuations of an adjacent fluid; and the response of a counterflow heat exchanger to inlet fluid temperature perturbations. Dimensionless system parameters make it possible to use general-purpose plots to find the error in particular approximations as a function of the frequency of perturbation. Such plots are directly applicable to control-system stability problems, where the highest frequency of interest is usually apparent.

A summary of the laboratory development program on aqueous uranium slurry fuels for the Homogenous Reactor Project during the period April 1951 through March 1953 is presented. These investigations were devoted primarily to a study of the uranium oxides in aqueous suspensions. It was concluded that U(VI) was most likely to be the stable valence state in such slurry fuels and it was shown that β-UO3·H2O platelet crystals were the stable modification at 250°C. Very pure slurries of β-UO3·H2O platelets, uranium concentration of 250g/liter and average particle size of about 10 μ, had favorable settling rates and could be easily redispersed. Their viscosity and corrosion rate in stainless steel were comparable with those in water. Exposure of these slurries to pile radiation disclosed that radiolytic hydrogen and oxygen gas pressure comparable in magnitude to those of uncatalyzed uranyl sulfate solutions could be expected. Fission products in the irradiated slurries were predominantly associated with the solids. Radiation also tended to promote caking of these solids on the walls of the radiation bombs. Uranyl phosphate and the magnesium uranates were briefly investigated as alternate system but were not found satisfactory. The program was discontinued before the feasibility of uranium slurries for reactor …

The following document describes some studies of the radioactive isotopes of cerium and lanthanum lying on the light or neutron-deficient side of stability.

Laboratory studies involving fluid flow through porous media require use of fluids having low dissolved gas content. Water is the major fluid used in various and box model and soil permeability studies carried out by the Geochemical and Geophysical Research group. Tap water supplied to the 222-U Bldg. contains a large amount of dissolved air. Under the reduced pressure encountered during model studies, the air is released from solution and gradually clogs the pores of the sand or other porous material. This, of course. leads to anomalous results and cannot be tolerated in precious studies. A system was required to effectively remove the air and make available a continuous supply of desired water for the model studies.

From introduction: "The fact that tetravalent uranium either in the form of solutions of its salts or, in some cases, in the dry state is readily oxidized by gaseous oxygen, has been observed by various investigators. A quantitative study of this reaction appeared to be desirable as a means of learning more about the nature of the ionic species present in uranous solutions. It was also of potential value in determining the importance of autoxidation as an undesirable side reaction involved in the handling of uranous solutions, and, if necessary, in developing procedures for minimizing the reaction."

Technical report abstract. The present state of knowledge concerning the effect of pile radiation on a variety of solid materials is reviewed. Radiation corrosion will not be a serious hazard for aluminum or stainless steel but it can be for iron or lead if either are exposed to water. Apart from corrosion the principal uncertainty is in regard to the Wigner effect on the behavior of metals. There is at present no ground for optimism regarding the behavior of tuballoy. The effect on aluminum or a bonding material while less severe must also be considered serious. The expectation in regard to graphite is that its behavior will not cause trouble during the first 100 days of operation although serious troubles will probably arise within two years of operation. Organic materials can be used safely only in regions of limited exposure.

"This bibliography is a list of references pertaining to factors affecting the motion of the artificial earth satellite. References are foreign and domestic literature."

Progress report of the Oak Ridge National Laboratory Biology Division providing updates on various projects, experiments, and other work. This report includes a summary of scholarly output from the division and departmental activities in cytology and genetics, mammalian genetics and development, microbial protection and recovery, mammalian recovery, pathology and physiology, general physiology, biochemistry, enzymology and photosynthesis, microbiology, plant biochemistry, and biophysics.

One-region buckling measurements that were made on a series of D/sub 2/O- moderated lattices of heavy uranium metal tubes in the Process Development Pile at Savannah River Laboratory are presented. The purposes of these measurements are to provide normalization points for lattice bucklings and to extend the study of natural uranium- D/sub 2/O systems. The dependence of buckiing on the moderator-to-fuel ratio is studied for two types of lattices.

The HRT leak detector system consists of four headers each of which are connected on one side to a common supply of pressurized water and on the other side by individual tubing to the ring grooves of approximately twenty flanges. There are two methods of detecting the loss of water that are particularly applicable to the HRT: (1) By the loss of pressure in a constant volume system; (2) By the measurement of flow from a constant pressure system. It was determined to investigate the second method which requires a flowmeter capable of measuring flows of .5 cc or less of water per hour. The experiment flowmeter constructed performed almost exactly as the design calculations predicted.

"Centrifugal-casting techniques were investigated as a method of producing hollow cylindrical extrusion billets of aluminum-35 w/o uranium. Among the variables evaluated were melt temperature, mold and pouring-spout configurations, mold speed, and method of pouring. With the equipment employed it was found that the best castings were produced stilizing a pouring temperature of 2400 F, a heavy-walled steel cylinder rotating between 700 to 900 rpm for the mold and bottom-pouring technique employing a retractable pouring spout. Sound, nonporous billets 26 in. long and 5 in. in diameter were produced with a yield after machining of over 75 per cent of the original charge. The major losses occurred in the pouring spout-and-cup assembly. This loss is relatively unaffected by the casting length; and, therefore, coatings of greater length than 26 in. should results in even greater recoveries.

New systems involving the exchange of boron between boron trifluoride and boron trifluoride addition compounds have been explored. These systems have large separation factors and potentially simple reflux mechanisms. A precise determination of this separation factor for the anisole-boron trifluoride system gave the value (see report). Boron exchange was found to occur between BF and BCl3. Several homogenous catalysts have been found which activate the hydrogen-water exchange, but none are adoptable to the production of deuterium because of the slow exchange rate. Platinum or platinum oxide may be usable as a heterogeneous catalyst with proper support or dispersion techniques. The high-pressure solubility of hydrogen in several amalgams was investigated in connection with a unique countercurrent exchange system. A proposed system involving isotopic exchange between lithium dipivaloylmethane in diethyl ether and lithium hydroxide in aqueous solution was shown to give little or no isotopic separation. Column studies of the carbonate system exchange reaction were concluded with a 40°C run. Slightly higher enrichment of N15 was obtained than at 30°C . The temperature dependence of all in this system was measured between 15 and 45°C. The factor increases with temperature, showing a tendency toward a maximum near 45°C. Isotopic exchange appears to …

Continued work on the adsorbability of metal complexes from concentrated LiCl solutions and LiCl-HCl mixtures on a strong-base anion-exchange resin further demonstrated the much higher adsorbability of these complexes from LiCl solutions than from HCl solutions. The effect is believed to be due to the formation of less strongly adsorbed undissociated chloro-complex acids in the case of the HCl solutions.