Report presenting the results of flight testing to determine the zero-lift drag of an NACA 65-009 airfoil at a specified aspect ratio. The results are compared to previous testing of unswept and swept-back arrangements. The swept-forward and swept-back airfoils were found to produce lower values of zero-drag lift than the unswept airfoil.

"A solution is presented for the coupled modes and frequencies of swept wings mounted on a fuselage. The energy method is used in conjunction with power series to obtain the characteristic equations for both symmetrical and asymmetrical vibration. A numerical example which is susceptible to exact solution is presented, and the results for the exact solution and the solution presented in this paper show excellent agreement" (p. 1).

Report presenting testing of a low-acceleration transonic flutter test vehicle to obtain flutter data on two similar sweptback wings which indicated that wing flutter was symmetrical in mode. Results regarding flight and flutter characteristics for the FR-1-B are provided.

"This report presents preliminary data obtained in the Langley supersonic sphere. The supersonic sphere is essentially a whirling mechanism enclosed in a steel shell which can be filled with either air or Freon gas. The test models for two-dimensional study are of propeller form having the same plan form and diameter but varying only in the airfoil shape and thickness ratio. Torque coefficients for the 16-006, 65-110, and the 15 percent thick ellipse models are presented, as well as pressure distributions on a circular-arc supersonic airfoil section having a maximum thickness of 10 percent chord at the 1/3-chord position" (p. 1).

Charts are presented that permit the estimation of F-3 and F-4 knock-limited performance ratings for certain ternary and quaternary fuel blends. Ratings for various ternary and quaternary blends estimated from these charts compare favorably with experimental F-3 and F-4 ratings. Because of the unusual behavior of some of the aromatic blends in the F-3 engine, the charts for aromatic-paraffinic blends are probably less accurate than the charts for purely paraffinic blends.

"This paper develops a new method for determining the buckling stresses of cylindrical shells under various loading conditions. In part I, the equation for the equilibrium of cylindrical shells introduced by Donnell in NACA report no. 479 to find the critical stresses of cylinders in torsion is applied to find critical stresses for cylinders with simply supported edges under other loading conditions. In part II, a modified form of Donnell's equation for the equilibrium of thin cylindrical shells is derived which is equivalent to Donnell's equation but has certain advantages in physical interpretation and in ease of solution, particularly in the case of shells having clamped edges" (p. 285).

Empirical design curves are presented for the critical stress of thin-wall cylinders loaded in axial compression. These curves are plotted in terms of the nondimensional parameters of small-deflection theory and are compared with theoretical curves derived for the buckling of cylinders with simply supported and clamped edges. An empirical equation is given for the buckling of cylinders having a length-radius ratio greater than about 0.75.

"The production-model 333-A-23 turbojet-engine compressor with a 17-blade impeller was operated at ambient and 0 F inlet temperatures and at inlet pressures of 14 and 5 inches mercury absolute for equivalent impeller speeds from 6000 to 12,750 rpm. The results of this investigation are compared with those of the 533-A-21 compressor. At the design equivalent speed of 11,750 rpm the maximum pressure ratio was 4.39" (p. 1).

Report discussing the cooling characteristics of a 14-cylinder double-row radial air-cooled engine in a four-engine airplane. The effects of charge-air flow, cooling-air pressure drop, and fuel-air ratio on the cooling characteristics were measured separately. The cooling equation, rear middle-barrel temperature, cooling-limited manifold pressure, and maximum cruising power versus temperature-limited power are described.

"A flight test of the Aero jet Engineering Corporation's 7KS-6000 T-27 Jato rocket motor was conducted at the Langley Pilotless Aircraft Research Station at Wallops Island, Va, to determine the flight performance characteristics of the motor. The flight test imposed an absolute longitudinal acceleration of 9.8 g upon the rocket motor at 2.8 seconds after launching. The total impulse developed by the motor was 43,400 pound-seconds, and the thrusting time was 7.58 seconds" (p. 1).

Report presenting an analytical investigation to determine primarily the reduction in cooling-air requirement and the increase in effective gas temperature for the same quantity of cooling air resulting from the use of an insert in the cooling-air passage of a hollow air-cooled turbine blade.

Based on results of longitudinal trim and tumble tests of a 0.057-scale model of the Chance Vought XF7U-1 airplane, the following conclusions regarding the trim and tumble characteristics of the airplane have been drawn: 1. The airplane will not trim at any unusual or uncontrolled angles of attack. 2. The airplane will not tumble with the center of gravity located forward of 24 percent of the mean aerodynamic chord. When the center of gravity is located at 24 percent of the mean aerodynamic chord and slats are extended and elevators are deflected full up, the airplane may tumble if given an external positive pitching moment.

"A summary has been made of available data on the characteristics of airfoil sections with trailing-edge high-lift devices. Data for plain, split, and slotted flaps are collected and analyzed. The effects of each of the variables involved in the design of the various types of flap are examined and, in cases where sufficient data are given, optimum configurations are deduced" (p. 1).

The effects of mass distribution on lateral stability and control characteristics of an airplane have been determined by flight tests of a model in the NACA free-flight tunnel. In the investigation, the rolling and yawing moments of inertia were increased from normal values to values up to five times normal. For each moment-of-inertia condition, combinations of dihedral and vertical-tail area representing a variety of airplane configurations were tested. The results of the flight tests of the model were correlated with calculated stability and control characteristics and, in general, good agreement was obtained.

From Summary: "Despite the development of relatively ice-free fuel-metering systems, the widespread use of alternate and heated-air intakes, and the use of alcohol for emergency de-icing, icing of aircraft-engine induction systems is a serious problem. Investigations have been made to study and to combat all phases of this icing problem. From these investigations, criterions for safe operation and for design of new induction systems have been established. The results were obtained from laboratory investigations of carburetor-supercharger combinations, wind-tunnel investigations of air scoops, multicylinder-engine studies, and flight investigations. Characteristics of three forms of ice, impact, throttling, and fuel evaporation were studied."

This paper contains a detailed description of a 2,000-horsepower propeller dynamometer used to make wind-tunnel tests of a two-blade NACA 10-(3)(08)-03 propeller for a range of blade angles from 20 degrees to 55 degrees at airspeeds up to 500 miles per hour. The results of these tests and comparisons with results obtained from a theoretical analysis and from previous tests made in other wind tunnels are presented.

"As part of an investigation to increase the power output of the V-1710-93 engine at altitude, the engine-stage supercharger was combined with a constant-area vaneless diffuser designed to improve the performance of the engine-stage supercharger at the rated engine operating point. The performance of the modified supercharger was investigated in a variable-component supercharger test rig and compared with that of the standard supercharger with an 8-vaned diffuser. A separate evaluation of the component efficiencies and a study of the flow characteristics of the modified supercharger was made possible by internal diffuser instrumentation" (p. 1).

"Abrupt, rudder-fixed aileron rolls have been made with the Bell X-1 airplane having a 10-percent-thick wing in glides to a Mach number of 0.82 at about 30,000 feet pressure altitude. Aileron movements were between one-fourth and one-half of full deflection. These aileron rolls indicate that Mach number has little effect on the aileron effectiveness up to a Mach number of 0.82" (p. 1).

Report presenting a simplified method for obtaining free-flight measurements of damping in roll through the use of rocket-powered models. Initial configurations have been tested for a range of Mach numbers. Results regarding the rolling velocity with two different airfoil sections and damping-in-roll coefficient are provided.

"Tests of a 1/20-scale dynamically similar model of the Northrop B-35 airplane were made to study its ditching characteristics. The model was ditched in calm water at the Langley tank no. 2 monorail. Various landing attitudes, speeds,and conditions of damage were simulated during the investigation. The ditching characteristics were determined by visual observation and from motion-picture records and time-history acceleration records" (p. 1).

Contains low-speed longitudinal stability characteristics of a 52 degree sweptback wing of aspect ratio 2.88, taper ratio 0.625, and NACA 64 (sub 1)-112 airfoil sections normal to the 0.282-chord line, in combination with split flaps, leading-edge flaps, and upper-surface fences. Low-wing and midwing-fuselage aerodynamic characteristics are presented with and without a horizontal tail at various vertical locations. Tests were conducted at a Reynolds number of 6.8 x 10(exp 6).

Report presenting an investigation of the effect of the rate of change of angle of attack on the maximum lift coefficient of a pursuit airplane equipped with a low-drag-type wing in stalls of varying abruptness over a range of Mach and Reynolds numbers. Maximum lift coefficients were found to increase linearly with increasing rate of change of angle of attack per chord length of travel up to the maximum rate attained in the tests.

Report discussing testing to determine the cooling effect of modified baffles and auxiliary-cooling ducts on the rear-row cylinders of a double-row radial engine. The modified baffles were found to reduce the temperatures of the exhaust-valve seats, but did not have an effect on the valve-guide temperatures. The auxiliary-cooling ducts reduced temperatures of the exhaust-valve seats and rear spark plug gaskets.

Report discussing testing of aromatic amines as antiknock additives, and more specifically the suitability of overwater storage for these fuel blends. 12 aromatic amines of three different concentrations at two temperatures were measured. The chemical properties of the most promising fuel blends are described in more detail and correlations were noted.