Report presenting an investigation at the Lewis laboratory to develop air-cooled, strut-supported turbine blades. Six blades were investigated in a full-scale turbojet engine to obtain data on blade durability and blade-cooling effectiveness and strut temperature. Results regarding the heat-transfer investigation and blade-durability investigation are provided.

Memorandum presenting an experimental study of the effects of several variations in configuration geometry on the aerodynamic characteristics of flat-top wing-body combinations. Generally, the configurations consist of one half of a body of revolution mounted beneath a wing of essentially arrow plan form. Results regarding the effect of trailing-edge sweep, effect of the addition of auxiliary bodies, effect of tip-flap deflection, effect of dihedral, effect of leading-edge sweep, effect of fuselage fineness ratio, effect of fuselage profile shape, and static longitudinal stability characteristics are provided.

From Summary: "This report presents the results of a wind-tunnel investigation conducted to determine the effects of Mach number on the aerodynamic characteristics of a wing of triangular plan form."

Report presenting an experimental investigation of the aerodynamic characteristics of a fin-stabilized body of revolution, designated as RM-10, in a supersonic wind tunnel. Pressure distributions and force characteristics were determined at two different Mach numbers. Results regarding pressure distributions, body-alone force tests, and body-tail combination force tests are provided.

From Introduction: "The purpose of this paper is to present and discuss skin temperature measurements from two flight tests. Temperature measurements were obtained to a Mach number of 5.4 on the first flight and to a Mach number of 10.4 on the second flight."

Report presenting an investigation of the aerodynamic loading characteristics of a wing-fuselage combination in the slotted test section of the transonic tunnel. The test was part of a systematic investigation of the effects of varying the amount of sweepback on wings in order to determine their suitability for transonic flight. Results regarding span load characteristics, normal-force characteristics, wing-tip angle of twist, spanwise distribution of section pitching-moment coefficient, pitching-moment characteristics, and fuselage characteristics in presence of wing are provided.

Report presenting an investigation to evaluate the effects of split flaps, elevons, sharp leading edges, drooped-nose flaps, and extended-nose flaps on the lift, drag, and pitching-moment characteristics at low speed of a wing-fuselage combination with a wing with the leading edge swept back 63 degrees and an aspect ratio of 3.5. Results regarding the plain wing and wing-fuselage combinations, Reynolds number, split flaps, elevons, leading-edge devices, and highest lift coefficient attained before longitudinal instability are provided.

From Introduction: "This report is concerned with the derivation of expressions for the velocity potential and associated forces and moments for oscillating triangular wings in supersonic flow. The purpose of the present report is to make use of the expanded form of the velocity potential to obtain the forces and moments, based on the first terms of this potential, for a rigid triangular wing performing vertical and pitching sinusoidal oscillations in mixed supersonic flow."

From Introduction: "The objective of this report are (1) to describe the complete fuel system, (2) to discuss the procedure used for transitions between JP-4 fuel and hydrogen, and (3) to present and discuss engine performance obtained with both fuels, and (4) to review the reliability of the fuel system."

From Introduction: "The effect of flame-holder and fuel-system design on the burner performance and the effect of altitude and flight Mach number on over-all performance with a fixed-area exhaust nozzle are reported in reference 1 to 4. Altitude performance characteristics of a tail-pipe burner having a converging conical burner section are presented in this report. Tail-pipe burner performance at several flight conditions is given in both tabular and graphical forms and compared with performance of the standard engine and of the tail-pipe burner reported in reference 2."

"An altitude-wind-tunnel investigation has been made to determine the performance of Hamilton Standard 6507A-2 four-blade and three-blade propellers on a YP-47M airplane at high blade loadings and high engine powers. Characteristics of the four-blase propeller were obtained for a range of power coefficients from 0.10 to 1.00 at free-stream Mach numbers of 0.20, 0.30, 0.40. Characteristics of the three-blade propeller were obtained for a range of power coefficients from 0.30 to 1.00 at a free-stream Mach number of 0.40" (p. 1).

Report presenting testing of a standard turbojet engine by water injection at the inlet of the axial-flow compressor in the altitude wind tunnel. Engine performance at 7600 rpm was obtained over a wide range of water-air-pressure ratios and ram-pressure ratios. Results regarding the engine-component performance are also provided.

From Introduction: "The purpose of the present study is to investigate these suggested methods for reducing the undesirable pitching and yawing motions of an airplane during roll maneuvers. The airplane characteristics used in this study were those of the F-100A airplane having the original small vertical tail as shown in figure 1."

Memorandum presenting an analysis to indicate the feasibility of the supercritical water compressor jet cycle for nuclear powered aircraft. Performance values of the cycle are given for a range of design-point engine operating conditions and subsonic flight conditions.

From Introduction: "The purpose of this report is to compare the effect on engine performance of the variable-area exhaust nozzle for axial- and centrifugal-flow turbojet engines."

From Introduction: "In the present report, the concept of velocity diffusion is applied in an analysis of blade losses expressed in terms of the fundamental parameter of wake momentum thickness. Restrictions and limitations involved in the application of the results to cascade performance analyses are discussed."

Memorandum presenting an aerodynamic design-point analysis of one-spool turbojet engines with one-stage turbines with one and with two rows of downstream stator blades. The object of the analysis was to evaluate the design characteristics of the turbines in comparison with conventional one- and two-stage turbines, to determine the extent to which exit whirl can be increased before causing weight-flow capacity to decrease, and to determine the effect of downstream stators on engine design limitations.

Report presenting measured pressure over airfoils at Mach number 1, with subsonic velocities at the nose and supersonic velocities throughout the rear portion, are analyzed by comparison with calculations for similar cases. Results regarding the theoretical basis of approximation, comparison of Prandtl-Meyer flow with measurements, comparison of linear-velocity extrapolation with measurements, and effect of boundary layer upon airfoil pressures are provided.

From Introduction: "The results of the aforementioned study are presented in this report together with the method of analysis employed. The net stability change is shown together with the individual contributions due to flexibility of wing, tail, and fuselage, both including and neglecting the effect of inertial loads."

From Introduction: "The present report gives an analysis of the design point performance of nuclear powered liquid-metal turbojet engines. The effect of varying the assumptions necessary to calculate gross weight and reactor heat release from engine data is presented."

Report presenting an analysis of the nuclear powered liquid-metal turbojet cycle for a wide range of engine operating conditions at a range of flight Mach numbers and altitudes. The method of analysis and working charts are presented to facilitate investigations beyond the scope of this report.

Report presenting an investigation of the influence of high-altitude supersonic flight on the operation and effectiveness of turbine-blade air- and liquid-cooling systems for turbojet application in guided missiles and supersonic interceptor aircraft. Results regarding the coolant passage heat-transfer-coefficients, nonrefrigerated air-cooling-system characteristics, and refrigerated-air-cooling-system characteristics are provided.

This report lists pertinent NACA papers presenting research results which have a direct bearing on control system design and performance for both piloted and automatically controlled aircraft. Limited reference is also made to NACA reports on aircraft engine controls and to research techniques and instrumentation pertinent to the study of control systems and aircraft dynamics in flight. Reports published between January 1949 and April 1954 are listed in chronological order and cross referenced.

Report presenting testing using a 1 7/8-inch inside-diameter combustor that can measure and compare the blow-out velocities of single-component fuels, slurries, and fuel mixtures with a wide range of reactivity and physical properties. The blow-out velocities of isooctane, n-heptane, isopentane, allyl chloride, and propylene oxide varied int he same way as flame speeds of the fuels. Results regarding the effects of different additives are also provided.