Report presenting an investigation of a fin-stabilized scale model of the NACA RM-10 missile at a Mach number of 1.62. Measurements were made of the lift, drag, and pitching moment of the finned body over a range of angles of attack. Comparisons with the results from other testing facilities are also provided.

Memorandum presenting an investigation to determine the energy transfer by thermal radiation from the flame of a single tubular turbojet-engine combustor to the combustor liner. The effects of variations in combustor inlet-air pressure, fuel-air ratio, and air mass flow on the transfer of radiant energy were studied.

Report presenting the application of an aerodynamically pulsed horizontal tail to determine experimentally the longitudinal aerodynamic characteristics of a rocket-powered model in free flight. Results regarding time history, lift and drag, and tail effectiveness and downwash are provided.

An experimental investigation of thermal radiation from the flame of a single tubular turbojet-engine combustor to the combustor liner is presented. The effects of combustor inlet-air pressure, air mass flow, and fuel-air ratio on the radiant intensity and the temperature and emissivity of the flame are reported. The total radiation of the "luminous" flames (containing incandescent soot particles) was much greater (4 to 21 times) than the "nonluminous" molecular radiation.

An investigation was conducted to determine the performance characteristics of a mixed-flow impeller which was designed with special emphasis on the reduction or elimination of flow decelerations along wetted surfaces. The performance was investigated over a range of equivalent impeller speeds from 700 to 1600 feet per second and over a range of flow rates from maximum adiabatic temperature-rise efficiency, measured at 1-1/2 impeller diameters in a vaneless diffuser, at the design speed of 1400 feet per second were 4.00 and 0.83, respectively.

Report presenting an attempt to improve the part-speed weight-flow-range characteristics of a typical inlet stage by two different approaches. Results regarding the effects of reduction in camber and effects of reduction in guide-vane turning are provided.

From Introduction: "The purpose of this report is to compare the effect on engine performance of the variable-area exhaust nozzle for axial- and centrifugal-flow turbojet engines."

Memorandum presenting analyses based on theoretical results of NACA Report 1041 to determine the plan forms of unbalanced trailing-edge flap-type controls with minimum hinge moments due to deflection and requiring minimum work to overcome the hinge moments due to deflection at supersonic speeds. Results of the analyses for longitudinal controls show high-aspect-ratio untapered controls to possess maximum ratios of lift to hinge moment. Results regarding ratios of lift to hinge moment, ratios of lift to deflection work, ratios of rolling moment to hinge moment, and ratios of rolling moment to deflection work are provided.

Report presenting rocket-propelled models flown at transonic and supersonic speeds to determine the effect on zero-lift drag of increasing the leading-edge bluntness of a sweptback wing. Results regarding the total drag coefficient, wing-plus-interference drag coefficients, and force-break Mach number are provided.

Memorandum presenting a comparison between the force data obtained on a wing in air and Freon-12 at a low supersonic Mach number as obtained from the pressure coefficients measured at three spanwise stations on a 45 degree sweptback wing. Results regarding pressure distributions and force and moment conversion factors are provided.

Report presenting an investigation of an axially symmetric spike-type nose inlet suitable for a nacelle power-plant installation in the 8- by 6-foot supersonic tunnel at a range of Mach numbers and angles of attack. The inlet was designed to attain a mass-flow ratio of unity a Mach number 2.0. Results regarding the performance of inlet A and inlet B, which differed based on subsonic diffuser area variation, are provided.

Report presenting an investigation of the aerodynamic loading characteristics of a wing-fuselage combination in the slotted test section of the transonic tunnel. The test was part of a systematic investigation of the effects of varying the amount of sweepback on wings in order to determine their suitability for transonic flight. Results regarding span load characteristics, normal-force characteristics, wing-tip angle of twist, spanwise distribution of section pitching-moment coefficient, pitching-moment characteristics, and fuselage characteristics in presence of wing are provided.

Memorandum listing NACA reports related to a variety of research topics, including instruments, research equipment, and research techniques.

Report presenting an investigation of whether or not a two-stage turbine with the frontal area no larger than the compressor frontal area could be satisfactorily designed to drive a particular compressor under take-off conditions. The low blade-tip speed, high work, and high air flow per unit of frontal area of the compressor make it critical that a two-stage turbine is designed to drive it. Results regarding the effect of work division, effect of variation in cone angle, and effects of radial variations on velocity diagrams are provided.

From Summary: "Pressure distributions around circular cylinders placed perpendicular to the stream for subsonic and supersonic flow conditions have been obtained. Drag coefficients calculated from these wind-tunnel tests and from transonic free-flight tests are presented. Drag data are presented for the Mach number range of 0.3 to 2.9."

Memorandum presenting results obtained from time-history records of normal accelerations, airspeed, and altitude. Additional data have been obtained from the operations of two types of commercial transport airplanes together with data on two other types of transport airplanes.

Report presenting the design of a mixed-flow impeller with special emphasis on the reduction or elimination of velocity deceleration along the wetted surfaces, especially the blade suction surface. With the use of a provisional hub-shroud profile, the blade shape at the blade mean height was determined from a prescribed velocity distribution.

Report presenting an investigation to determine the directional characteristics of a sharp-nosed fuselage through a large angle-of-attack range at zero angle of sideslip. The fuselage was found to experience a large increase in yawing moment as the angle of attack increases. The results also indicated that a ring or other roughness used on the nose caused a large decrease in the yawing moment obtained at high angles of attack.

Report presenting an investigation in the 8-foot transonic tunnel to determine the effects of twist and camber on the aerodynamic characteristics of a sweptback wing-fuselage configuration. The wing had 45 degrees sweepback of the 0.25 chord, an aspect ratio of 4, a taper ratio of 0.6, and NACA 65A-series airfoil sections with 6-percent thickness distribution parallel to the plane of symmetry. Results regarding the lift characteristics, drag characteristics, and pitching-moment characteristics are provided.

Report presenting an investigation in the 300 mph tunnel to determine the applicability of spoilers as lateral-control devices on thin delta wings. The wing used in testing had a thickness ratio of 1.5 percent at the root and a maximum ratio of 4.5 percent at 66.7 percent wing semispan, 60 degree sweepback at the leading edge, 0 degree sweep of the trailing edge, an aspect ratio of 2.31, and a taper ratio of 0. Results regarding the effect of spoiler location and angular placement, effect of spanwise location, effect of spoiler projection, and effect of slots and perforations are presented.

From Summary: "The aeroelastic effects on wing-aileron rolling effectiveness and drag of thin flat-plate delta wings with 45 degree swept leading edge and plain constant-chord ailerons have been investigated. This investigation has been carried out over a Mach number range of 0.7 to 1.6 by means of rocket-propelled test vehicles in free flight. The results show a near-linear decrease in lateral control effectiveness with a decrease in the wing torsional stiffness. An aileron-effectiveness reversal was experienced with the more flexible delta-wing models."