This report follows investigations of methods for sealing the ends of stainless steel-uranium oxide fuel pins with the objective to develop an end-capping method that would give consistently good-quality closures in production.

This report follows a study that was aimed at the collection of experimental data needed to estimate the maximum safe temperatures and dispersed UO2 contents for MoSi2--UO2 fuel elements exposed to air.

The following report summarizes the results of the laboratory-scale work and pilot-plant scale work of a salt-batch composition that reduces the hydrogen pickup by uranium rods during the beta heat treatment, and the study of the influence of humidity over the salt bath on hydrogen pickup.

Abstract: "In a study of the preparation and properties of delta-phase zirconium hydride it was found that large, sound bodies of the hydride can be prepared by direct combination of the elements if the rate of the reaction is retarded by limiting the supply of available hydrogen. Specimens up to 1-in. diameter were prepared using this technique. Because delta phase zirconium hydride does not readily form eutectics with iron-and nickel-base alloys below 1800 F these materials may be utilized for clodding the hydride. Delta-phase zirconium hydride is unaffected by exposure to liquid NaK or to nitrogen gas at temperatures below 1000 F. The hot hardness of delta-phase zirconium hydrid is about 130 kg per mm-2 at room temperature and 40 kg per mm-2 at 1500 F. The mean coefficient of thermal expansion (68 to 1337 F) is 6.5 x 10^-6 per deg F. The thermal conductivity varies from 5.7 Btu/(ft)(hr)(F) at 300 F to 5.1 Btu/(ft)(hr)(F) at 1300 F."

From introduction: "This report deals with a part of the research and development studies which preceded the manufacture of fuel elements for the Gas Cooled Reactor Experiment (GCRE)." The studies evaluate the effects of varying the type and size of UO2 particles, stainless steel matrix powders, blending procedures, compacting pressures, sintering times, temperatures and atmospheres, roll-cladding temperatures and reduction rates, total cold reduction, and heat-treating times and temperatures has been made for UO2 stainless steel dispersion fuel elements."

The following report follows the procedures to compact blends of uranium tetrafluoride and magnesium, describing how lubrication of the compact effects the outcome of the blends.

The following report follows an experimental study that was made on the mass transport of chromium in polythermal inconel-fluoride fuel systems, followed by the technique of adding radioactive chromium-51 to the system as either CrF3 in the salt or as elemental chromium in the solid phase.