Abstract: "Diameter measurements of 25 slugs taken before and after a prolonged heat treatment showed no evidence of differences that would indicate blistering. The average effects of the treatment was different for the various slugs. Large differences in diameter measurements between slugs. Large differences in diameter between slugs and significant differences between indices and positions were found."

Abstract: "Following nitrate removal by means of a three-stage hydrochloric acid digestion, uranium was reduced with chromous sulfate reagent. In an inert atmosphere, the quadrivalent uranium was titrated at 80-95[degrees] with standard ferric sulfate solution. The end point was obtained with a potentiometric cell including a platinum in-titrant reference electrode and a platinum indicator electrode. Application was made to various low leverl uranium solutions. For samples containing 1 - 12 milligrams or uranium, less than one percent error may be expected. Iron and chromium do not interfere."

Abstract: "A new method of determining 8-hydroxyquinoline by titration with electrolytucally-generated bromine has been developed. Results show good precision in the range 0.4 mg. to 1.6 mg. total 8-hydroxyquinoline, with 99% confidence limits of less than +/- 2%. An electronically-regulated constant current source, required by the method, is described. A new indicator system with high sensitivity to free bromine is discussed."

Abstract: "Small amounts of acetic acid, equivalent to 400 ul. of 0.3 to 0.13 g/L. can be titrated coulonatrically in the presence of a 10 to 25-fold excess of HN03 in 70%, isopropanol. An accuracy of +/- 0.1% and a precision of +/- 8.5% (99% limite) are obtained.

The purpose of the test used to make this report was to determine if anodizing could become a part of the canning operation prior to autoclaving, other factors permitting, or if it must follow autoclaving.

Abstract: "The valve-actuated pulse column is employed to give phase separation on each half cycle in the countercurrent flow cycle and provides independent control over each step in the cycle. The dependence on temperature of operation, on pulse frequency and amplitude, and on plate design and spacing has been studied for extraction and stripping of uranium with tributyl phosphate in a hydrocarbon diluent. It is found that the efficiency increases quite significantly as the temperature is raised regardless of the direction of transfer and this increased efficiency is accompanied by greater operational freedom. A decrease in hole size, decrease in plate separation and increase in frequency all lead to higher efficiency in agreement with the concept that small drops continually formed coalesced and reformed, lead to maximum interphase transfer. The high extraction efficiency of the column is probably aided further by the relatively sharp pulse produced."

Abstract: "A method has been devised and successfully used for marking a leaking pile process tube prior to its removal from the pile, such that subsequent location of the leak is more easily accomplished. An acetone solution of Testor's Dark Red Airplane Dope is poured into the suspect tube. The solution leaks from the hole and stains the surrounding area a light pink. To date the method has been used on tubes 3573F, 0486F, 0867F, and 3670F."

The preceding report follows an extensive study made at Hanford of methods and equipment to remove effectively the dissolver vent gases.

At the request of the Hanford Operations Office of the Atomic Energy Commission, a criticality instrumentation meeting was held at Hanford on August 17 and 18, 1959. The purposes of the meeting were: (a) to review types of criticality control and/or alarm instrumentation at each site, their problems, shortcomings and potential obsolescence; (b) to discuss instrumentation in the area if approaching criticality; and (c) to consider for material balance purposes, the feasibility of devising instruments to detect the buildup of plutonium and enriched uranium bearing residues in process systems.

When an aqueous solution containing dissolved irradiated uranium and nitric acid is equilibrated with 30% tributylphosphate solution in kerosene, the distribution co-efficients for sirconium and niobium are decreased by the addition of phosphoric acid to the system.

An analytical method for Cu-64 in reactor effluent has been studied based upon electrodeposition of the active copper with inert copper carrier. A two hour plating time was employed at a current density of 10 ma/sq cm and four volts across the cell. A stainless steel cathode plate was used. Carrier yields of greater than 80% were obtained with a standard deviation of the yield-corrected counting rate as low as 0.24%. Very little, if any contamination by other radioactive elements present was shown by decay curve studies. Self-absorption and self-scatter factors to correct the counting rate were obtained.

The purpose of the short duration corrosion test was to obtain preliminary data regarding the corrosion resistance of the spring steel wire in Purex process waste solutions and to measure any changes in the tensile properties of the wire resulting from this exposure.

The results of this investigation indicate that maximum electric power generation can be obtained by selecting the turbine steam temperature within a range of plus/minus 30 degrees C. from an "idealized" steam temperature. This "idealized" steam temperature is shown to depend primarily on the maximum permissible uranium temperature. The minimum available condenser temperature and the temperature rise of the coolant in the pile effect the selection of the turbine steam temperature to lesser extent.

Report documenting experience gained by operating the spare PRTR Primary Process Pump. This includes descriptions of equipment used, testing procedures, and operating history.

From introduction: "Five appendices, each of which pertains to a separate phase of the Filtration of Radioactive Aerosols by Glass Fibers program."

The recovery of plutonium and neptunium by anion exchange has been well demonstrated on a laboratory scale. (1, 2,3,4) The specific adsorbed by the resin is the tetravalent hexanitrate complex of either element. With plutonium (IV) and neptunium(V) in IWW, the plutonium is adsorbed but the neptunium is not. If nitrite is used as the reductant in strong (preferably 8 M or over) nitric acid, both plutonium and neptunium are obtained in the tetravalent state, and both are adsorbed on the resin. With stronger reductants, such as semi carbazide or ferrous sulfamate, plutonium (III) and neptunium (IV) are obtained so that only the neptunium is adsorbed. Optimum recovery of either element is obtained with between seven and eight M nitric acid.

Zircaloy-2 has a strong tendency to absorb oxygen and nitrogen at elevated temperatures. These gas impurities are extremely harmful, causing brittleness and loss of corrosion resistance. The production of ductile corrosion-resistant welds by present methods required shielding of the weld metal by an inert gas atmosphere or by a vacuum. The alternative to an inert gas atmosphere or a vacuum is reduction of the welding time to a few milliseconds of time to prevent gas absorption.

Two types of enclosed hot junction arrangements are possible with sheathed mineral insulated thermocouples. They are the integral junction and he isolated junction. The integral junction is formed by welding, soldering, brazing or forging the two wires into the end of the sheath. The process forms a good thermal and electrical contact between the three materials.