Report presenting a combustion-efficiency investigation of 10 special straight-run distillate fuels in an individual tubular-type combustor unit of a 14-unit assembly at two simulated engine operating conditions. These distillates were obtained from various crude oils and consisted of hydrocarbon mixtures with distillations temperature varying from 93 to 690 degrees Fahrenheit. Comparison of temperature measurements obtained from two locations in the exhaust duct showed that under certain operating conditions the flame extended beyond the turbine position.

"An experimental investigation was made of a preloaded spring-tab flutter model to determine the effects on flutter speed of aspect ratio, tab frequency, and preloaded spring constant. The rudder was mass-balanced, and the flutter mode studied was essentially one of three degrees of freedom (fin bending coupled with rudder and tab oscillations). Inasmuch as the spring was preloaded, the tab-spring system was a nonlinear one" (p. 1).

Report presenting an evaluation of a piston-type gas-generator engine by comparing the performance of a transport airplane powered with than engine with the same airplane powered by different engines. The engines compared were a turbojet engine, a turbine-propeller engine, a compound engine, and a turbosupercharged reciprocating engine utilizing a variable-area exhaust jet nozzle. Results regarding optimum altitude and transport performance are provided.

Report presenting an experimental and analytical investigation of the flutter of uniform sweptback cantilever wings. The experiments used groups of wings sweptback by rotating and by shearing with angles of sweep ranging from 0 to 60 degrees. Results regarding the experimental investigation and a discussion and comparison of the analytical and experimental results are provided.

Report presenting an investigation of the experimental performance of chlorine triflouride and hydrazine measured over a range of propellant mixtures in a 100-pound-thrust rocket engine. Experimental values of specific impulse, volume specific impulse, heat rejection per propellant weight, nozzle thrust coefficient, and characteristic velocity were obtained as functions of percent fuel by weight in the propellant mixture.

Memorandum presenting a calculation of the amount of possible correction for coordinated turns with limited bank angle and level sideslips for a large transport airplane, the C-54D. The results indicate that for all instances from the end of the runway, coordinated turns are the more effective maneuver.

Report presenting surveys of the flow of the asymmetric adjustable nozzle of the 6- by 6-foot supersonic wind tunnel, which were made to determine the uniformity of the air stream. Test techniques for minimizing the effects of stream irregularities and the results of force and pressure-distribution tests of a swept-wing model are presented to illustrate the effectiveness of these techniques.

Report presenting an analysis to determine the applicability of existing propeller theory and the theory of oscillating airfoils to the problem of determining the magnitude of the forces on propellers in pitch or yaw. The steady-state method for calculating propeller forces appears to give satisfactory results.

Memorandum presenting an investigation of the change in spanwise load distribution at high Mach numbers, which is of considerable interest because lateral movement of the center of lift affects the trim, stability, and structural factors of safety of an airplane. The data is not sufficient to permit isolation of the effects of changes in wing configuration, but in a majority of cases, the tests reveal a tendency for the center of lift to shift outboard with increasing Mach number.

Report presenting the results of pitching-moment, lift, and drag measurements on a model of the D-558-1 with speed reduction brakes and a symmetrical profile wing at a range of Mach numbers. Only a small decrement in Mach number is produced with no nose-inlet flow and the speed-reduction brakes deflected.

The results of power-off force tests and flight tests of a model with a thin unswept low-aspect-ratio wing are presented. The tests were made with the flaps retracted and deflected. The effects on the lateral flight characteristics of decreasing directional stability were noted.

Report presenting wind-tunnel testing to determine the independent effects of Mach and Reynolds numbers on the aerodynamic characteristics of a wing-fuselage combination with a wing with the leading edge swept back 63 degrees and with camber and twist. Results regarding the fuselage alone and the effects of camber and twist are also provided.

Report presenting an investigation of the effects of various mass, aerodynamic, and dimensional parameters on the dynamic lateral stability of the Douglas D-558-2 airplane. Results regarding an airplane with the flaps and gear retracted, airplane at sea level with flaps deflected 50 degrees and landing gear lowered, and effect of assumed modifications to airplane are provided.

Report presenting tests to determine the recovery of total pressure attainable at a range of Mach numbers, which were performed with models with twin-scoop inlets situated on the sides of a long forebody. Results regarding ducts without slots and ducts with slots are provided.

Investigation conducted in the altitude wind tunnel to study the effect of Reynolds number on the performance of an axial-flow compressor. The compressor was operated as a part of a turbojet engine over a range of pressure altitudes and compressor-inlet Reynolds numbers. Results regarding compressor efficiency, air flow, and a comparison with axial-flow compressors of different design are provided.

Memorandum presenting a study to determine the possible blending agents or additives that may be used to supplement current high performance number, rich rating components in future aviation fuels. The study indicated that such high rich rating blending agents as toluene and xylene cannot be made available in sufficient quantities to maintain the rich rating performance of the fuels when reducing the lead content from 4.6 to 3.0 ml per gallon.

From Introduction: "Thrust augmentation of an axial-flow-type turbojet engine by burning fuel in the tail pipe is discussed in references 1 to 3. Thrust augmentation of the same turbojet engine by water injection at the compressor inlet is reported in reference 4."

Report presenting an investigation of the operation of two submerged-type inlets in a wind tunnel at subsonic and transonic speeds. The pressure recovery was relatively constant throughout the lower subsonic speed range. The ability of the divergent-walled inlet to operate with satisfactory pressure recovery at higher free-stream Mach numbers than was possible with the parallel-walled inlet is attributed to the difference in the boundary-layer characteristics of the two types of inlets.

"The factors that affect the rate of change of rolling moment with yaw of a typical fighter-type airplane were investigated in the Langley full-scale tunnel on a typical fighter-type airplane. Eight representative flight conditions were investigated in detail. The separate effects of propeller operation, of the wing-fuselage combination, and of the vertical tail to the effective dihedral of the airplane in each condition were determined. The results of the tests showed that for the airplane with the propeller removed, the wing-fuselage combination had positive dihedral effect which increased considerably with increasing angle of attack for all conditions" (p. 1).

"Low-speed wind-tunnel tests of a l/8 scale model of the Republic XP-91 airplane were made to determine its low-speed characteristics and the relative merits of a vee and a conventional tail on the model. The results of the tests showed that for the same amount of longitudinal and directional stability the conventional tail gave less roll due to sideslip than did the vee tail. The directional stability of the model was considered inadequate for both the vee and conventional tails; however, increasing the area and aspect ratio of the conventional vertical tail provided adequate directional stability" (p. 1).

"Preliminary tests have been made of a small burner to meet the requirements for application to supersonic ram jets. The principal requirements were taken as: (1) efficient combustion in a high-velocity air stream, (2) utilization for combustion of only a small fraction of the air passing through the unit, (3) low resistance to air flow, (4) simple construction, and (5) light weight. Tests of a small burner were carried to stream velocities of nearly 150 feet per second and fuel rates such that one-eighth to one-fourth of the total air was involved in combustion" (p. 1).

An investigation of the pressure distribution on the fuselage nose and the pilot canopy of a supersonic airplane model has been conducted at a Mach number of 1.90 over a wide range of angles of attack and yaw. Boundary layer separation apparently occurred from the upper surface at angles of attack above 24 degrees and from the lower surface at minus 15 degrees. No separation from the sides of the fuselage was evident at yaw angles up to 12 degrees.

The preignition characteristics of the R-2800 cylinder, as effected by fuel consumption, engine operating variables, and spark plug type and condition, were evaluated. The effects on preignition-limited performance of various percentages of aromatics (benzene, toluene, cumene, xylene) in a base fuel of triptane were investigated. Two paraffins (triptane and S + 6.0 ml TEL/gal) and two refinery blends (28-R and 33-R) were preignition rated. The effect of changes in the following engine operating variables on preignition limit was determined: inlet-air temperature, rear spark plug gasket temperature, engine speed, spark advance, tappet clearance, and oil consumption. Preignition limits of the R-2800 cylinder using Champion C34S and C35S and AC-LS86, LS87, and LS88 spark plugs were established and the effect of spark plug deterioration was investigated.

The performance at inlet pressure of 21 inches mercury absolute and inlet temperature of 538 R for the 10-stage axial-flow X24C-2 compressor from the X24C-2 turbojet engine was investigated. the peak adiabatic temperature-rise efficiency for a given speed generally occurred at values of pressure coefficient fairly close to 0.35.For this compressor, the efficiency data at various speeds could be correlated on two converging curves by the use of a polytropic loss factor derived.