This paper contains tail and hull loads data obtained in an investigation of a l/15-scale model of the Goodyear XZP5K airship. Data are presented in the form of tabulated pressure coefficients over a pitch and yaw range of +/-20 deg and 0 deg to 30 deg respectively, with various rudder and elevator deflections. Two tail configurations of different plan forms were tested on the model. The investigation was conducted in the Langley full-scale tunnel at a Reynolds number of approximately 16.5 x 10(exp 6) based on hull length, which corresponds to a Mach number of about 0.12.

Report presenting an analysis to determine the applicability of existing propeller theory and the theory of oscillating airfoils to the problem of determining the magnitude of the forces on propellers in pitch or yaw. The steady-state method for calculating propeller forces appears to give satisfactory results.

Report presenting an investigation to determine the static longitudinal and lateral stability characteristics of an airplane configuration with a trapezoidal wing with modified hexagonal airfoil section and a cruciform tail with 5 degree semiangle wedge section. Data were obtained at a range of angles of attack and sideslip.

Engine dynamics were investigated for supercritical operation of the ram jet at Mach 2.75 over a range of simulated altitudes from 68,000 to 82,000 feet. Indicial-and frequency-response tests were conducted with fuel flow as the input variable. For a wide range of operating points, the response of static or total pressure to fuel flow consisted of a dead time followed by a response form that generally approximated a linear, first-order, lead-lag. The dead time varied significantly only with distance from the combustion zone. The rise ratio and the time constant of the lead-lag function were nearly independent of the pressure sensed.

Report presenting an investigation to determine the spin, recovery, and longitudinal-trim characteristics of a 60 degree delta-wing model through an extensive range of mass loadings. Variations in the relative density, center-of-gravity position, and inertia parameters were included in testing. Results regarding the single-vertical-tail and multiple-vertical-tail configurations are provided.

The stator-blade angles in the first four stages of a 16-stage axial-flow compressor were increased in order to decrease the angles of attack of these stages, and thereby to improve part-speed performance. The performance of this modified compressor was compared with that of the same compressor with original blade angles.

Report presenting an investigation of a rocket-propelled model of the Douglas X-3 airplane in order to determine the lateral stability characteristics at zero angle of attack and to evaluate test and analysis technique. Results regarding time histories, lateral trim characteristics, general characteristics of lateral oscillation, and lateral stability derivatives are provided.

Memorandum presenting a mechanism for the thermal decomposition of sodium, lithium, beryllium, magnesium, aluminum, and boron alkyls and for the reverse reaction, the addition of olefins to metal hydrides. The reactions are shown to be nonradical and to probably proceed through a cyclic intermediate.

Report presenting an investigation in the free-spinning tunnel to study the behavior in descent of hemispherical and quasi-conical parachutes, some with symmetrical canopy modifications and all with a right circular cylinder suspended by one end below the parachute. Results indicated that a lateral flight component during descent could be obtained by using a circular cutout in the side of the canopy of a hemispherical parachute and a large slit between two panels of a quasi-conical parachute.

Report presenting an investigation of several wing-body combinations with wings suitable for supersonic interceptor-type aircraft at high Reynolds numbers and low Mach numbers. Nine wing-body combinations were tested with three different wing aspect ratios and three different plan forms. Results regarding the lift, drag, and pitching moment are provided.

Report presenting comparative drag and pressure recovery for an NACA submerged inlet and two side-wall modifications. One afterbody and diffuser were used for all tests and testing was conducted over a range of Mach numbers. The two modified inlets were found to be superior to the standard inlet from the standpoint of pressure recovery.

Memorandum presenting a study of the effect of oxide-depositing fuels on engine starting, operation, and performance by using a modified production turbojet engine operated using a trimethyl borate azeotrope as a fuel. Results regarding boric oxide deposition, engine operation and performance, effect of turbine-inlet temperature, and dissipation of boric oxide deposits are provided.

Report presenting testing of a modified production turbojet engine using a trimethyl borate azeotrope as a fuel. Operation with this fuel for 100 minutes produced a 2-percent deterioration in engine speed and only a 1-percent increase in combustor total-pressure loss with the best engine configuration investigated. Results regarding boric oxide deposition, engine operation and performance, effect of turbine-inlet temperature, and dissipation of boric oxide deposits are provided.