Equilibrium krypton and xenon adsorption isotherms were obtained for four varieties of charcoal and for Linde Molecular Sieves Types 4A and 5A, generally at 0, 25, and 60°c. Such data are of interest in connection with design and evaluation of adsorbers for radioactive noble gas fission products. The isotherms were fitted, by linear regression analysis, to straight-line forms of the Freundlich and Langmuir equations. The Freundlich linear equation gave the better fit and the parameters of this equation are presented for each of the isotherms. Also presented are the constants for an equation representing the temperature dependence of arbitrary adsorption coefficients, the coefficients having been calculated from the Freundlich isotherm parameters. Some aspects of the applicability and accuracy of these results are discussed.

A short-term study was made to investigate the removal of radioiodine vapor from air-steam mixtures as could occur immediately following a nuclear incident in a pressurized water reactor. Activated charcoal traps, designed to simulate a small section of a commercial charcoal canister, were tested at gas velocities of 23.9 to 74.9 ft/min over the temperature range of 75 to 118°C. The iodine removal efficiency was found to range from 99.80 to 99.4% with an average of 99.9%. One test performed at a temperature of 105°C and with gas velocity of 290 ft/min indicated that the iodine removal efficiency was reduced to 99.54%. Activated charcoal exhibits a high efficiency for iodine vapor removal under these test conditions and appears suitable for application in the decontamination of air-steam mixtures.

The designer's concept of a test program for the 30-Mw prototype intermediate heat exchanger and steam generator designed and fabricated as part of the Sodium Components Development Program is presented. The performance data will serve to verify the thermal design, or allow application of improved techniques to future designs, give an improved basis for stress analysis in design of future units, and demonstrate the capability and limitations of the units in relation to the performance specifications for which they were designed. Welding techniques for type 316 stainless steel are described. The specifications and operating conditions of the units are given along with instrumentation drawings showing test equipment design and arrangement.

This report describes the work carried out in 321 Building semiworks equipment, to define the factors contributing to high corrosion-product contamination and presents recommendations for reducing the impurity level to meet current specifications (maximum of 200 parts total metals per million parts U).

Abstract: The reactor kinetics equations are combined into a single integral equation whose kernel describes the time-dependent characteristics of the reactor including six delayed groups of neutrons. Numerical solutions of the integral equation are given for constant, linear, and ∫sin²kx dx reactivities. An approximate solution of the integral equation is obtained which provides a basis for the formulation and solution of the reactor system control problem using the methods of servomechanisms theory. The reactor frequency response function, a product of the approximate solution, is calculated and plot given.

The thermal decomposition of the higher oxides of praseodymium and americium have been investigated.

The writer has initiated a comprehensive program of equipment development designed to give the maximum practical aid to the physicists and technicians who are carrying out track measurements. Some attention has also been given to developing systems of data handling using International Business Machine (IBM) equipment and Keysort cards. In addition, some of the steps to insure the accuracy of the emulsion data are taken long before the emulsion is studied under the microscope.

The following report measures a shield mockup in three regions: the first made almost entire of iron; the second, transition, region is made of various thicknesses of B4C; and the third region was borated water. The iron samples used in the experiments were made in the form of rectangular plates and place in the lid tank; however, the plates were not completely flat and created a water gap that was measured in this report.

The following report discusses the renewed element 43, or eka-manganese, whose discovery was heralded in 1925, but whose chemical properties remained unreported until the radiochemical investigations of Perrier and Segre."

A two-group approximation of the fission ratios and Pu production in an infinite hollow matrix is developed

"Abstract: Data on analog magnetic tape characteristics are presented along with results from conventional and modulator playback system operational tests. Theoretical considerations imply that the modulator head should be loss sensitive to short term variations in record and playback tape speed. It is also pointed out that although a tape recorder operating at 7.5 in./sec has only 12 kcs bandwidth for sinusoidal wave forms. the record and play-back amplifiers for pulse recording can operate with other bandwidths. These amplifiers must be capable of passing a square wave with a frequency of 1.5 kcs. A square wave of such frequency represents the condition of 350 microsecond pulses with a 700 microsecond period. (J.R.D)."

Introduction: "In the early operation of the WTR severe canal corrosion of dummy fuel assemblies and a beryllium A-piece caused a great deal of concern as to the possible effects of long-time canal storage on such elements. A short-term experimental program was started to determine the causes of this corrosion and to correct them before any irradiated fuel elements had to be stored in the canal. The results of this program are presented here."

With discussion under way concerning power production by chain reacting piles, it becomes pertinent to consider the ration of the temperature of the hottest spot in the pile to the average exit temperature of the cooling stream. This is important because the temperature of the hottest spot in the pile is one of the limiting factors in determining the maximum power at which a pile can be operated. However, the higher the temperature of the emerging cooling stream, the more efficient can be the thermal engine operated by it. Thus the ideal situation is to have the average exit temperature of the cooling stream as near as possible to the hottest temperature of the hottest spot in the pile.

Conclusions from the study: "Radioactive dusts are carcinogenic, and can cause cancer of the lung. complete dose response curves have not yet been determined. All the parameters that render this demonstrably toxic material (radioactive dust) have not yet been evaluated. It is strongly suggested by the experimental data that duration of radiological insult to the lung is an important factor in eliciting lung cancer. The atmospheric tolerance concentrations now in use seem to afford little margin of safety."

The following report proposes a concept of a transient version of Astron thermonuclear reactor while describing the basic concepts of the reactor and the design criteria.

An additive, interacting mechanism of micro and macro-convective heat transfer is proposed to represent boiling heat transfer with net vapor generation to saturated liquid metals in convective flow. Based on this mechanism, a method for calculating boiling coefficients is developed. The correlating is shown to be in fair agreement with early experimental results for convective boiling of potassium and sodium.

The following report describes a thermonuclear reactor based on the use of a long layer of rotating relativistic electrons to confine and heat the plasma.

The following report provides data based off of the solubility of sodium uranyl acetate that was measured under a variety if conditions.

The nuclear safety portion of this report is inclined to ignore the factors by which safety limits can be increased. It makes no mention of the control that can be exercised by limiting the assay of the U-235 being processed in the plant. From some of the previous reports, it is apparent that this plant is not anticipating processing U-235 of assay greater than approximately 20%. At this value, many of the numbers that are presented in the tables could be increased markedly. Rough examination indicates that these values all refer to top product U-235. The general discussion is, however, excellent. The references apparently used are those unclassified references with which we are all familiar and think highly of. We would recommend the inclusion of TID-7016.

Recently, we reported that the administration of the thyroid hormone, L-triiodothyronine (T3), markedly accelerated the development of experimental hypertension associated with a high-salt intake in intact rate. Earlier, Selye and his associates and Masson, Corcoran, and Page has observed a similar effect from thyroxin in uninephrectomized salt-fed rats. We were aware of the fact that oxidative phosphorylation is uncoupled by the thyroid hormone and were intrigued by the possibility that such uncoupling was instrumental in the accelerated development of the hypertension observed. The work reported here was undertaken with this possibility in mind; it was based on the well documented observation of Loomis and Lipmann that dinitrophenol reversibly inhabits oxidative phosphorylation. The present studies indicates that 2, 4-dinitrophenol, like L-triiodothyronine, can also rapidly induce hypertension in salt-fed rate. These observations have led us to develop a working hypothesis that may have general implications relative to the pathogenesis of hypertension in man.

Report discussing the application of some previously established methods to yield a calculation of the pressure and internal energy functions of a system of point charges interacting only with Coulomb forces.

Though only recently established, this concept has been developing for a long time. More than thirty years ago Dubinin, Serebrovsky, and other, investigating the phenotypes of a number of "achaete-scute" alleles of Drosophilia melanogaster, found that the alleles could be arranged in a definite series accoding to bristle patters, and also that the heterozygotes lacked only those bristles which were affected in common by both participating alleles. They concluded that the serial classification of alleles according to bristle patters had its counterpart in a similar arrangement of portions of the achaete-scute gene locus. On this assumption they divided the locus into twelve elementary subunits. It was assumed that each allele arose by a change involving a certain combination of these centres. According to their theory, the achaete-scute locus is made up of separate, regularly spaced, and linearly arranged functional units. Several years later, Oliver described the occurrence of crossing over between two alleles of the "lozenge" locus. Then Green and a number of other workers analyzed similar phenomena in different regions of Drosophila chromosome. During the same period Lewis developed the theory of pseudoallelism, which interprets the occurrence of recombinants in interallelic crosses as the result of gene duplications. Thus …

Corrosion rates of present reactor grade uranium were measured in boiling distilled water and were found to have higher values almost by a factor of two then previously reported corrosion rates of uranium. Mallinckrodt biscuit metal showed corrosion rates in the same medium somewhat lower than reactor grade uranium, and high purity metal prepared at Argonne National Laboratory corroded considerably less rapidly than the biscuit metal.

From abstract: "The relative differential neutron-proton scattering cross section has been measured in the range of center-of-mass angles from 5.1° to 36.0° for approximately 90-Mev neutrons and from 10.7° to 37.8° for approximately 290-Mev neutrons."