"Abstract: Data on analog magnetic tape characteristics are presented along with results from conventional and modulator playback system operational tests. Theoretical considerations imply that the modulator head should be loss sensitive to short term variations in record and playback tape speed. It is also pointed out that although a tape recorder operating at 7.5 in./sec has only 12 kcs bandwidth for sinusoidal wave forms. the record and play-back amplifiers for pulse recording can operate with other bandwidths. These amplifiers must be capable of passing a square wave with a frequency of 1.5 kcs. A square wave of such frequency represents the condition of 350 microsecond pulses with a 700 microsecond period. (J.R.D)."

This manual contains the Radiation Control Standards'' and Radiation Control Procedures'' at Hanford Operations which have been established to provide the necessary control radiation exposures within Irradiation Processing Department. Provision is also made for including, in the form of Bulletins'', other radiological information of general interest to IPD personnel. The purpose of the standards is to establish firm radiological limits within which the Irradiation Processing Department will operate, and to outline our radiation control program in sufficient detail to insure uniform and consistent application throughout all IPD facilities. Radiation Control Procedures are intended to prescribe the best method of accomplishing an objective within the limitations of the Radiation Control Standards. A procedure may be changed at any time provided the suggested changes is generally agreeable to management involved, and is consistent with department policies and the Radiation Control Standards.

Abstract: The reactor kinetics equations are combined into a single integral equation whose kernel describes the time-dependent characteristics of the reactor including six delayed groups of neutrons. Numerical solutions of the integral equation are given for constant, linear, and ∫sin²kx dx reactivities. An approximate solution of the integral equation is obtained which provides a basis for the formulation and solution of the reactor system control problem using the methods of servomechanisms theory. The reactor frequency response function, a product of the approximate solution, is calculated and plot given.

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Price Daniel, regarding a legal question submitted for clarification: Issuance of Revenue Bonds under Article 2654c-1, V.C.S.

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Price Daniel, regarding a legal question submitted for clarification: Number of employees of the Board of Insurance Commissioners for whom travel expense funds are made available by the general appropriation bill for attending a meeting of the National Association of Insurance Commissioners.

None

Report documenting the suitability of Kentucky for plant locations to produce synthetic liquid fuels, based on raw materials, water sources, and local interest.

The net multiplication effect of beryllium oxide, which is due to the (n,2n) reaction, was calculated using an essentially exact calculation of the neutron spectrum as a function of energy. The upper limit of the (n,2n) cross section curve gives the unpoisoned value epsilon /sup +/ = 1.047 and the lower limit gives epsilon /sup -/ = 1,027. The behavior of the Li/sup 6/poisoned fast multiplication effect as a function of the number of collisions was studied for both beryllium and beryllium oxide. (auth)

None

None

Data on analog magnetic tape charactcristics are presented along with results from conventional and modulator playback system operational tests. Theoretical considerations imply that the modulator head should be loss sensitive to short term variations in record and playback tape speed. It is also pointed out that although a tape recorder operating at 7.5 in./sec has only 12 kcs bandwidth for sinusoidal wave forms. the record and play-back amplifiers for pulse recording can operate with other bandwidths. These amplifiers must be capable of passing a square wave with a frequency of 1.5 kcs. A square wave of such frequency represents the condition of 350 microsecond pulses with a 700 microsecond period. (J.R.D)

None

The following report measures a shield mockup in three regions: the first made almost entire of iron; the second, transition, region is made of various thicknesses of B4C; and the third region was borated water. The iron samples used in the experiments were made in the form of rectangular plates and place in the lid tank; however, the plates were not completely flat and created a water gap that was measured in this report.

Report presenting an investigation to determine the effectiveness of circulation control by applying suction through trailing-edge slots on a 45 degree sweptback wing. Various chordwise extents and depths of slot were investigated with and without deflection of a trailing-edge split flap. Results regarding the correlation of two-dimensional-section results with Ehlers' theory, effectiveness of circulation control on a sweptback wing, effect of slot configuration on circulation control, effect of trailing-edge split flap on circulation control, effect of circulation control on pitching moment, and circulation control at angle of attack are provided.

Report presenting a low-speed investigation in the stability tunnel to determine the static longitudinal stability and control characteristics of a 60 degree triangular-wing model with various triangular-all-movable horizontal tails. An all-movable trail of 10 percent of the wing area and aspect ratio 2.31 was investigated in 17 tail positions, including positions above, below, and to the rear of the assumed center of gravity.

Report presenting the damping-in-roll characteristics of three wings with an aspect ratio of 4, a taper ratio of 0.6, an NACA 65A006 airfoil section, and three different sweep angles at a range of Mach numbers and angles of attack. The data were obtained in the 7- by 10-foot tunnel transonic bump by utilizing the twisted-wing technique. Results regarding the damping-in-roll parameter, angle of attack, and lift-curve slope are provided.

Memorandum presenting an investigation conducted in the 4- by 4-foot supersonic pressure tunnel at Mach number 2.01 to determine the static stability and control characteristics of a canard-type missile configuration with large deflections of the canard controls and with deflection of wing-tip controls. The results of the investigation indicated that with a 30 degree deflection of the canard control a maximum trim normal-force coefficient of 0.4 and a maximum trim angle of attack of 12 degrees might be obtained for the optimum center-of-gravity location.

Approximate shapes of nonlifting bodies having minimum pressure foredrag at high supersonic airspeeds are calculated. With the aid of Newton's law of resistance, the investigation is carried out for various combinations of the conditions of given body length, base diameter, surface area, and volume. In general, it is found that when body length is fixed, the body has a blunt nose; whereas, when the length is not fixed, the body has a sharp nose. The additional effect of curvature of the flow over the surface is investigated to determine its influence on the shapes for minimum drag. The effect is to increase the bluntness of the shapes in the region of the nose and the curvature in the region downstream of the nose. These shape modifications have, according to calculation, only a slight tendency to reduce drag. Several bodies of revolution of fineness ratios 3 and 5, including the calculated shapes of minimum drag for given length and base diameter and for given base diameter and surface area, were tested at Mach numbers from 2.73 to 6.28. A comparison of theoretical and experimental foredrag coefficients indicates that the calculated minimum-drag bodies are reasonable approximations to the correct shape.

None

Report summarizing corrosion tests meant to determine the corrosion rates of bronze, mild steel, T-304 stainless steel and 2S aluminum in 10% potassium tetraborate solution. Tests were completed under the boiling point of each solution except for 2S aluminum, which was tested at 40C, the approximate temperature in a pile.

This report, compiled by Mr. W. R. Lewis of the Pile Technology Division, is a revision of Document HW-15516 (January 5, 1950) in consideration of new knowledge obtained during the past year. The document discusses the technical factors involved in attaining higher power levels in the various Hanford Piles. The purpose of this presentation is to summarize the present operating limitations and the possibilities of increased production rates. The limitations discussed are: A. Reactivity and flattening; B. Aluminum thimbles; C. Graphite temperature considerations; D. Boiling or vapor binding considerations; E. Tube and slug jacket corrosion; F. Effluent water activity; G. Distortion of the biological shields; H. Radiation considerations; and I. Pile control system capacity.

The feasibility of improving swelling resistance in metallic uranium by increasing the dislocation density is under investigation. Increasing the density of dislocations is expected to increase the number of sites at which fission product gas atoms are "pinned," increase the number of gas bubble nuclei, and increase mechanical strength. Dislocations are introduced by a treatment which involves deformation of metastable beta or gamma phase in uranium-rich alloys, followed by transformation. Activity has been concerned primarily with selection of uraniurnbase alloys for initial evaluation, procurement of materials, installation of specialized equipment, and development of techniques. A number of small ingots were produced, and screening tests were carried out on several analyses. These preliminary experiments were designed to show the deformation characteristics of the alloys in the metastable state as a function of rolling temperature and time. Initial results on gamma-stabilized binary alloys containing 2, 3.5, 5, and 7 wt. % Mo showed that large reductions are possible in 5 and 7 wt. % Mo alloys at450 deg C. The more dilute alloys are relatively difficult to roll, although small reductions were achieved. Aging experiments on deformed and undeformed 5 wt. % Mo alloys indicate that deformation accelerates the aging process and …

Abstract: "The information contained in this report consists of personnel exposures to radioactive dust resulting from a thorium rolling operation."

From introduction: "This report summarizes the experimental data obtained at the San Pablo Laboratory on the corrosion of 5% Cr - 0.5% Mo steel by bismuth under conditions that allow mass transfer to occur. The bismuth is circulated through a temperature gradient by means of a thermosiphon loop."