Report presenting an investigation to determine the effectiveness of circulation control by applying suction through trailing-edge slots on a 45 degree sweptback wing. Various chordwise extents and depths of slot were investigated with and without deflection of a trailing-edge split flap. Results regarding the correlation of two-dimensional-section results with Ehlers' theory, effectiveness of circulation control on a sweptback wing, effect of slot configuration on circulation control, effect of trailing-edge split flap on circulation control, effect of circulation control on pitching moment, and circulation control at angle of attack are provided.

Approximate shapes of nonlifting bodies having minimum pressure foredrag at high supersonic airspeeds are calculated. With the aid of Newton's law of resistance, the investigation is carried out for various combinations of the conditions of given body length, base diameter, surface area, and volume. In general, it is found that when body length is fixed, the body has a blunt nose; whereas, when the length is not fixed, the body has a sharp nose. The additional effect of curvature of the flow over the surface is investigated to determine its influence on the shapes for minimum drag. The effect is to increase the bluntness of the shapes in the region of the nose and the curvature in the region downstream of the nose. These shape modifications have, according to calculation, only a slight tendency to reduce drag. Several bodies of revolution of fineness ratios 3 and 5, including the calculated shapes of minimum drag for given length and base diameter and for given base diameter and surface area, were tested at Mach numbers from 2.73 to 6.28. A comparison of theoretical and experimental foredrag coefficients indicates that the calculated minimum-drag bodies are reasonable approximations to the correct shape.

Report presenting a low-speed wind-tunnel investigation to determine the characteristics of deflectable wing-tip ailerons on an untapered 45 degree sweptback semispan wing. Ailerons with triangular and parallelogram plan forms with a maximum chord of 0.625 wing chord and a flat-plat profile were investigated. The aerodynamic characteristics in pitch and lateral control characteristics are included.

Report presenting a low-speed investigation in the stability tunnel to determine the static longitudinal stability and control characteristics of a 60 degree triangular-wing model with various triangular-all-movable horizontal tails. An all-movable trail of 10 percent of the wing area and aspect ratio 2.31 was investigated in 17 tail positions, including positions above, below, and to the rear of the assumed center of gravity.

Report presenting the damping-in-roll characteristics of three wings with an aspect ratio of 4, a taper ratio of 0.6, an NACA 65A006 airfoil section, and three different sweep angles at a range of Mach numbers and angles of attack. The data were obtained in the 7- by 10-foot tunnel transonic bump by utilizing the twisted-wing technique. Results regarding the damping-in-roll parameter, angle of attack, and lift-curve slope are provided.

Report presenting an investigation to determine if thin airfoils with increased values of low-speed maximum lift coefficient but also retain the basic advantages of thin sections at high Mach numbers can be developed. Several experimental thin airfoil sections were developed from an analysis of airfoil data and two of them were investigated at high and low subsonic Mach numbers. Results regarding the low-speed characteristics and high-speed characteristics are provided.

From Summary: "A description of the test methods used at the National Bureau of Standards for determining the characteristics of aircraft compasses is given. The methods described are particularly applicable to compasses in which mineral oil is used as the damping liquid. Data on the viscosity and density of certain mineral oils used in United States Navy aircraft compasses are presented. Results of flight tests are presented."

Memorandum presenting an investigation conducted in the 4- by 4-foot supersonic pressure tunnel at Mach number 2.01 to determine the static stability and control characteristics of a canard-type missile configuration with large deflections of the canard controls and with deflection of wing-tip controls. The results of the investigation indicated that with a 30 degree deflection of the canard control a maximum trim normal-force coefficient of 0.4 and a maximum trim angle of attack of 12 degrees might be obtained for the optimum center-of-gravity location.

Report discussing tests on the N9M-2 airplane to evaluate the airplane efficiency factor and to investigate the characteristics of the aeroboost in the elevon control system. The efficiency factor compared reasonably well to conventional airplanes and the aeroboost system and valve-chatter tests were satisfactory.