The nuclear safety portion of this report is inclined to ignore the factors by which safety limits can be increased. It makes no mention of the control that can be exercised by limiting the assay of the U-235 being processed in the plant. From some of the previous reports, it is apparent that this plant is not anticipating processing U-235 of assay greater than approximately 20%. At this value, many of the numbers that are presented in the tables could be increased markedly. Rough examination indicates that these values all refer to top product U-235. The general discussion is, however, excellent. The references apparently used are those unclassified references with which we are all familiar and think highly of. We would recommend the inclusion of TID-7016.

Methods for the determination of plutonium and uranium in highly radioactive scrup dissolver solutions have been developed. Plutonium was separated from the dissolver solutions by solvent-extraction and ion-exchange techniques and determined by potentiometric titration. Uranium was separated by ion exchange and determined by potentiometric titration. Solutions that were similar to the actual dissolver solutions and that contained known amounts of plutonium and uranium were analyzed by these methods. Evaluation of the data secured for the determination of plutonium and uranium by the methods given herein indicated that, within the limits of the precision of the methods, there was no bias. The precision of the data obtained for the determination of plutonium, expressed as the relative standard deviation, was better than 2% for plutonium in the concentration range of 0.27 to 0.64 mg/ml. The precision for uranium was estimated to be about 0.2% for uranium concentrations of 425 mg/ml. These methods and the data obtained by then are discussed in this report; the procedures are appended.

Technical report with short reports on (1) P-9 recovery from UO2F2 solution; (2) Correlation of theories on action of radiation on matter; (3) Literature surveys on organic compounds and on chemistry of UO2F2; (4) effect of radiation on organic compounds; and (5) Effect of radiation on 100 area construction materials.

From abstract: "Twelve binary chromium-base alloy systems were screened for hot workability, oxidation resistance, and hot strength using small ore-melted ingots...Experiments with the preparation of large chromium-base alloy ingots showed that cold-mold ore melting was not suitable for preparing ingots containing over about 1 w/o of alloy addition."

Part I. Experimental Reactors: The effect of prompt-neutron lifetime upon reactor safety was investigated for the HRT. It was found that for a given pressure rise the allowable rate of reactivity addition was relatively insensitive to the average prompt-neutron lifetime, although the rate de creased somewhat with decreasing lifetime for the higher pressure rises. With only source neutrons present and the reactor initially subcritical, the allowable rate was practically independent of the initial value of k£. For a core-pressure rise of 400 psi, the corresponding rate of reactivity addition was about 0.8% per second; for a pressure rise of 4000 psi, the rate was 2.5 to 3.0% per second. Part II. Thorium Breeder Reactor: An economic study of one-region thorium breeder reactors was completed. Where possible, the process characteristics and cost factors were the same as those used previously in studies of two-region-type reactors. The mini mum-cost reactor is about 12 ft in diameter, operating with 260 g of thorium per liter on a chemical processing cycle of about 450 days. The ratio of U232 to U233 produced is approximately 2 x 10~4 VIM in the minimum-cost one-region system, compared with 4 x 10 5 in the two-region system. The …

Abstract: In one of the final stages of the process at the Mallinckrodt Uranium Refining Center, a 45 per cent nitric acid solution at about 170 F is used to pickle the calcined magnesium fluoride scale off the uranium derbies. The increase in the fluoride-ion content of the bath tends to promote corrosion of the Type 347 stainless tanks. This attack becomes excessive if 0.3 g/liter of fluoride ion or more is present. It was found that if aluminum ion is added to the solution the corrosiveness of the bath can be controlled. Two or three times as much aluminum ion as fluoride ion present is found satisfactory at 170 F. Indications are that the tying up of the fluoride-ion by the complexion [AlF6]8 is responsible for the corrosion control.

The effects of oxidation and irradiation on the microsurface structure of pile graphite have been investigated by measuring the surface area and pore size distribution of several samples. The results obtained for both oxidized and irradiated graphite samples indicate that changes in surface characteristics which occur are determined by the flux, temperature of irradiation, and gaseous atmosphere in which the radiation takes place.

In recognition of the need for an integrated system plan for future development requirements for radiological instrumentation, this information report was written to provide the initial step concerning such a planning. The report is to be considered a basic information analysis of the present in-use plant radiological instrumentation, of the instrumentation now undergoing active development, and of the future development work contemplated.

This quarterly progress report details the ongoing research happening at the Oak Ridge National Laboratory. In particular, this report discusses the current status of the Homogenous Reactor Experiment, boiling reactor and slurry studies, and general homogenous reactor studies.

From abstract: "The variation of the reactivity of a pile as a function of width of a transverse gap is obtained. The method involves first finding the boundary condition satisfied by the flux at the gap face. This, in principle, provides enough information for a complete solution of the pile equations. A method for calculating the reactivity change is presented. The calculated reactivity is compared with experiment and a brief discussion of the validity of the approximations is given."

The following report describes the crystal structures of NpC and Pu2O3 identified by x-ray diffraction.

Analysis of the problem of accelerating ions in a Thomas cyclotron has been confined almost entirely to the integration of various equations of motion (for single particles) for which a complete field description is necessary. In contrast, the problem of principal interest to rf system engineers concerns the gross transfer of electrical energy from an rf generator into an accelerated beam.