Report presenting an exploratory investigation of three aluminum disoaps of C(sub 8) acids to determine the gelling properties and stabilizing ability in slurries of 50 percent magnesium power and JP-4 fuel. All of the soaps were found to gel the slurries satisfactorily and to exhibit adequate reproducibility of gel properties. Results regarding the soap behaviors, effects of temperature, viscosity, and formation of the gel structures are provided.

Memorandum presenting a study of the ignition of ammonia and mixed oxides of nitrogen at 160 degrees Fahrenheit made with and without fuel additives utilizing small-scale rocket engines of approximately 200 pounds thrust. All experiments were conducted at sea-level pressures except two at a range of pressure altitudes. Results regarding the use of lithium as a catalyst, calcium as a catalyst, and no apparent catalyst are provided.

Memorandum presenting an investigation of the forced-convection heat-transfer and pressure-drop characteristics of a staggered closely spaced 0.020-inch wire metal-to-air heat exchanger. Eight wire banks were electrically heated, and the range of variables included bulk Reynolds numbers based on wire diameter and maximum velocity, from 82 to 1900, average wire temperatures up to 1109 degrees R, and heat flux densities up to 84,000 Btu per hour per square foot.

From Introduction: "In reference 1, in which the performance of conical supersonic scoop inlets on circular fuselages is reported, the drag of the bottom-inlet configuration was considerably higher than for the top inlet."

"The performance of liquid fluorine and liquid ammonia as a propellant combination was evaluated in 1000-pound-thrust rocket engines operated at a chamber pressure of 600 pounds per square inch absolute. Values of specific impulse, characteristic velocity, thrust coefficient, and heat rejection were obtained as functions of propellant mixture ratio for each of four injectors: a triplet, a showerhead, and two like-on-like types" (p. 1).

Report presenting an experimental investigation to determine the low-speed yawing stability derivatives of a model of the Douglas A4D-1 airplane. The model was tested in clean and landing configurations with horizontal and vertical tails on and off. Results are provided without analysis.

Report presenting a study of four short annular diffusers with different diffuser passage area variations and with various combinations of straightening vanes, vortex generators, splitters, and boundary layer suction for flow control. Results regarding turbine discharge whirl, diffuser passage modification, and boundary layer control are provided.

Report presenting an experimental investigation to determine the effect of several wedge-type boundary-layer diverters on drag and inlet pressure recovery in the 8- by 6-foot supersonic wind tunnel at Mach numbers of 1.5, 1.8, and 2.0. The model consisted of two rectangular ramp-type inlets mounted on the NACA RM-10 body of revolution. Results regarding variation of inlet pressure recovery and configuration drag with inlet mass-flow ratio, changes in the shock pattern off the inlet ramp, pressure-recovery-mass-flow characteristics, and drag coefficients are provided.

From Summary: "This paper presents the results of an investigation of the dynamic stability and controllability of a model which approximately represents the Lockheed XFV-1 airplane to a 1/8 scale. The investigation consisted of hovering flights in still air at a considerable height above the ground, hovering flights very close to the ground, vertical take-offs and landings, flights through the transition range from hovering to normal forward flight, and sideways translational flights."