Report presenting an experimental investigation conducted in the supersonic wind tunnel at three Mach numbers on a translating-spike inlet analytically designed to keep the cone shoulder downstream of the cowl-lip station without a net internal contraction. The inlet in this investigation had an internal cowl-lip angle of 17.5 degrees and was constructed to have the same inlet capture area and maximum cross-sectional area as a previously tested inlet with an internal cowl-lip angle of only 7 degrees. Results regarding the total pressure recovery, effect of spike translation, external drag coefficients, and effective thrust parameter are provided.

Report presenting an investigation in the transonic blowdown tunnel at a range of Mach numbers to determine the increments in lift, drag, and pitching moments due to the installation of a semielliptical-shaped air inlet in the root of a 45 degree sweptback wing and to study the internal flow characteristics of the inlet. Results regarding the internal pressure measurements, effect of inlet installation on external aerodynamic characteristics, effect of boundary-layer removal on internal pressure recovery, and inlet performance are provided.

This paper present results of an investigation of the lateral-control and hinge-moment characteristics of a 0.67 semispan flap-type spoiler aileron on a semispan thin 60 degree delta wing at transonic speeds by the reflection-plane technique. The spoiler-aileron had a constant chord of 10.29 percent mean aerodynamic chord and was hinged at the 81.9-percent-wing-root-chord station. Results indicated reasonably linear variations of rolling-moment and hinge-moment coefficients with spoiler projection except at spoiler projections of less than -2 percent mean aerodynamic chord and angles of attack greater than 12 degrees with results generally independent of slot geometry.

Report presenting an investigation in the 8- by 6-foot supersonic wind tunnel to evaluate the performance of a translating-cone inlet operated over a range of Mach numbers and angles of attack. The effects of spike projection and internal flow area variation on pressure recovery, external drag, and corrected air-flow variation were determined.

"A transonic turbine designed for a maximum blade-surface relative Mach number of 1.57 was investigated experimentally. The performance of the turbine is compared with that of three other transonic turbines that were previously investigated" (p. 1).

Report presenting an investigation made to improve compressor performance by bleedoff of detrimental boundary layer through a porous compressor casing. The results were compared to the performance characteristics of the original engine. Bleedoff was found to increase the efficiency of the compression process, but the overall performance of the turbojet suffered.

From Summary: "Incipient spin characteristics have been investigated on a 1/35-scale dynamic model of the Convair F-102A airplane. The model was launched by a catapult apparatus into free flight with various control settings, and the motions obtained were photographed. The model was ballasted for the combat loading. All tests were made with the speed brakes and landing gear retracted, and engine effects were not simulated."

Memorandum presenting surveys of the impact pressure of the flow to obtain information for determining pressure losses in four different turbosupercharger nozzle boxes. The data indicated substantial differences in total head loss among the boxes and the existence of sharply defined high-loss regions in portions of the nozzle annulus.

Report presenting an investigation in the transonic tunnel to determine the characteristics of several flap-type spoiler ailerons, lower-surface deflector ailerons, and spoiler-slot-deflector ailerons. Six-component force and moment data were obtained at a range of Mach numbers and angles of attack.

Report presenting measurements of downwash angles at points at two vertical positions at the probable tail location behind a high-aspect-ratio wing with an NACA 65-210 section with no sweep and 30 degrees and 45 degrees of sweepback and sweepforward in conjunction with a fuselage.

An investigation has been conducted in the Cleveland altitude wind tunnel to determine the operational characteristics of the I-40 jet-propulsion engine over a range of pressure altitudes from 10,000 to 50,000 feet and ram-pressure ratios from 1.00 to 1.76. Engine operational data were obtained with the engine in the standard configuration and with various modifications of the fuel system, the electrical system, and the combustion chambers. The effects of altitude and airspeed on operating speed range, starting, windmilling, acceleration, speed regulation, cooling, and vibration of the standard and modified engines were determined, and damage to parts was noted.

Report presenting a wind-tunnel investigation to determine the effects of two wing-root leading-edge plan-form modifications, including a notched leading-edge fillet and a rounded leading-edge fillet, on the low-speed longitudinal stability characteristics of an airplane model with a 50.7 degree sweptback wing. Results regarding stability at zero lift, variation of stability with lift coefficient, and lift and drag characteristics are provided.

Report presenting an investigation of the low-speed, power-off stability and control characteristics of a model of the McDonnell XF3H-1 airplane. Flight testing occurred in the clean and slat- and flaps-extended conditions over a range of lift coefficients.

"At the request of the Bureau of Aeronautics, Navy Department, an investigation of the low-speed, power-off stability and control characteristics of a 1/10-scale model of the McDonnell XF3H-1 airplane has been made in the Langley free-flight tunnel. Flight tests of the model in the clean and in the slats-and-flaps-extended conditions were made over a lift-coefficient range from about 0.5 through the stall. Only low-altitude conditions were simulated and no attempt was made to determine the effect on the stability characteristics of freeing the controls" (p. 1).

An investigation was conducted to determine the combustion response to rapid fuel-flow changes in a single tubular combustor at two simulated altitude-rotor speed conditions of 25,000 feet-70 percent rated engine speed and 50,000 feet-70 percent rated engine speed. Limiting rates of change of fuel flow (acceleration limits) were determined and the effects of certain combustion air flow variables on the transient combustion characteristics were studied with the aid of rapid-response instrumentation.

Memorandum presenting a turbojet engine with a centrifugal-flow compressor which permitted overspeed, overtemperature operation and was modified for spray cooling. The effectiveness of spray cooling as a method which permits operation at overspeed, overtemperature conditions with this engine was investigated and the overspeed, overtemperature performance was obtained. Results regarding the cooling system performance, turbine performance, and engine performance are provided.

From Summary: "A knock-limited performance investigation was conducted on blends of triptane and 28-P fuel with a 12-cylinder, V-type, liquid-cooled aircraft engine of 1710-cubic-inch displacement at three compression ratios: 6.65, 7.93, and 9.68. At each compression ratio, the effect of changes in temperature of the inlet air to the auxiliary-stage supercharger and in fuel-air ratio were investigated at engine speeds of 2280 and. 3000 rpm. The results show that knock-limited engine performance, as improved by the use of triptane, allowed operation at both take-off and cruising power at a compression ratio of 9.68."

Memorandum presenting an investigation to determine the automatic lateral stability characteristics of a model equipped with a gyro stabilizing unit that gave response to bank and yaw. Stable flights were obtained with the flicker-type automatic control, and the amplitude of the oscillations was decreased by adding the attachment which provided hunting control.

"The results of an investigation of a 1/3-scale model of the Chance Vought XF5U-1 airplane in the Langley full-scale tunnel are presented in this report. The maximum lift and stalling characteristics of several model configurations, the longitudinal stability characteristics of the model, and the effectiveness of the control surfaces were determined with the propellers removed. The propulsive characteristics, the effect of propeller operation on the lift, and the static thrust of the model propellers were determined at several propeller-blade angles" (p. 1).

Memorandum presenting a flight investigation of the Bell X-5 variable-sweep research airplane in the 45 degree wing sweptback configuration over a range of Mach numbers. Lift and drag values are presented and a comparison is made with data obtained with a wing sweepback of 59 degrees.

Report presenting information regarding transient oscillations observed in response to elevator pulses of the Douglas D-558-I airplane at a range of Mach numbers and altitudes. An application of the Fourier transform was used to obtain the frequency-response characteristics. The effects of lift coefficient on the frequency response are also included.

The longitudinal stability and control characteristics of a 1/30-scale model of the Republic XF-103 airplane were investigated in the Langley 8-foot transonic tunnel. The effect of speed brakes located at the end of the fuselage was also investigated. The main part of the investigation was made with internal flow in the model, but some data were obtained with no internal flow. The longitudinal stability and control at transonic-speeds appeared satisfactory. The transonic drag rise was small. The speed brakes had no adverse effects on longitudinal stability.

Report discussing testing of a rocket-propelled airplane configuration model and a drag model, each with a 60 degree swept wing of aspect ratio 2.24, and different fuselages, at a Mach number range of 0.75 to 1.50. Information about the longitudinal stability, control, and drag characteristics and minimum-drag characteristics is presented.

From Summary: "A flight test has been conducted to determine the longitudinal stability and control characteristics of a 0.133-scale model of the Consolidated Vultee XFY-1 airplane with windmilling propellers for the Mach number range between 0.70 and 1.13. The variation of lift-curve slope C(sub L(sub alpha) with Mach number was gradual with a maximum value of 0.074 occurring at a Mach number of 0.97. Propellers had little effect upon the values of lift-curve slope or the linearity of lift coefficient with angle of attack."