Level densities and radiative strength functions in {sup 171}Yb and{sup 170}Yb nuclei have been measured with the {sup 171}Yb({sup 3}He, {sup 3}He{prime}{gamma}){sup 171}Yb and {sup 171}Yb({sup 3}He,{alpha}{gamma}){sup 170}Yb reactions. A simultaneous determination of the nuclear level density and the radiative strength function was made. The present data adds to and is consistent with previous results for several other rare earth nuclei. The method will be briefly reviewed and the result from the analysis will be presented. The radiative strength function for {sup 171}Yb is compared to previously published work.

One aspect of Science Based Stockpile Stewardship (SBSS) is to improve the quality of neutron cross section data for certain isotopes. The isotopes of interest are used to monitor neutron and charged particle fluxes in environments of brief, intense neutron fluxes. The accuracy of flux determination is dependent on the accuracy of cross section data for the stable isotopes loaded into the system and the unstable isotopes produced when the neutrons are incident on the monitor. For isotopes with a half-life greater than one day it is possible, given the production rates of RIA, to make radioactive targets for neutron irradiation. This would require the ability to harvest isotopes at RIA, an onsite radiochemistry facility for processing the harvested material into a target, and an onsite neutron source facility. The radiochemistry facility will need to handle activity levels on the order of 100's of Curie's while the neutron source facility will need to provide high intensity ''monoenergetic'' neutrons from 10's keV to 20 MeV. For isotopes with a half-life much less than one day, only indirect methods can be used to get information on the neutron cross sections because of the lack of a target. Both experimental techniques will be …

The overall objective of this project is the three phase development of an Early Entrance Coproduction Plant (EECP) which produces at least one product from at least two of the following three categories: (1) electric power (or heat), (2) fuels, and (3) chemicals. The objective is to have these products produced by technologies capable of using synthesis gas derived from coal and/or other carbonaceous feedstocks. The objectives of Phase I were to determine the feasibility and define the concept for the EECP located at a specific site; develop a Research, Development, and Testing (RD&T) Plan for implementation in Phase II; and prepare a Preliminary Project Financing Plan. The objective of Phase II is to implement the work as outlined in the Phase I RD&T Plan to enhance the development and commercial acceptance of coproduction technology that produces high-value products, particularly those that are critical to our domestic fuel and power requirements. The project will resolve critical knowledge and technology gaps on the integration of gasification and downstream processing to coproduce some combination of power, fuels, and chemicals from coal and/or other carbonaceous feedstocks. The objective of Phase III is to develop an engineering design package and a financing and testing …

We present {sup 9}Be and {sup 11}B NMR spin-lattice relaxation rate (1/T{sub 1}) measurements in UBe{sub 13-x}B{sub x} for x = 0.03 and 0.07 over the temperature range 0.096 K to 2 K. The temperature dependence of 1/T{sub 1} shows a strong B concentration dependence, especially at low temperatures. We interpret this behavior as consistent with gapless superconductivity induced by the addition of B impurities. The ratio of the {sup 9}Be to {sup 11}B 1/T{sub 1} increases with decreasing temperature below {Tc} indicating additional contributions to the {sup 9}Be relaxation rate, possibly from nuclear spin diffusion to normal-state vortex cores or paramagnetic impurities.

In this report we have described the broad and compelling range of astrophysical and cosmological evidence that defines the dark matter problem, and the WIMP hypothesis, which offers a solution rooted in applying fundamental physics to the dynamics of the early universe. The WIMP hypothesis is being vigorously pursued, with a steady march of sensitivity improvements coming both from astrophysical searches and laboratory efforts. The connections between these approaches are profound and will reveal new information from physics at the smallest scales to the origin and workings of the entire universe. Direct searches for WIMP dark matter require sensitive detectors that have immunity to electromagnetic backgrounds, and are located in deep underground laboratories to reduce the flux from fast cosmic-ray-muon-induced neutrons which is a common background to all detection methods. With US leadership in dark matter searches and detector R&D, a new national laboratory will lay the foundation of technical support and facilities for the next generation of scientists and experiments in this field, and act as magnet for international cooperation and continued US leadership. The requirements of depth, space and technical support for the laboratory are fairly generic, regardless of the approach. Current experiments and upgraded versions that run …

Superconducting Gamma-ray detectors offer an order of magnitude higher energy resolution than conventional high-purity germanium detectors. This can significantly increase the precision of non-destructive isotope analysis for nuclear samples where line overlap affects the errors of the measurement. We have developed Gamma-detectors based on superconducting molybdenum-copper sensors and bulk tin absorbers for nuclear science and national security applications. They have, depending on design, an energy resolution between {approx}50 and {approx}150 eV FWHM at {approx}100 keV. Here we apply this detector technology to the measurement of uranium isotope ratios, and discuss the trade-offs between energy resolution and quantum efficiency involved in detector design.

Scientists are finding increased applications for microcomputers as process controllers in their experiments. However, while microcomputers are small and inexpensive, they are difficult to program in machine or assembly language. A high-level language is needed to enable scientists to develop their own microcomputer programs for their experiments on location. Recognizing this need, LLL contracted to have such a language developed. This report describes the result--the LLL BASIC interpreter, which operates with LLL's 8080-based MCS-80 microcomputer system. 4 tables.

This paper describes work in progress to develop a standard for interoperability among high-performance scientific components. This research stems from growing recognition that the scientific community must better manage the complexity of multidisciplinary simulations and better address scalable performance issues on parallel and distributed architectures. Driving forces are the need for fast connections among components that perform numerically intensive work and parallel collective interactions among components that use multiple processes or threads. This paper focuses on the areas we believe are most crucial for such interactions, namely an interface definition language that supports scientific abstractions for specifying component interfaces and a ports connection model for specifying component interactions.

This document presents data from Savannah River Site routine effluent monitoring and environmental surveillance programs.

The mission at the Savannah River Site (SRS) is focused primarily on support of the national defense, nonproliferation, and environmental cleanup. SRS-through its prime operating contractor, Westinghouse Savannah River Company-continues to maintain a comprehensive environmental monitoring program.

The Plasma Electrode Pockels Cell (PEPC) embodies technology essential to the National Ignition Facility (NIF). Together with a thin-film polarizer, PEPC functions as an optical switch for the main amplifier cavity, allowing optical pulses to be trapped, and then released, and enabling NIF to take advantage of the attendant gain and cost-savings. Details of the genesis, development, and prototyping of the PEPC are well documented. After moving from its laboratory setting to the NIF facility, PEPC--via its performance during the two-year NIF Early Light (NEL) campaign and its ongoing operation during facility build-out--has proven to be a fully functional system. When complete, NIF will accommodate 192 beams, capable of delivering 1.8 MJ to a fusion target. Forty-eight Plasma Electrode Pockels--driven by nearly 300 high-power, high-voltage pulse generators--will support this complement of beams. As deployed, PEPC is a complex association of state-of-the-art optics; low-voltage and high-voltage electronics; and mechanical, gas, and vacuum subsystems--all under computer control. In this paper, we briefly describe each of these elements, but focus on the pulse power aspects of the PEPC system.

The authors present a measurement of the angle {gamma} of the Unitarity Triangle with a Dalitz analysis of neutral D decays to K{sub S}{pi}{sup +}{pi}{sup -} from the processes B{sup 0} {yields} {bar D}{sup 0}(D{sup 0})K*{sup 0} ({bar B}{sup 0} {yields} D{sup 0}({bar D}{sup 0}){bar K}*{sup 0}) with K*{sup 0} {yields} K{sup +}{pi}{sup -} ({bar K}*{sup 0} {yields} K{sup -} {pi}{sup +}). Using a sample of 371 x 10{sup 6} B{bar B} pairs collected with the BABAR detector at PEP II, they measure the angle {gamma} as a function of r{sub S}, the magnitude of the average ratio between b {yields} u and b {yields} c amplitudes. Combining this result with the available information on r{sub S}, they obtain {gamma} = (162 {+-} 56){sup o} or (342 {+-} 56){sup o} and r{sub S} < 0.55 at 95% probability.

The performance of the Beamlet laser with one dimensional smoothing by spectral dispersion (1D SSD) implemented is investigated. Measurements of the near field beam quality, nonlinear breakup, and transmission through spatial filter pinholes show a modest effect only at large SSD divergence. No measurable effect was found at the divergence level planned for indirect drive ignition experiments. The efficiency of conversion to the third harmonic was also measured with SSD present and found to be somewhat larger than expected from an ideal plane wave model.

Additional double-shell tank storage capacity is not needed until FY 2004 or later. The waste volume in the current baseline program can be managed within the existing tank capacity. However, this requires implementation of some risk management actions and significant investment in software and hardware to accomplish the actions necessary to maximize use of existing storage tank space.

None

TPV technology has advanced rapidly in the last five years, with diode conversion efficiency approaching >30%, and filter efficiency of {approx}80%. These achievements have enabled repeatable testing of 20% efficient small systems, demonstrating the potential of TPV energy conversion. Near term technology gains support a 25% efficient technology demonstration in the two year timeframe. However, testing of full size systems, which includes efficiency degradation mechanisms, such as: nonuniform diode illumination, diode and filter variability, temperature non-uniformities, conduction/convection losses, and lifetime reliability processes needs to be performed. A preliminary analysis of these differential effects has been completed, and indicates a near term integrated system efficiency of {approx}15% is possible using current technology, with long term growth to 18-20%. This report addresses the system performance issues.

Tritium-release kinetics studies have been conducted on eight beryllium specimen disks, irradiated in the European Community/United States of America (EC/USA) Collaborative SIBELIUS irradiation test. These studies, measuring tritium-release rate versus time over several temperatures, have generated a series of well-characterized tritium release curves. These release curves are presented, along with supporting information, to provide input data in support of tritium transport prediction models and code development.

Methods for extending the productive life of marginal wells in the East Texas Field were investigated using advanced computer imaging technology, geophysical tools, and selective perforation of existing wells. Funding was provided by the Department of Energy, TENECO Energy and Schlumberger Wireline and Testing. Drillers' logs for more than 100 wells in proximity to the project lease were acquired, converted to digital format using a numerical scheme, and the data were used to create a 3 Dimensional geological image of the project site. Using the descriptive drillers' logs in numerical format yielded useful cross sections identifying the Woodbine Austin Chalk contact and continuity of sand zones between wells. The geological data provided information about reservoir continuity, but not the amount of remaining oil, this was obtained using selective modern logs. Schlumberger logged the wells through 2 3/8 inch tubing with a new slimhole Reservoir Saturation Tool (RST) which can measure the oil and water content of the existing porosity, using neutron scattering and a gamma ray spectrometer (GST). The tool provided direct measurements of elemental content yielding interpretations of porosity, lithology, and oil and water content, confirming that significant oil saturation still exists, up to 50% in the upper Woodbine …

This project involved the following objectives: 1. Determine black liquor drying and devolatilization elemental and total mass release rates and yields. 2. Develop a public domain physical/chemical kinetic model of black liquor drop combustion, including new information on drying and devolatilization. 3. Determine mechanisms and rates of sulfur scavenging in recover boilers. 4. Develop non-ideal, public-domain thermochemistry models for alkali salts appropriate for recovery boilers 5. Develop data and a one-dimensional model of a char bed in a recovery boiler. 6. Implement all of the above in comprehensive combustion code and validate effects on boiler performance. 7. Perform gasification modeling in support of INEL and commercial customers. The major accomplishments of this project corresponding to these objectives are as follows: 1. Original data for black liquor and biomass data demonstrate dependencies of particle reactions on particle size, liquor type, gas temperature, and gas composition. A comprehensive particle submodel and corresponding data developed during this project predicts particle drying (including both free and chemisorbed moisture), devolatilization, heterogeneous char oxidation, char-smelt reactions, and smelt oxidation. Data and model predictions agree, without adjustment of parameters, within their respective errors. The work performed under these tasks substantially exceeded the original objectives. 2. A separate …

The Savannah River National Laboratory (SRNL) has developed an analytical method to measure many trace elements in a variety of uranium materials at the high part-per-billion (ppb) to low part-per-million (ppm) levels using matrix removal and analysis by quadrapole ICP-MS. Over 35 elements were measured in uranium oxides, acetate, ore and metal. Replicate analyses of samples did provide precise results however none of the materials was certified for trace element content thus no measure of the accuracy could be made. The DOE New Brunswick Laboratory (NBL) does provide a Certified Reference Material (CRM) that has provisional values for a series of trace elements. The NBL CRM were purchased and analyzed to determine the accuracy of the method for the analysis of trace elements in uranium oxide. These results are presented and discussed in the following paper.

This review indicates the present limiting capacities within the Redox plant and presents courses of action necessary to realize an instantaneous rate of 12/TD. The changes contemplated to reach this goal are time cycle reductions, procedural changes, and equipment changes which can be undertaken and achieved by the Redox organization presumably without recourse to project funds or special authorizations. The review proceeds systematically from the dissolvers, through head and, the extraction columns, concentrators, tail end equipment, and auxiliary equipment.

The present invention relates to a metal-oxide ceramic composition useful in induction heating applications for treating uranium and uranium alloys. The ceramic composition is electrically conductive at room temperature and is nonreactive with molten uranium. The composition is prepared from a particulate admixture of 20 to 50 vol. % niobium and zirconium oxide which may be stabilized with an addition of a further oxide such as magnesium oxide, calcium oxide, or yttria. The composition is prepared by blending the powders, pressing or casting the blend into the desired product configuration, and then sintering the casting or compact in an inert atmosphere. In the casting operation, calcium aluminate is preferably added to the admixture in place of a like quantity of zirconia for providing a cement to help maintain the integrity of the sintered product.

Final report on conference grant supporting the American Physical Society Division of Particles and Fields meeting in Philadlephia, PA April 5-8, 2003.

None