From introduction: "The present investigation of the properties of boron stainless steel is an outgrowth of a project started in 1947. The problem is to replace the present steel used for drop rods in the Hanford piles with a material much less subject to corrosive attack from the humid atmosphere existing at the location of the rods."

A flexible foil data processing program is described. Raw data on foil radioactivity are the basic input information required. Output may consists of relative activities, saturated activities, and/or cadmium ratio and flux spectrum data. A statistical analysis of the data is executed with the direct calculation, and errors estimated for the output data.

Several plates of 98.7% Th - 1.2% U 235 (clad in aluminum) were irradiated in the MTR for an integrated flux of 2.6 x 10 21 neutrons/cm2. Although these samples represent an early development in bonding of aluminum to thorium and there are better methods at present, the bond proved to be quite strong and both clad and core were dimensionally stable under irradiation. The production of uranium 233 was as much as theory would indicate and the total amount of fissionable material material after irradiation and after decay of the protactinium 233 was greater than before irradiation. A fuel element of this nature appears to offer excellent potentialities from the standpoint of radiation stability.

This report presents data obtained from processing 33 Clementine Reactor fuel elements in the ORNL Metal Recovery Plant to recover approximately 15 kg of plutonium and 0.16 g of americium.

Abstract: A control system to provide digital printing and to plot an analog trace on an electric operated IBM model 11C Output Writer is described. The Digital mode of operation translates multidigit numbers through a set of commands to print each digit serially, then presents them to the output writer in a time sequence. The Analog mode of operation converts a d.c. input voltage to a digital number and by tab and space bar commands translates the carriage horizontally a distance proportional to this number.

Abstract. In addition to the hexagonal and monoclinic bismuth phosphate precipitates, whose structures are now known, a third crystalline phase has been found to appear in BiPO4 precipitates after (a) extremely long digestion in concentrated nitric acid; (b) oven drying at 800 degrees to 1000 degrees. Thought very small single crystals of the component have been isolated, nor crushed sample contained less than 30% of the beta-form. The cell size and symmetry of the crystal indicates that there ae two bismuth atoms in the cell, and there is no evidence that the compound is not BiPO4. It is suggested that this maty be a third form of BiPO4, stable over a short range of conditions, and tending to revert to the beta-form.

The error that results when it is attempted to evaluate stress from a reading taken on a single element SR-4 strain gage in a biaxial stress field is discussed. A method is presented for relating SR-4 rosette strain gage readings directly to the biaxial stress state without the necessity of first converting strain gage readings to true strains. Correction formulas are presented for use when single element SR-4 gages are used as rosette elements or as stress gages.