Report discussing testing to determine the drag characteristics at zero lift of a wing with a circular-arc airfoil section with a maximum thickness of 9 percent chord. The results were compared to previous testing on an NACA 65-009 airfoil. It was found that the NACA airfoil had lower drag coefficients than the circular-arc airfoil tested in this experiment.

Report presenting the results of flight tests conducted to determine the effect of number of fins on the drag of a pointed body moving at low supersonic velocities. The data indicated that the interference drag increased with increased number of ins up to a Mach number of 1.35, but above that value, the effect is reversed to the end of the test Mach number.

Report presenting a test-stand investigation conducted on a rectangular ramjet engine design for installation in an aircraft wing. The engine operated without excessive engine noise or vibration over the entire range of operating conditions. Results regarding inlet velocity, exhaust flame characteristics, fuel-air ratio, and total-temperature rise are provided.

Characteristics of NACA submerged duct entries and wing leading-edge inlets designed for a 1/4 scale flow model of a fighter-type airplane powered by a jet engine in the fuselage are presented.

An investigation is in progress at the Langley Laboratory of the NACA to explore the possibilities of axial-flow compressors operating with supersonic velocities relative to the blade rows. The first phase of this investigation, a study of supersonic diffusers, has been reported. The second phase, an analysis of supersonic compressors, has also been reported. Preliminary calculations have shown that very high pressure ratios across a stage, together with somewhat increased mass flows, are possible with compressors which decelerate air through the speed of sound in their rotor blading. These performance characteristics are desirable in compressors for aircraft jet propulsion units, gas turbines, or superchargers. The third phase, presented here, is a preliminary experimental investigation of a supersonic compressor designed to produce a high pressure ratio in a single stage.

Powered models of three different flying boats were landed in oncoming wave of various heights and lengths. The resulting motions and acceleration were recorded to survey the effects of varying the trim at landing, the deceleration after landing, and the size of the waves. One of the models had an unusually long afterbody. The data for landing with normal rates of deceleration indicated that the most severe motions and accelerations were likely to occur at some period of the landing run subsequent to the initial impact.

"Efficiency investigations have been made on a single-stage modification of the turbine of a Mark 25 aerial torpedo to determine the performance of the unit with five different turbine nozzles. The output of the turbine blades was computed by analyzing the windage and mechanical-friction losses of the unit. The turbine was found to be most efficient with a cast nozzle having sharp-edged inlets to the nine nozzle ports" (p. 1).

"An investigation was conducted to correlate the engine service performance of cast Vitallium turbine buckets with standard laboratory metallurgical data. Data were obtained from four I-40 turbine wheels of Timken alloy with cast Vitallium buckets. In order to accelerate bucket deterioration, the turbine wheels were subjected to 20-minute cycles consisting of 5 minutes at idle and 15 minutes at rated speed" (p. 1).