Report presenting simulator studies of a homing missile pursuing a constant-velocity nonmaneuvering target. The missile dynamics in pitch and roll, seeker method of deflection and control, and the missile-target geometry were simulated to determine whether the method of control and detection in conjunction with the missile dynamics were feasible.

Report presenting flight tests using a rocket-propelled 60 degree delta-wing body configuration, which included a NACA 0003-63 wing airfoil section. Drag at lift and stability data were obtained for a range of Mach numbers.

Report presenting an investigation in the 4- by 4-foot supersonic pressure tunnel to determine the static longitudinal and lateral stability and control characteristics of an 0.065-scale model of the Chance Vought Regulus II missile. The tests were made at three Mach and Reynolds numbers.

Report presenting lift and drag data obtained during the Douglas X-3 airplane. The data covered the Mach number range from 0.82 to 1.20 with considerable variation in lift. A comparison of the flight data with data from wind-tunnel and rocket-model tests shows that the model tests adequately predict the performance of the airplane.

Report presenting a determination of the performance and flow distributions in the first, fifth, and tenth stages of a 10-stage axial-flow research compressor at design and part speed in order to study the validity of the compressor design assumptions and to show the effects of part-speed compressor operation on stage performance.

Memorandum presenting an investigation of the performance of inlet configurations with a forebody designed for isentropic external compression at a nominal Mach number of 5.6. At zero angle of attack, all the configurations yielded larger total-pressure recoveries than had previously been obtained with a single-conical-shock inlet. Results regarding the flow about the forebody, inlet performance, and performance comparisons are provided.

Memorandum presenting a supersonic wind-tunnel investigation of the origin and distribution of store interference performed in the 4- by 4-foot supersonic pressure tunnel at Mach number 1.6. Separate forces on a store, a fuselage, a swept wing, and a swept-wing-fuselage combination were measured. The configuration investigated simulated a heavy bomber airplane with a large store or nacelle with frontal area equivalent to a twin-engine nacelle.

Report of theoretical values of performance parameters for liquid hydrogen and flourine as a rocket propellant for a wide range of fuel-oxidant and expansion ratios. Parameters computed include specific impulse, combustion-chamber temperature, nozzle-exit temperature, equilibrium composition, mean molecular weight, characteristic velocity, coefficient of thrust, ratio of nozzle-exit area to throat area, specific heat at constant pressure, coefficient of viscosity, and coefficient of thermal conductivity.

Memorandum presenting an experimental investigation of the adaptation of a transonic slotted tunnel to supersonic operation by enclosing the slots with fairings. The adaptation allows the extension of peak Mach number of the tunnel to be made at a reasonable cost in both time and effort, provided simplicity and ease of installation are taken into consideration during the design of the cover fairings. The nozzle is found to be sensitive to phenomena that will cause thickening of the boundary layer in the slot cover fairing.

Report presenting an investigation to determine the effect of blade-section camber on the stall-flutter characteristics of three propellers using a 6000-horsepower propeller dynamometer. Up to a certain blade angle, there was an increase in flutter-speed coefficient with an increase in blade-section design lift coefficient. An increase in thrust was found to lead to an increase in tip Mach number in the flutter region of the propeller blades.

Memorandum presenting a flight investigation in natural icing conditions to determine the effect of ice formations on the performance of an axial-flow turbojet engine. Tail-pipe temperature increased from 761 to 1065 degrees Fahrenheit and the jet thrust decreased from 1234 to 910 pounds during a period of 45 minutes in icing. No general conclusions can be reached from the data because the icing condition was relatively light.

Memorandum presenting the lift, pitching-moment, and drag characteristics of a missile configuration with a body of fineness ratio 9.33 and a cruciform triangular wing and tail of aspect ratio 4 at a Mach number of 1.99 and a Reynolds number of 6.0 million. Testing was performed to investigate the effects on the aerodynamic characteristics of roll angle, wing-tail interdigitation, wing deflection, and interference among the components. Results regarding the body-wing-tail combination, body, wing and tail, body-wing and body-tail combinations, and body-wing-tail interference are provided.

Report presenting a transonic investigation of the static-pressure fluctuations in the left duct of a scale inlet model of a supersonic fighter-bomber airplane in the transonic tunnel. Results regarding amplitude characteristics of pressure fluctuations, power-spectral analyses, and flow distortions at compressor face are provided.

"Convective heat-transfer coefficients in dry air were obtained for an ellipsoidal spinner of 30-inch maximum diameter for both stationary and rotating operation over a range of conditions including airspeeds up to 275 miles per hour, rotational speeds up to 1200 rpm, and angles of attack of zero and 4 degrees. The results are presented in terms of Nusselt numbers, Reynolds numbers, and convective heat-transfer coefficients. The studies included both uniform heating densities over the spinner and uniform surface temperatures" (p. 1).

"A principle formerly used in an instrument for cloud detection was further investigated to provide a simple and rapid means for measuring the liquid-water content of clouds at temperatures above and below freezing. The instrument consists of a small cylindrical element so operated at high surface temperatures that the impingement of cloud droplets creates a significant drop in the surface temperature. The instrument is sensitive to a wide range of liquid-water content and was calibrated at one set of fixed conditions against rotating multicylinder measurements. The limited conditions of the calibration Included an air temperature of 20 F, an air velocity of 175 miles per hour, and a surface temperature in clear air of 475 F" (p. 1).

Report presenting an investigation of a model of the Kingfisher XAUM-2 flying torpedo to determine the pressure recoveries within the jet engine nacelle and to determine the effects of several changes in model configuration on the aerodynamic characteristics of the model. The effectiveness of elevons and tabs as control devices was also investigated.

Report discussing testing to determine the longitudinal and lateral stability and control characteristics of a Chance Vought Regulus II missile at several Mach and Reynolds numbers.

Memorandum presenting a direct-connect duct investigation conducted with a one-quarter segment of a 25.5 inch diameter annular combustor which had been previously developed for liquid fuel injection. The combustor was modified by changing the fuel injectors and the liner design for vapor fuel injection. Results regarding accuracy and reproducibility, combustion efficiency, combustor-outlet temperature profiles, and pressure losses are provided.

Report presenting an investigation to determine the effectiveness of studying the dynamic characteristics of a low-speed slowly spinning fin-stabilized rocket with a free-oscillation technique and to study certain types of behavior that have been observed in this type of missile. Results regarding the stability of the original model, the effect of reversing direction of arming propeller, the effect of increasing the size of the reversed-rotation arming propeller, the effect of removing the arming propeller, the effect of adding a spoiler nose ring to a basic model, and the effect of changes in the spin rate are provided.

Memorandum presenting an investigation conducted to reduce the pressure drop in an experimental combustor designed to operate with high efficiencies at high altitude. The combustor utilized a previously designed prevaporizing fuel system that supplied vapor fuel to the injectors for high-altitude operation. Results regarding combustor development and performance of final combustor model 47L are provided.

Report presenting analytical estimates of the thrust, efficiency, drag, and weight of the air-turborocket engine. The effects of changes in the engine components on design and off-design performance are emphasized. Results regarding the performance, effect of design parameters, effect of subsonic cruising Mach number, geometry variations, engine weight estimates, and comparison with turbojet engines are provided.

Report presenting an investigation of an all-internal conical compression inlet with annular bleed at the throat at Mach number 5.0 and zero angle of attack. Results regarding the performance of the diffuser alone, a Pitot-pressure survey of the flow leaving the diffuser, total-pressure distribution, and inlet efficiencies are provided.

Memorandum presenting several proposed-high performance aircraft that have been studied analytically and by model flight tests to define some problem areas in dynamic lateral behavior of high-speed aircraft which require specific attention. Aileron control problems and Dutch roll characteristics with and without artificial damping were considered.

From Introduction: "A 12-percent-chord-thick wedge section and a reversed NACA 0012 section were chosen for these tests as they are representative of sections having no boat tailing and appreciable boat tailing (i.e., blunt and rounded trailing edges, respectively), and the results of this investigation are compared with those obtained from a previous investigation of the NACA 0012 section. Conclusions are drawn regarding the relative merits of the two unconventional sections and the conventional section in transonic speed range."