Report issued by the University of California Radiation Laboratory discussing an experiment in which a system was designed and built to load titanium with deuterium gas of a high purity. It discusses the results and the parameters affecting the amounts and purity of the absorbed gas.

The following report describes the charged secondary particles from all presently known decay modes of positive K mesons that have been identified, and the masses of the primaries measured by the momentum-range method.

The following document analyzes one hundred and seventy-seven bevatron tau mesons for Q value of the tau decay, tau spin and parity, and possible polarization effects.

Abstract: "A simple solution to Saha's equation has been obtained. The method of solution involves iteration with respect to the electron pressure or concentration and can be applied to the simultaneous calculations of any number of ions. Sample results are given for lithium and aluminum."

Abstract: "The cross section for this reaction is calculated for three Hulthen deuteron wave functions. A hard core in the deuteron at one-half meson Compton wavelength reduces the total cross section and flattens the angular distribution in the backwards direction in agreement with experiment."

Abstract: "The distribution ratios and equilibrium constants for the extraction of zirconium and hafnium from 4 M perchloric acid with various combinations of fluorinated [beta]-diketones and organic solvents have been determined. The separation factors K'Zr/K'HF, found for this acidity were: Z-thenoyltrifluoroacetone in benzene, 25; Z-thenoyltrifluoroacetone in o-dichlorobenzene, 16; benzoyltrifluoroacetone in benzene, 18; isovaleroyltrifluoroacetone in benzene, 13; isovaleroyltrifluoroacetone in n-hexane, 13."

As there is no accurate measurements of the energy distribution of neutrons emerging from large uranium blocks, it becomes of importance to see how much information of this kind can be derived from the slowing down distribution of the neutrons in a water tank.

Secondary charge effects from a 10 kilovolt proton beam and their effect upon beam current measurement are investigated. A collector is designed for beam current metering of a 60 kilovolt proton beam by means of charge measurement and energy measurement.

The phase shifts for proton-proton scattering as calculated from the one-pion exchange contribution (OPEC) alone are of some interest because they describe the scattering correctly in the high angular momentum states, and because in the lower angular momentum states the deviation from the OPEC phases is an indication of the strength of the two-pion and higher exchanges processes. The attached table gives the proton-proton nuclear-bar phase shifts as calculated from OPEC. Phase shifts and mixing parameters are given in degrees, as function of the T, the laboratory kinetic energy of the incoming protons in Mev. Phase shift and mixing parameters are listed in the angular momentum states.

Abstract. Results are presented of a theoretical study to calculate the [alpha]/[beta] ratio of filter-collected natural airborne radioactivity. The detection of airborne plutonium contamination by noting increases in this [alpha]/[beta] ratio is discussed. A modification of this approach which provides a more uniform response to alpha airborne contamination is described.

The ANGIE, one of a series of reactor neutronic programs for an IBM 709 or 7090 data processing system, solves the time-dependent, multi-group, neutron diffusion equation for 1 to 26 energy groups applied to a rectangular mesh superimposed on either an x-y or an r-z plane.

A repeatable technique for preparation of thin, self-supporting copper films has been developed at the Lawrence Radiation Laboratory in Livermore, California. The process, done in a vacuum chamber, involves evaporation of copper by electron bombardment, and deposition of the copper on a detergent-coast glass substrate. The copper film is later removed from the substrate by immersion in water.

Based on the assumption that the noise contribution of a semiconductor detector is due solely to the bulk properties of the semiconductor, equations are presented which indicate the theoretical limits of noise in detector-amplifier combinations. These equations show that an optimum amplifier time constant and detector bias voltage exist for which condition the minimum noise is independent of the semiconductor resistivity. The optimum performance of a detector-amplifier system is shown to depend only upon detector area, input capacity (less detector capacity), semiconductor minority carrier lifetime, and the transconductance of the amplifier input tube. A new detector structure including a guard-ring electrode as an integral part of the detector structure is described which largely eliminates noise due to surface leakage. Experimental results for detector leakage and energy resolution are presented which agree well with theory.

Summary of the research progress meeting of June 12, 1952

Recent studies on the separation of cobalt and nickel and on the behavior of iron in hydrochloric acid on Dowex-1 resin in relation to the selective adsorption of chloride complexes of these elements have suggested the use of resin for the separation of iron and cobalt.