The following report is based on the observations made during a visit to the Oak Ride National Laboratories of their Redox Pilot Plant equipment.

Summary: "Criticality was considered impossible in any contingency encountered in practice under either of the following conditions which include no safety factor: (a) In any isolated cylinder not more than 5 in. in disruptor, if the total amount of U235 present does not exceed 7.5 Eg. (b) In an isolated vessel of any shape and size, if the total amount of U235 present does not exceed 880 g. An "isolated" vessel is one which does not "see" more than 0.1 [...] other vessels containing fissionable material."

Report discussing a method of rear face monitoring by television as a form of visual contact and communication between Hanford Works crews. A conclusion and recommendation of the method is given as well as an explanation of necessary materials.

Summary: "Six different types of solutions of various concentrations were used to deoxidize uranium chips on a laboratory scale. None of the solutions tested appears to be more desirable than 50% nitric acid for deoxidizing uranium chip on a production scale."

The following report describes a countercurrent extraction column, which employs timed solenoid valves and pressurized feeds to provide a pulsing action to disperse the phases. This report further describes the 4-stage cycle of the column operation.

Five continuous coatings were produced on zirconium coupons using an anodizing technique. These layers appear to be quite adherent and not subject to visible or audible failure caused by flaxion of the basis metal, Their abrasion resistance, though not investigated thoroughly, appears to be moderately good.

Thirty gram patches of plutonium dioxide can be readily chlorinated by reaction with phosgene or carbon tetrachloride at temperatures of 350 and 450 C respectively. Plutonium trichloride prepared by either method can be reduced to the metal in a hermetically sealed bomb by reaction with calcium. On a twenty gram scale yields of approximately 97 per cent are obtained when a calcium-iodine booster is employed. It has been demonstrated that a method for reduction of plutonium trichloride to the metal without the use of a booster can be development.

Automatic sample changer developed to increase the number of samples that can be handled daily.

Organic compounds have been considered for use as reactor coolants for two primary reasons. First, the high boiling points of the compounds would permit the reactor to operate at high temperature without the need for the high pressure required when water is used as a coolant. Secondly, the compounds are less corrosive than water and would permit the use of carbon steel rather than stainless steel components in the reactor. Unfortunately, the organic compounds proposed for use as reactor coolants have a greater tendency to leak than water and are thus more difficult to seal. A development program was established to evaluate the types of closures required to produce a leak-tight system. This report presents the results of the evaluation. Two proposed coolant compounds, monoisopropylbiphenyl (MIPB) and the eutectic mixture of 55 per cent ortho terphenyl, 25 per cent biphenyl, and 20 per cent meta terphenyl were used.

At the request of 234-5 Development, studies of a system for controlling plutonium powder transfer were undertaken by Process Equipment Development. This report presents details of equipment designed to fulfill requirements and proposes equipment for installation on additional Hot Button Line prototypes.

Primary control of the PRTR is achieved by regulating the level of the heavy water moderator which is held in the reactor vessel by a helium gas balance system. Emergency shutdown is effected by a gas-balanced moderator dump system which drain the moderator from the calandria at a rapid rate. This report presents a quantitative appraisal of the reactivity effects due to moderator level changes in controlling or scramming the reactor. In conjunction with the reactivity calculations, solutions were obtained which yield an evaluation of vertical flux or power distributions for any positioning of the moderator level. Coupled with the radial distributions for a given fuel loading, this information is useful in obtaining the value of the maximum specific power associated with a given power of operation and moderator height. The calculations were made using VALPROD, a one dimensional, multigroup diffusion theory reactor code programmed for the IBM-650 computer.