"An investigation was conducted to determine the electric power requirements necessary for ice protection of inlet guide vanes by continuous heating and by cyclical de-icing. Data are presented to show the effect of ambient-air temperature, liquid-water content, air velocity, heat-on period, and cycle times on the power requirements for these two methods of ice protection. The results showed that for a hypothetical engine using 28 inlet guide vanes under similar icing conditions, cyclical de-icing can provide a total power saving as high as 79 percent over that required for continuous heating" (p. 1).

Report presenting an investigation of the effect of two wing sections and a tip tank on the aerodynamic characteristics of a rigid unswept wing in the high-speed tunnel over a Mach number range of 0.60 to 0.90. Results regarding the effect of original airfoil sections, effect of modifications to Section B, effect of tip tank, and characteristics of the tip tank in the presence of the wing are provided.

Report presenting a rocket-powered model of the X-3 configuration flown through a range of Mach numbers to determine the response of the model to rapid deflections of the horizontal tail and its effects on lift, drag, longitudinal stability and control, and longitudinal-trim change. The model was found to remain statically and dynamically stable through the lift-coefficient and Mach number range of the test.

Report presenting the results of an experimental wind-tunnel investigation of the damping in pitch of two triangular wings having leading edges swept back 45 degrees are presented. The wings differed only in airfoil section. Results regarding the damping coefficients, aeroelastic effects at supersonic speeds, Reynolds number effects, and application of the results to the prediction of the dynamic behavior of full-scale aircraft are provided.

Report presenting an investigation of the lift, drag, pitching-moment, and downwash characteristics of a triangular wing of aspect ratio 3 with an NACA 63A006 section. Downwash was measured by using an all-movable horizontal tail at five locations. Results regarding basic wing characteristics and stability contribution of the tail are also provided.

Report presenting an investigation of the overall performance of a 20-inch-tip-diameter, eight-stage axial-flow compressor conducted as the initial step in an investigation of the problems encountered in a high-pressure-ratio axial-flow compressor with transonic inlet stages. The investigation was made over a range of weight flows at equivalent speeds from 30 to 100 percent of design speed. Results regarding the overall performance, stage performance, comparison with design, and engine application are provided.

Report presenting visual-flow studies made of the behavior of the vortices which form in the separated flow region in the lee of an inclined body of revolution. Generally, the configuration of vortices in the wake could be changed by varying the position of the crossflow separation lines along the sides of the body. Results regarding the effects of body expansion, effect of body cross-sectional asymmetry, Reynolds number effects, and effects of vortex configuration on body forces are provided.

This report details a study that was conducted by the U.S. Naval Air Development Center to "determine the feasibility of several airborne magnetic mine-sweeping methods. The advantages of a satisfactory airborne method are greater safety and speed than are possible with existing surface methods." The configurations and results of the double Q-sweep, the modified double-catenary sweep, and the M-sweep are examined.

Flight tests were made of six noninstrumented rocket-powered "Tin Can" models of AAF Project MX-800. Velocity and drag data were obtained by use of CU Doppler radar. The existence of stability and adequate structural strength for flight near zero lift was checked by visual and photographic observation. Drag data obtained during the tests agreed reasonably well with estimates based on experimental data from NACA RM-2 rocket-powered drag research models.

Memorandum presenting two nose inlets utilizing the boundary-layer separation ahead of a blunt body to provide a compression surface at Mach number 5.5. Results regarding the spherical-nose inlet, the planar-nose inlet, some operating characteristics, and a comparison with the single-conical-shock inlet are provided.