Abstract: "A method is described for the identification and quantitative determination of trace amounts of rare earths in graphite by measurement of the energies and decays of the activities induced by neutron irradiation. The specific rare earth elements identified are europium and samarium. During the development of this method, the half-lives of Eu-152 and Sm-153 were determined. These are reported as 9.32 +/- 0.04 hours and 46.34 +/- 0.23 respectively."

Report discussing several reactions that occur during the Redox process and involve hexone. Discussion of each reaction and experimental data is included.

The purpose of this program is to determine the effects of neutron radiation and reactor gaseous atmospheres on the structural integrity of candidate materials for the PRTR gas-cooled loop. An exploratory investigation is being conducted to select a high temperature resistant alloy for the fabrication of tubes and supporting appliances for the PRTR gas-cooled loop. In addition to a low neutron cross section, the material must be able to withstand the operating conditions outlined in Table 1.

Early in the U.S. gas-cooled reactor program, it was recognized that a considerable research and development effort would be needed to utilize the full potential of gas cooling. Hanford Laboratories contribution to this program began in August, 1958 when a graphite studies program was initiated. The primary objectives of the Hanford program are: (1) to secure improved knowledge of the reaction of gas coolants with protected and unprotected graphites over a range of conditions of practical interest for gas cooled power reactors with tolerable damage to the graphite moderator.

The attached survey information comprises a cross section of Air and Gas Cleaning Operations as used in the Chemical Processing Department at the Hanford Atomic Products Operation, Richland, Washington. Most of the information as requested by J. T. Fitsgerald, Harvard University, is included in these surveys, certain cost information was difficult to isolate in the manner requested and may, therefore, be only roughly approximate. The numerical significance of the data will indicate this in most instances.

In connection with the study of aqueous-tributyIphosphate (TBP) systems, the study of the interactions of various diluents with the TBP has been extended. The diluents used were mineral oil, Amsco 125-90W, dodecane, n-hexane, cyclohexane, benzene, n-octyl bromide, carbon tetrachloride, chloroform and pentachloroethane. The solubility of TBP in water from solutions of these diluents and the solubility of water in the organic phase was determined. For the paraffin hydrocarbons as diluents the solubility of TBP in water was found to increase with increasing molal volume of the diluent. No evidence for the formation of TBP-water complex of simple mole ration was found.

The computation of liquid-boiling heat exchanger performance under a wide variety of operating conditions is a cumbersome, time-consuming procedure. Rapid evaluation of a design requires the use of some form of computational aid. Exchanger equations covering the case of liquid-boiling heat transfer have been derived and evaluated for a specific correlation of local boiling condition. Examination of various data as presented by Bonilla and McAdams indicates that the boiling coefficients are not fully reproducible and appear to be sensitive to surface conditions, gases, geometry, etc. It therefore is believed advantageous to extend the reference analysis to cover a wide range of surface and pool boiling conditions. In this manner, the effects of potential errors in both boiling and liquid film coefficients may be investigated with minimum effort.