Report presenting an experiment regarding tank and float venting conditions that exist on diving airplanes undergoing rapid changes in altitude. The results indicated that large pressure differences build up between the outside and inside of tanks and floats on diving airplanes unless the correct size of venting tube is used.

Report presenting tests made in the variable-density wind tunnel of airfoils of the NACA 4400 series modified by reflex at the trailing edge designed to reduce the pitching moment to the value of -0.03. The modified airfoils are designated the NACA 4400R series.

"Recent developments in airfoil-testing methods and fundamental air-flow investigations, as applied to airfoils, are discussed. Preliminary test results, obtained under conditions relatively free from stream turbulence and other disturbances, are presented. Suitable airfoils and airfoil-design principles were developed to take advantage of the unusually extensive laminar boundary layers that may be maintained under the improved testing conditions" (p. 1).

Report presenting an investigation of the effects of propellers and of vibration on the extent of laminar flow on the NACA 27-212 airfoil by testing the airfoil in conjunction with a tractor and a pusher propeller and with a mechanical vibrator. The results show that neither the pusher propeller nor vibration with amplitudes up to 0.094 inch and with a frequency of 1650 cycles per minute had any consequential effect on the extent of laminar flow but that the tractor propeller had a very pronounced effect.

Report presenting an investigation of the drag and power cost associated with the changing of the nose of a nacelle from a streamline shape to a conventional cowling shape. Full-scale propellers and nacelles were used. The results of the tests showed that the streamline afterbody drag approached that of an airship form and that the added drag due to the open-nose cowling was only a quarter of the drag increase obtained with the other afterbody.

Report presenting flight and ground-cooling tests with a Northrop A-17A attack airplane to determine the merits of a nose-blower engine cowling designed and built at the NACA laboratory. The main objective was to determine the cooling characteristics of the nose blower, especially for ground and low-speed operation. Results regarding the cooling properties, engine pressure drop, and maximum speed and drag are provided.

Report presenting an investigation in the 20-foot wind tunnel to determine the drag, propulsive and net efficiencies, and cooling characteristics of several scale-model arrangements of air-cooled radial-engine nacelles and present-day propellers in front of an 18-percent-thick, 5-by-15-foot airfoil. Two 3-blade propellers with differing diameters were tested in conjunction with a 12-inch-diameter nacelle in three positions in front of the wing and with a 16-inch-diameter nacelle in six positions in front of the wing. Lift, drag, cooling-air flow, and propeller characteristics were determined for each arrangement.

Report presenting tests conducted on a steel cylinder barrel with aluminum fins in order to determine the heat-transfer coefficients of the cylinder and the excellence of the bond between the steel barrel and the aluminum fins. Results regarding the heat-transfer tests and physical tests are provided.

Report presenting tests of wing-fuselage combinations employing an airfoil-type fuselage in the variable-density wind tunnel as part of a wing-fuselage program. The models were designed to simulate an existing moderate-size transport airplane of that type. Results regarding some general comparisons, lift distribution and induced drag, and drag in high-speed flight are provided.

From Introduction: "This report presents the results of these tests which cover a total of about 70 flying hours on this airplane."

Report presenting a study of comparable information on full-scale spinning results and NACA free-spinning wind-tunnel results in order to determine the degree of reliability of tunnel results in predicting the spinning behavior of airplanes. Satisfactory agreement between model and airplane was found in 16 instances and disagreement was found in 5 instances.

Report presenting a consideration of the general problem of stalling as affecting the safety of airplanes. The increased difficulties associated with modern efficient wings, particularly highly tapered wings and high-life devices, are discussed and means are considered for avoiding these difficulties.

Report presenting an investigation of the size and distribution of ice particles on the wings of aircraft and how they affect the aerodynamic characteristics. A simulated ice formation was generated from survey information received from aircraft pilots and was tested to determine the impact on the lift characteristics.

From Introduction: "An investigation has been conducted in the N.A.C.A. full-scale wind tunnel to determine the aerodynamic characteristics of a 1/4-scale model of a 4-engine monoplane when equipped with comparable air-cooled engine and liquid-cooled engine installations. The air-cooled engine installation consisted of nacelles equipped with N..A.C.A. cowlings and oil coolers located in the leading edge of the wing."

Report presenting testing in the full-scale wind tunnel on a model of a large 4-engine monoplane to determine the overall aerodynamic efficiency of a conventional wing-nacelle-engine installation as compared with power-plant installations enclosed in the wing with extension shafts to the propellers. Results regarding power-on and power-off performance for the installations as well as propeller noise are provided.