This thesis presents a novel ZnO-hydrogel based fluorescent colloidal semiconductor nanomaterial system for potential bio-medical applications such as bio-imaging, cancer detection and therapy. The preparation of ZnO nanoparticles and their surface modification to make a biocompatible material with enhanced optical properties is discussed. High quality ZnO nanoparticles with UV band edge emission are prepared using gas evaporation method. Semiconductor materials including ZnO are insoluble in water. Since biological applications require water soluble nanomaterials, ZnO nanoparticles are first dispersed in water by ball milling method, and their aqueous stability and fluorescence properties are enhanced by incorporating them in bio-compatible poly N-isopropylacrylamide (PNIPAM) based hydrogel polymer matrix. The optical properties of ZnO-hydrogel colloidal dispersion versus ZnO-Water dispersion were analyzed. The optical characterization using photoluminescence spectroscopy indicates approximately 10 times enhancement of fluorescence in ZnO-hydrogel colloidal system compared to ZnO-water system. Ultrafast time resolved measurement demonstrates dominant exciton recombination process in ZnO-hydrogel system compared to ZnO-water system, confirming the surface modification of ZnO nanoparticles by hydrogel polymer matrix. The surface modification of ZnO nanoparticles by hydrogel induce more scattering centers per unit area of cross-section, and hence increase the luminescence from the ZnO-gel samples due to multiple path excitations. Furthermore, surface modification of …

Dallas is the third largest growing industrialized city in the state of Texas. the prevailing air quality here is highly influenced by the industrialization and particulate matter 2.5µm (PM2.5) has been found to be one of the main pollutants in this region. Exposure to PM2.5 in elevated levels could cause respiratory problems and other health issues, some of which could be fatal. the current study dealt with the quantification and analysis of the sources of emission of PM2.5 and an emission inventory for PM2.5 was assessed. 24-hour average samples of PM2.5 were collected at two monitoring sites under the Texas Commission on Environmental Quality (TCEQ) in Dallas, Dallas convention Centre (CAMS 312) and Dallas Hinton sites (CAMS 60). the data was collected from January 2003 to December 2009 and by using two positive matrix models PMF 2 and EPA PMF the PM2.5 source were identified. 9 sources were identified from CAMS 312 of which secondary sulfate (31% by PMF2 and 26% by EPA PMF) was found to be one of the major sources. Data from CAMS 60 enabled the identification of 8 sources by PMF2 and 9 by EPA PMF. These data also confirmed secondary sulfate (35% by PMF2 and …

While conventional turbines have been extensively researched and tested, Tesla and boundary layer type turbines have not. In order to construct a dynamometer, thermodynamic flow apparatus and future turbines, we modeled the Tesla turbine using theoretical calculations and preliminary experiments. Thus a series of experiments were run to determine stall torque and maximum run speed for a known pressure range. This data was then applied to modeling formulas to estimate stall torque over an extended range of variables. The data were then used to design an appropriate dynamometer and airflow experiment. The model data also served to estimate various specifications and power output of the future turbine. An Obi Laser SSTG‐001 Tesla turbine was used in the experiments described. Experimental stall torque measurements were conducted in two stages. Shaft speed measurements were taken with an optical laser tachometer and Tesla turbine stall torque was measured using a spring force gauge. Two methods were chosen to model Tesla turbine stall torque: 1) flow over flat plate and 2) free vortex with a sink. A functional dynamometer and thermodynamic apparatus were constructed once the model was confirmed to be within the experimental uncertainty. Results of the experiments show that the experimental turbine …