Note presenting an experiment to obtain information regarding the relationship between the coefficients for flow in the two directions through an inlet. The results indicate that the ratio of the orifice discharge coefficient from standard orifice to the discharge coefficient from reverse flow is always less than unity, but approaches unity with increasing ratio of box area to orifice area, and that even for a ratio of areas as low as twenty the ratios of the coefficients is not much less than unity.

Report discussing the progress of airplane performance and measured by speed.

Note presenting methods for ascertaining the value of n in Euler's simplified formula, which can be used for the compressive strength of tapered airplane struts, by estimating from curves and by calculation.

This report presents the results of an investigation undertaken to determine the feasibility of making glide landings in gusty air. Wind velocities were measured at several stations between the ground and a height of 51 feet, and flight tests were made to determine the actual influence of gusts on an airplane gliding close to the ground.

Report discussing the 6-foot-4-inch wind tunnel and its auxiliary equipment has proven itself capable of continuous and reliable output of data. The real value of the tunnel will increase as experience is gained in checking the observed tunnel performance against full-scale performance. Such has been the case of the 8- by 8-foot tunnel, and for that reason the comparison in the calibration tests have been presented.

This report is a revision of the altitude pressure tables of the United States standard atmosphere given in Technical Report No. 246 and the altitude range has been extended from 50,000 to 80,000 feet.

Report presents the results of tests conducted at Stanford University of a 3-foot model propeller at four pitch settings and at 0 degree, 10 degrees, 20 degrees, and 30 degrees yaw.

The following report discusses an investigation that was made to determine the tensile and the compressive properties of a large number of 24ST extruded shapes selected at random from commercial production in order to investigate the interrelation of these properties.

From Introduction: "An apparatus that gives a quick and an accurate measurement of the rate of discharge has been has been designed by the NACA and is described in this report."

"The data presented in this report are part of a general program to determine the effects of xylidines on the knock-limited performance of currently used aviation fuels" (p. 2).

From Introduction: "The purpose of this analysis was to investigate the use of function of intake-manifold temperature and pressure, exhaust back pressure, and engine speed in place of a ventri as a means of measuring engine air consumption and to determine if this function is suitable for automatic mixture control."

From Introduction: "The purpose of this analysis was to investigate the use of a function of intake-manifold pressure, exhaust back pressure, intake manifold temperature, and engine speed in place of a venturi as a means of measuring engine air consumption and to determine if this function is suitable for automatic mixture control."

From Introduction: "This report presents only that portion of the data from the first ditching which was to be used roughly establish the accelerations experienced by the pilot and the amount of water pressure to which the fuselage structure was subjected during the ditching."

"There are several constants which have been devised as numerical representations of the behavior of metals under the action of loadings which stress the metal within the range of elastic action. Some of these constants, such as Young's modulus of elasticity in tension and compression, shearing modulus of elasticity, and Poisson's ratio, are regularly used in engineering calculations. Precise tests and experience indicate that these elastic constants are practically unaffected by many of the factors which influence the other mechanical properties of materials and that a few careful determinations under properly controlled conditions are more useful and reliable than many determinations made under less favorable conditions" (p. 1).

From Introduction: "The research program included clean-up tests (unpublished data) and stability and control tests (reference 1) made in the NACA Langley full-scale tunnel. An investigation of the aerodynamic characteristics of the power-plant installation in the Cleveland altitude wind tunnel is discussed in this report."

From Introduction: "The difficulties experienced in cooling the exhaust-valve seats of the rear-row cylinders have been overcome to a considerable extent by improving the mixture distribution through application of the injection impeller (reference 1) and by augmenting the flow of cooling air to the critical baffles (reference 2). Flight tests of this airplane (reference 3) indicated that the temperatures of exhaust-valve seats on rear-row cylinders were markedly lowered by these modifications and that airplane range, altitude, and gross weight previously limited by these temperatures could be greatly increased."

From Introduction: "The present report has been prepared to discuss the indications obtained from the University of Chicago turbulence indicator in relation to simultaneous measurement of atmospheric gustiness made by the NACA, which are summarized herein."

From Introduction: "The present report is the second prepared to give the results of an analysis of V-G data from commercial transport airplanes. The present report is concerned with an analysis of data obtained with Douglas DC-3 airplanes flying over three transcontinental routes in the United States."

"The results obtained from an evaluation for gust and draft velocities of acceleration and airspeed-altitude records taken by NACA recording instruments installed in P-61c airplanes participating in thunderstorm flights 6, 7, and 8 of July 9, 1946, July 10, 1946, and July 11, 1946, respectively, are presented herein. These data are summarized in tables I and II. In accordance with a recent discussion with a member of the U.S. Weather Bureau staff, the tabulated results for the present flight include in addition to data of the type presented in reference 1, the initial heading of the airplane for each traverse, the pressure altitude at the start of each traverse in increments of 500 feet, and the gust gradient distance when it could be evaluated" (p. 1).

This report presents the results obtained from gust and draft velocity measurements within thunderstorms for the period August 7, 1946 to August, 13, 1946 at Orlando Florida. In several of the surveys, indications of ambient air temperature were obtained from photo-observer records. These data are summarized in the report.

From Introduction: "Experimental investigations (reference 1) have shown that in some cases the thrust can be more than doubled by means of tail-pipe burning. A comparison is made of a standard turbojet engine, whose thrust is augmented by tail-pipe burning, and a ram-jet engine. The performance characteristics for the ram-jet engine were computed entirely from theoretical considerations and on the assumption that the burner-inlet velocity was constant."

From Summary: "This report presents the aerodynamic measurements made during a Navy investigation conducted in the Langley 8-foot high speed tunnel to determine the actual human tolerance to wind blasts."

The results obtained from gust and draft velocity measurements within thunderstorms for the period July 24, 1946 to August 6, 1946 at Orlando, Florida are presented herein. These data are summarized in tables I and II and are of the type presented in reference 1 for previous flights. In two thunderstorm traverses, indications of ambient-air temperature were obtained from photo-observer records. These data are summarized in table III.

From Summary: "These properties compare favorably with those of the strongest similar alloys previously investigated. However, compared with a 60Cr-25Fe-15Mo alloy, the three cobalt-chronium-nickel cast alloys are inferior. A correlation of NACA and OSRD (Project NRC-8) data is presented, showing the variation of rupture strengths with temperature in the range of 1350^o to 2000^o for alloys."