An experiment was designed utilizing a charge-exchange reaction to study the decay and interactions of the neutral K mesons produced. The experiment produced no events that could be interpreted as either the decay or interaction of neutral K mesons. The nature of the experiment and the possible explanations of this unexpected result are presented in this paper.

The calculation of shielding the thickness for plutonium is complicated by the many different energies represented in the gamma radiation emitted during decay of the plutonium isotopes. Dose rate predictions are also frequently confused by gamma from varying content of fission product impurities in the plutonium, as well as other gamma radiation induced through alpha and neutron particle absorption within the source material or its environment. After assumptions are made for these many factors the radiation data for shielding determination is still frequently inadequate because of wide variations in dose rates resulting from self-absorption. The degree if self-shielding is in turn dependent on nature of the plutonium compound, degree of compactness, weight, and over-all geometrical distribution of the source material. By preparing a variety of plutonium samples representing combinations of these varying factors, actual dose rates and gamma spectra, as obtained from them, can then be extrapolated for application to specific situations.

The following document describes the usage and purpose of the neutron diffusion theory reactor program 9-Zoom, a memory-contained program that takes advantage of 709 features such as, for example, preferential order of multiply by zero, and for small problems approaches input-output limitations with excellent convergence properties.

A multi-purpose program for processing exponential data has been prepared for the 709 computer. The main purposes of the program is to compute the material buckling from raw data (given counts, time, and counter information) or from previously calculated Athermal's. It is also possible to compute only CeCh (end and harmonic corrections) for a given B11 or series if B11's no counting data being entered. In every case, pile measurements must be submitted as input for corrections.

Water treatment systems for preparing and maintaining high purity water in out-of-reactor or in-reactor test oops are becoming increasingly important. In out0of-reactor experiments the presence of ionic impurities in the water has a marked influence on film formation and corrosion rates. It is therefore , imperative that these impurities be maintained at the lower practical concentration.

The purpose of the test was to determine the internal temperature of the valve position detector for the 1A reactor inlet hydraulic valve with the plant at normal pressure and temperature and at power. The normal operating temperatures for the valve position detector on the 1A reactor inlet hydraulic valve range from a minimum of 287 F to a maximum of 294.7 F.

The adsorption of acetic and oleic acids on the surface of thoria was studied by means of infrared spectroscopy. An infrared analysis of the adsorbates before and after adsorption using differential double bean methods indicated that the adsorption of organic acids on thoria surfaces occurs by an esterification reaction between the organic acid and the hydroxylated thoria surface. Ammonia vapor will not adsorb on thoria, indicated the basic character of the hydroxylated surface.

The attached list of publications is submitted as a year to year and final report of progress on work accomplished under Contract AT(11-1)-159 from 1950 to 1959. Work was initiated on this project in the spring of 1950 and is still in progress as of the date of this report.

The Non-Production Fuel Reprocessing Program involves the chemical processing of valuable reactor fuels received from privately owned power reactors. It is necessary therefore, to accurately measure the fuel material received in order to insure proper payment to reactor operator and to provide the Atomic Energy Commission with appropriate accountability data. The volume measurement study described herein was conducted in order to determine the limits of accuracy that could be obtained in measuring relatively large volumes of solution under plant processing conditions.

Technical report outlining experiments on aluminum-lithium alloys. From Abstract: "Aluminum-lithium alloys are subject to precipitation from solid solution, and may be age hardened by the same techniques used for more common aluminum alloys. Spherical particles of precipitate were observed with the electron microscope in 1.5% and 2.8% Al-Li alloys after aging for times comparable to those required to produce maximum hardness. Rod-shaped particles that were oriented parallel to either the (110) or the (111) planes of the aluminum matrix were observed in overaged specimens."

The following document was done under the auspices of the U.S. Atomic Energy Commission with the intention of analyzing air core cryogenic magnet coils and its usage in fusion research and high energy nuclear physics applications.

The following report is based on work performed under the auspices of the U.S. Atomic Energy Commission. The purpose of this report is to describe an air-core strong focusing synchrotron and its functions.

Disposal of liquid radioactive wastes to ground requires knowledge of the area ground-water hydrology. Information is desired on direction and velocity of ground-water flow. Direction of flow can be determined from maps showing contours on the water table surface, such contours being derived from well water elevations. Ground-water velocity is more difficult to ascertain.

This report is an amendment to the Preliminary Hazards Summary Report (1) and the Operating Procedures and Emergency Plans (5) for the Dresden Nuclear Power Station, submitted to the United States Atomic Energy Commission on September 3, 1957, and June 5, 1958, respectively.

Since the start of E-metal processing in December, 1958, critical mass control in the Redox dissolvers has been provided by a combination of administrative controls, revised dissolver charging procedures, and new dissolving processes and operation control procedures. These were all based on a maximum allowable charge of E-Metal to the dissolvers which was equivalent to 45 percent of the minimum critical mass.

This technical report constitutes a brief review of the work undertaken, entirely or in part, under the Contract AT(30-1)-1772 with eh United States Atomic Energy Commission. The work published during 1959 is listed at the end of this report and copies of the reprints or reports are attached where available. These investigations have been concerned with the examination of defect production and behavior as it may be observed by high frequency ultrasonic attenuation and velocity (modulus) changes in such materials as quartz, silicon, germanium, alkali halides (especially NaCl and XCl), high purity aluminum, and glass containing boron. The irradiations used are cobalt 60 gamma-ray irradiation and the reactor irradiation obtained in the Brookhaven National Laboratory graphite reactor.

Quantitative recovery of carrier‐free 10−9 M manganese (II) is possible from weakly acidic solutions. The use of lead dioxide as either a non-isotopic carrier or a chemical displacing agent makes possible high recoveries from more acidic solutions.

Report discussing the equations of the Debye-Huckel theory modified to include quantum statistics.

The program objective has been to investigate the possible similarity between a bond interface and a grain boundary. The criterion for establishing the similarity of a bond interface and a grain boundary was the migration characteristics of the boundary under the influence of controlled orientation, strain level, temperature and time. In addition, the orientation dependency of the "threshold", or minimum deformation, for bonding would have to be determined. The initial bonding studies were to be made by a "cold welding" technique; subsequently, elevated temperatures bonding would have been attempted. Migration of boundaries was to be observed by high temperature metallographic techniques.

Relatively long time cycles are required for the standard nitric acid dissolution of enriched uranium using safe batch size techniques for criticality control. Upwards of forty eight hours are required for the total dissolution of solid of I and E enriched slugs in nitric acid. The dissolution capacity may be increased by: (1) using a dissolver critically safe by virtue of its geometry or, (2)increasing the rate of uranium dissolution. Dilute agua regia -- a mixture of hydrochloric and nitric acids -- is known to dissolve uranium much more rapidly than nitric acid. This reports present a flowsheet for the rapid dissolution of uranium slugs in dilute agua regia.

In early July, 1958, it appeared that Columbia River temperature at HAPO would be near 24.5ºC by the end of August. River temperature were averaging 4º to 5º above 1957 figures and were 3º to 4º above the ten year highs. It seemed desirable to examine the problem to determine if any corrective measure could be taken, since it was apparent that production losses were imminent.

Attempts to secure a high degree of synchronization of cell division of the Krebs mouse ascites carcinoma, by combined use of aminopterin and citrovorum factor, and by use of colchicine and N-acetyl colchinol, were unsuccessful. In the course of the work, a new method for securing smears of ascites tumor cells was out, which we believe will be found useful

A preliminary evaluation of the autoclave corrosion behavior of a series of U-low C alloys and a series of U-low Zr alloys prepared by Fuels Fabrication Development Operation has been made. The corrosion testing was conducted by Coatings and Corrosion Operation by the experimental methods and procedure outlined in HW-61378.

Laboratory studies involving fluid flow through porous media require use of fluids having low dissolved gas content. Water is the major fluid used in various and box model and soil permeability studies carried out by the Geochemical and Geophysical Research group. Tap water supplied to the 222-U Bldg. contains a large amount of dissolved air. Under the reduced pressure encountered during model studies, the air is released from solution and gradually clogs the pores of the sand or other porous material. This, of course. leads to anomalous results and cannot be tolerated in precious studies. A system was required to effectively remove the air and make available a continuous supply of desired water for the model studies.