Report presenting a sample of data on atmospheric turbulence on Lockheed U-2 airplanes during research flights. The intensity, amount, and extent of atmospheric turbulence observed in the United States is in good agreement with data from England and Western Europe. Results regarding overall gust distribution, intensity of turbulence, percent of rough air, and size of turbulent areas are provided.

Document HW-33176, "A Proposed Scope of the 100-K Sulfuric Acid Addition Facilities", presented the justification and bases for a sulfuric acid addition facility at the 183-K headhouses and included a system for adding the acid to the raw water. Since the issue of this document several factors to consider in such a system have been brought to light by experience gained both at K and at other areas. The alternate system presented here eliminates several of the troublesome points in the previously proposed system.

An altitude-test-chamber investigation of a 28-inch-diameter ram-jet engine at a simulated flight Mach number of approximately 2.0 for altitudes of 40,000 to 50,000 feet was conducted at the NACA Lewis laboratory. Three different flame holders, varying in the number and size of the annular gutters, in conjunction with several fuel-injection systems were investigated. The combustion efficiency for the flame-holder fuel-injection system that provided the best over-all operational fuel-air-ratio range (0.03 to 0.075) was over 0.9 at a fuel-air ratio of about 0.065 for the altitude range investigated.

A wind tunnel investigation was conducted to determine the performance of a turbine operating as an integral part of a turbojet engine. Data was obtained while the engine was running over full operable range of speeds at various altitudes and flight mach numbers, and with four nozzles of different outlet areas.A maximum turbine efficiency of 0.875 was obtained at altitude of 15 thousand feet, Mach number 0.53, and corrected turbine speed of 5900 rpm.

Compressor performance properties for two 11-stage compressors of 3000-pound-thrust axial-flow turbojet engines were determined. Data are presented for a range of simulated altitudes and a range of Mach numbers for various modifications of the engine.

Combustion chamber performance properties of a 3000-pound-thrust axial-flow turbojet engine were determined. Data are presented for a range of simulated altitudes from 15,000 to 45,0000 feet and a range of Mach numbers from 0.23 to 1.05 for various modifications of the engine.

An investigation was conducted to evaluate the operational characteristics of a 3000 pound thrust axial flow turbojet engine over a range of simulated altitudes from 2000 to 50,000 feet and simulated flight Mach numbers from 0 to 1.04 throughout the operable range of engine speeds. Engine operating range, acceleration, deceleration, starting, altitude, and flight Mach number compensation of the fuel control system, and operation of the lubrication system at high and low ambient air temperatures were evaluated.

"An investigation has been conducted in the NACA Cleveland altitude wind tunnel to evaluate the performance and windmilling drag characteristics of an original and a modified turbojet engine of the same type. Data have been obtained at simulated altitudes from 5000 to 45,000 feet, simulated flight Mach numbers from 0.09 to 1.08, and engine speeds from 4000 to 12,500 rpm. Engine performance data are presented for both engines to show the effects of altitude at a flight Mach number of 0.25 and of flight Mach number at an altitude of 25,000 feet" (p. 1).

Report presenting a study of the application of Wiener filter theory to the design of a beam-rider guidance system operating in the presence of glint noise. The theory is then used to establish the theoretical lower limit of root-mean-square error and the corresponding desired transfer-function characteristics.

Report presenting a wind-tunnel investigation on two series of twisted and cambered wings, which were identical except for wing section, to compare the effects of NACA 4-digit and NACA 64A chordwise distributions of thickness on the longitudinal aerodynamic characteristics of the wings. Results regarding the low-speed results, high-speed results, and flow studies are provided.

Study conducted for the U. S. Army Reactors Branch of reactors for the irradiation of food.

The following report describes results from a study of three types of cement (Barytes, Brookhaven, and Portland) exposed in the ORNL Reactor for periods of seven and twenty-eight days.

Report wherein acid free uranyl nitrate hexahydrate was distributed into 4-1/2 percent TBP-Amsco 125-90W and combined with various concentrations of acid in order to study the distribution of uranium and hydrolysis effects.

From introduction: A subsurface exploration program was undertaken to investigate the concentration of uranium and vanadium in or near the base of the Shinarump member of the Chinle formation in the Flatirons locality, and to develop criteria whereby adjacent unexplored areas could be evaluated as to potential production capacity from study of geological and mineralogical features at the host rook outcrop. An earlier study of the area by C. G. Evensen of the U. S. Atomic Energy Commission had shown that geological conditions favorable to the accumulation of commercial uranium deposits were present in the Flatirons area.

This report presents the results of a flight investigation to determine the effect on the performance of a turbosupercharged engine of an exhaust-gas-to-air heat exchanger installed between the engine-exhaust collector ring and the turbosupercharger. The background, results, and discussion of the investigation are described.

Report discussing testing to determine the effects of control profile on the dynamic hinge-moment and flutter characteristics of a trailing-edge flap-type control. A conventional control and two control profile modifications were examined. Information about spring moments is also provided.

Report presenting an investigation in the 4- by 4-foot supersonic pressure tunnel to determine the effects of various external-store configurations on the longitudinal and lateral aerodynamic characteristics of a model of a 45 degree swept-wing fighter airplane. Results regarding accuracy and remarks on effects of stores are provided.

Memorandum presenting a flight investigation using pulse techniques to determine longitudinal and lateral dynamic stability characteristics of the D-558-II research airplane with particular reference to the jet exhaust effects of the rocket engine. Results regarding the longitudinal stability characteristics, and lateral stability characteristics are provided.

Memorandum presenting the effects of resin coating methods on some physical properties of laminates prepared with glass fabric, Fiberglas 181, and bonded with two commercial polyester resins. The resins used were Laminac 4126 and Selectron 5003. The resin coating methods used were roller coating, application of a dilute solution of resin, resin immersion, application of monomeric styrene, and vacuum impregnation.

Report presenting measurements of the skin temperature and surface pressure on a large-scale, highly polished nose with a relatively sharp-tipped 100 degree total-angle cone followed by a conical flare section of 10 degree half-angle. Heating on the forward 3.0 to 4.5 inches of the 100 degrees cone was generally lower than that on the rearward portion.

Report presenting an investigation of the hydrodynamic characteristics of a multijet water-based aircraft capable of supersonic speeds and with jet engines exhausting through the step. The step engine exhausts were found to considerably increase afterbody wetting and smooth-water resistance, but they had no significant effect on longitudinal stability. Results regarding spray characteristics, resistance and stability at constant speed, take-off stability, landing stability, and jet noise are provided.

A heat-transfer investigation was conducted with air flowing through an electrically heated Inconel tube having either a long-approach or a right-angle-edge entrance, an inside diameter of 0.402 inch, and a length of 24 inches over a range of Reynolds numbers up to 375,000 and average inside-tube-wall temperatures up to 2000 degrees R. Good correlation of heat-transfer data was obtained for both entrances, which substantiates work previously reported. A fair correlation of friction data was obtained for both entrances. The entrance configuration had little effect on the average heat-transfer and friction coefficients.

Report presenting an investigation of the aerodynamic characteristics of various configurations of the Republic F-105 at Mach numbers from 0.60 to 1.13. The primary focus of this report are the static lateral and directional stability and control characteristics of the model. Results regarding force and moment results, longitudinal characteristics, lateral and directional characteristics.

Report presenting an investigation to determine the lateral control characteristics of a 20-percent-chord flap-type aileron of various spans on a semispan wing-fuselage model in the transonic speed range. The wing of the model had 45 degrees of sweepback, an aspect ratio of 3.7, a taper ratio of 1.0, and an NACA 65A009 airfoil section parallel to the free stream.