Techniques for applying ab-initio calculations to the is of atomic spectra are investigated, along with the relationship between the semi-empirical and ab-initio forms of Slater-Condon theory. Slater-Condon theory is reviewed with a focus on the essential features that lead to the effective Hamiltonians associated with the semi-empirical form of the theory. Ab-initio spectroscopic parameters are calculated from wavefunctions obtained via self-consistent field methods, while multi-configuration Hamiltonian matrices are constructed and diagonalized with computer codes written by Robert Cowan of Los Alamos Scientific Laboratory. Group theoretical analysis demonstrates that wavefunctions more general than Slater determinants (i.e. wavefunctions with radial correlations between electrons) lead to essentially the same parameterization of effective Hamiltonians. In the spirit of this analysis, a strategy is developed for adjusting ab-initio values of the spectroscopic parameters, reproducing parameters obtained by fitting the corresponding effective Hamiltonian. Secondary parameters are used to "screen" the calculated (primary) spectroscopic parameters, their values determined by least squares. Extrapolations of the secondary parameters determined from analyzed spectra are attempted to correct calculations of atoms and ions without experimental levels. The adjustment strategy and extrapolations are tested on the K I sequence from K{sup 0+} through Fe{sup 7+}, fitting to experimental levels for V{sup 4+}, …

This report addresses the breeder reactor fuel fabrication development overview.

A design study of a closed loop test facility for eight-inch hot dirty gas valves is presented. The objective of the facility is to quality valves for use in coal gasifiers, combined cycle plants, and pressurized fluid bed combustors. Outline sketches and estimated costs are presented for the selected design.

Research into deuterium-from-protium isotope separation via both metal hydride chromatography and CO/sub 2/ laser multiple-photon dissociation (MPD) of trifluoromethane (CDF/sub 3//CHF/sub 3/) is discussed. Several new classes of alloy compositions, including Mg-rare earth, NiTi/sub x/, and (Ca+Ce,Zr,Ti)./sub 8//sup -/Ni/sub 4/Cu compounds, were evaluated for chromatograhic isotope separation; no tested alloy exhibited properties suitable for commercial deuterium separation. For deuterium separation by MPD of CDF/sub 3/, construction of a CO/sub 2/ laser system was completed that is capable of delivering either 2 nsec short pulses at a single wavelength or 200 nsec long pulses simulatneously at two different laser frequencies. The wavelength dependence of single-line multiple-photon dissociation probability of CDF/sub 3/ was measured, and is reported here. Deuterium separation by CO/sub 2/ laser photolysis of CDF/sub 3//CHF/sub 3/ near 10.3 ..mu.. using approx. 2 nsec pulses still appears to be a commercially viable process for heavy water production.

The laboratory facility for photochemical tritium separation research has been completed. Methods for synthesizing the mono-tritiated halogenated methanes have been developed. Notably, CTF/sub 3/ has been synthesized and spectrally analyzed. The CTF/sub 3/ vibrational frequencies are found to be in quite good agreement with earlier calculations.

The influence of laser pulse propagation on multiple-photon excitation of many-level absorbers, and the significance of SIRF for SF/sub 6/ dissociation are discussed.

The fluid motion in the cavity of a HYLIFE reactor was calculated for the two extreme cases of optically thin and thick lithium gas in the hot core. The distinction is important because in the optically thin case (emission approximation) a major fraction of the gas energy is re-radiated to the main fall, following the lithium implosion, whereas in the optically thick case (diffusion approximation) virtually none escapes. This, in turn, has a major influence on the impulse ultimately imparted to the reactor walls. The complete set of finite difference equations used is given in an appendix.

These notes present a brief survey of some of the current diagnostic techniques used in magnetic fusion plasma devices. To give an idea of the range of parameters and geometries encountered the parameters of four representative experiments - PLT, TMX, ZT-40 and EBT-I(S) - are given. The central issue of all experiments is to understand the flow of power which can be summarized by two volume integrated equations for the ions and electrons.

The subject program is primarily an exploratory and demonstration study of the use of silicate glass-based adhesives for bonding silicon-base refractory ceramics (SiC, Si/sub 3/N/sub 4/). The projected application is 1250 to 2050/sup 0/F relaxing joint service in high-performance energy conversion systems. The five program tasks and their current status are as follows. Task 1 - Long-Term Joint Stability. Time-temperature-transformation studies of candidate glass adhesives, out to 2000 hours simulated service exposure, are half complete. Task 2 - Environmental and Service Effects on Joint Reliability. Start up delayed due to late delivery of candidate glass fillers and ceramic specimens. Task 3 - Viscoelastic Damping of Glass Bonded Ceramics. Promising results obtained over approximately the same range of glass viscosity required for joint relaxation function (10/sup 7.5/ to 10/sup 9.5/ poise). Work is 90% complete. Task 4 - Crack Arrest and Crack Diversion by Joints. No work started due to late arrival of materials. Task 5 - Improved Joining and Fabrication Methods. Significant work has been conducted in the area of refractory pre-glazing and the application and bonding of high-density candidate glass fillers (by both hand-artisan and slip-spray techniques). Work is half complete.

The paper discusses two treaties that are being negotiated: Multilateral Treaty, which bans all nuclear weapon tests and establishes a moratorium on PNEs (Peaceful Nuclear Explosions) for the life of the treaty, and a separate verification agreement, which provides for much more extensive verification measures that does the Multilateral Treaty and to which only the US, UK, and USSR will adhere. On the latter treaty, agreement has been reached that there will be improved seismic stations (NSS) in each country. Discussed are the outstanding general points of agreement or disagreement on NSS; technical characteristics of NSS; and a joint cooperative program for NSS.

Income, ethnicity, education, and occupation are examples of socio-economic factors associated with the occurrence of disease, whether an investigation focuses on an individual or on an aggregation of individuals. In this study, data aggregated to the county level are used to explore two issues - geographic variation and geographic covariation of ten selected causes of death in the United States. The counties of the United States are characterized by 15 socio-economic variables and age-adjusted mortality rates for the ten selected causes of death. The observed variation among the US counties, as measured by the socio-economic variables, is first assessed, then the geographic variation and covariation are described for each cause of death and, finally, the covariation among causes of death is analyzed after adjusting for the influences of the measured sources of county variation.

A technique is described for fabricating minature, high-density capsules of curium-244 oxide contained in three concentric jackets of metallic gold (or silver), with the outer surface being free of alpha contamination. The completed capsules are right circular cylinders 0.2500-inch diameter and 0.125-inch tall, with each level of containment soldered (or brazed) closed. A typical capsule would contain approx. 70 mg of /sup 244/Cm (5.7 Ci) mixed with 120 mg of gold powder in the form of a cermet wafer clad in three concentric, 0.010-inch thick, liquid tight jackets. This method of fabrication eliminates voids between the jackets and produces a minimum size, maximum density capsule. Cermet densities of 11.5 g/cc were obtained, with an overall density of 17.3 g/cc for the finished capsule.

We are using a transponding geostationary satellite to collect surface environmental data to describe the fate of soil-borne radionuclides. The remote, former atomic testing grounds at the Eniwetok and Bikini Atolls present a difficult environment in which to collect continuous field data. Our land-based, solar-powered microprocessor and environmental data systems remotely acquire measurements of net and total solar radiation, rain, humidity, temperature, and soil-water potentials. For the past year, our water flux model predicts wet season plant transpiration rates nearly equal to the 6 to 7 mm/d evaporation pan rate, which decreases to 2 to 3 mm/d for the dry season. Radioisotopic analysis confirms the microclimate-estimated 1:3 to 1:20 soil to plant /sup 137/Cs dry matter concentration ratio. This ratio exacerbates the dose to man from intake of food plants. Nephelometer measurements of airborne particulates presently indicate a minimum respiratory radiological dose.

This volume contains appendices of the following: US Geological Survey Arctic operating orders, 1979; Det Noske Vertas', rules for the design, construction and inspection of offshore technology, 1977; Alaska Oil and Gas Association, industry research projects, March 1980; Arctic Petroleum Operator's Association, industry research projects, January 1980; selected additional Arctic offshore bibliography on sea ice, icebreakers, Arctic seafloor conditions, ice-structures, frost heave and structure icing.

This manual is intended to serve several purposes. The first goal is to describe the capabilities and operation of the SMC processor package from an operator or user point of view. Secondly, the manual will describe in some detail the basic hardware elements and how they can be used effectively to implement a step motor control system. Practical information on the use, installation and checkout of the hardware set is presented in the following sections along with programming suggestions. Available related system software is described in this manual for reference and as an aid in understanding the system architecture. Section two presents an overview and operations manual of the SMC processor describing its composition and functional capabilities. Section three contains hardware descriptions in some detail for the LLL-designed hardware used in the SMC processor. Basic theory of operation and important features are explained.

Stimulated Raman scattering is of concern to laser fusion since it can create a hot electron environment which can increase the difficulty of achieving high final fuel densities. In earlier experiments with one micron laser light, the energy measured in Raman-scattered light has been insignificant. But these experiments were done with, at most, about 100 joules of laser energy. The Raman instability has a high threshold which also requires a large plasma to be irradiated with a large diameter spot. Only with a long interaction length can the Raman-scattered light wave convectively grow to a large amplitude, and only in recent long pulse, high energy experiments (4000 joules in 2 ns) at the Shiva laser facility have we observed as much as several percent of the laser light to be Raman-scattered. We find that the Raman instability has a much lower intensity threshold for longer laser pulselength and larger laser spot size on a solid target.

Lawrence Livermore National Laboratory has developed and tested for the United States Nuclear Regulatory Commission a procedure for the evaluation of Material Control and Accounting (MC and A) Systems at Nuclear Fuel Facilities. This procedure, called the Structured Assessment Approach, SAA, subjects the MC and A system at a facility to a series of increasingly sophisticated adversaries and strategies. A fully integrated version of the computer codes which assist the analyst in this assessment was made available in October, 1979. The concepts of the SAA and the results of the assessment of a hypothetical but typical facility are presented.

Experimental and theoretical studies of field reversal in a mirror machine are reported. Plasma-gun experiments demonstrate that reversed-field plasma layers are formed. Low energy plasma flowing behind the initially produced plasma front prevents tearing of the layer from the gun muzzle. MHD simulation shows that tearing can be obtained by impeding the slow plasma flow with a plasma divider. It is demonstrated theoretically that a field-reversed mirror imbedded in a multipole field can be sustained in steady state with neutral-beam injection even in the absence of impurities. MHD stability analysis shows that growth rates of elongated reversed-field theta-pinch configurations decrease with axial extension, which indicates the importance of including finite Larmor radius in the analysis. Tilting-mode criteria are improved by proper shaping, and a problimak shape is proposed. Tearing mode stability of reversed-field theta-pinches is greatly enhanced by flux exclusion. Self-consistent, 1-1/2-dimensional transport codes have been developed, and initial results are presented.

Layered synthetic microstructures have been built and tested for use as medium-resolution x-ray diffraction monochromators, in the 1 to 10 angstrom wavelength region. They can be employed to good advantage in spectrometry and imaging instruments that are used to determine the nature of the x-ray emission of high-temperature plasmas. When the micro-structures are used in spectrometers, we find that they gather much more light than natural crystals and are not troubled by high order diffraction response, yet have better spectral resolution than that provided by spectrometer channels formed by Ross filter or filter/fluorescer techniques. For use in imaging instruments such as the grazing-incidence reflection Kirkpatrick-Baez microscope, the microstructures provide high reflectivity at wavelengths shorter than the practical limit of total external reflection. We will present calibration data that describes the diffraction properties and piece-to-piece uniformity of microstructures built especially for use in the 1 to 10 angstrom region. We will also describe in detail two instruments that will be used at the Shiva laser system to determine the spectral and spatial distributions of x-rays radiated by inertial confinement fusion targets.