From Introduction: "The wings were tested in combination with fuselage similar to the one used in the 7- by 10-foot wind-tunnel investigations. The results are reported herein and are compared with results for three similar model wings on the transonic bump (references 1, 2, and 3)."

From Introduction: "In the present report, the results for the wings and bodies of revolution alone are first analyzed in comparison with exiting theory."

"An investigation was conducted to determine the longitudinal- and lateral-stability characteristics of a 0.5-scale model of the Fairchild Lark missile. The model was tested with 0 deg and with 22.5 deg of roll. Three horizontal wings having NACA 16-009, 16-209, and 64A-209 sections were tested. Pressures were measured on both pointed and blunt noses" (p. 1).

"Tests have been made in the Langley 4- by 4-foot supersonic pressure tunnel at Mach numbers of 1.41, 1.61, and 2.01 of various arrangements of a 0.04956-scale model of the Convair F-102A airplane with faired inlets. Tests made of the model equipped with a plain wing, a wing with 6.4 percent conical camber, and a wing with 15 percent conical camber. Body modifications including an extended nose, a modified canopy, and extended afterbody fillets were evaluated" (p. 1).

"Tests have been conducted in the Langley 8-foot transonic tunnel on a 0.04956-scale model of the Convair F-102A airplane which employed an indented and extended fuselage, cambered wing leading edges, and deflected wing tips. Force and moment characteristics were obtained for Mach numbers from 0.60 to 1.135 at angles of attack up to 20 degrees. In addition, tests were made over a limited angle-of-attack range to determine the effects of the cambered leading edges, deflected tips, and a nose section with a smooth area distribution" (p. 1).

Report discussing testing of a scale model of the Convair F-102B to determine its aerodynamic characteristics at several Mach numbers. Four basic body modifications and two afterbody configurations were evaluated.The body modifications were all found to slightly reduce values of minimum drag, but did not cause a change in the static stability and lift-curve-slope values compared to the F-102A.

"The basic aerodynamic characteristics of a 0.04956-scale model of the Convair TF-102A airplane with controls undeflected have been determined at Mach numbers from 0.60 to 1.135 for angles of attack up to approximately 22 deg in the Langley 8-foot transonic tunnel. In addition, comparisons have been made with data obtained from a previous investigation of a 0.04956-scale model of the Convair F-102A airplane. The results indicated the TF-102A airplane was longitudinally stable for all conditions tested" (p. 1).

Report discussing testing on a model of the General Electric P-1 nuclear powerplant to determine its internal aerodynamic characteristics. The main purposes of testing were to measure the mass-flow distribution of air, to measure the total-pressure losses for the duct components and complete model, and to determine modifications necessary to attain the desired performance characteristics.

Memorandum presenting an investigation of the flow characteristics over a 6-percent-thick symmetrical circular-arc airfoil section with a 30-percent-chord trailing-edge flap at a Mach number of 6.90 and a Reynolds number of 1.65 x 10(sub 6). The model was tested over an angle-of-attack range of 0 to 16 degrees and a flap-deflection range of -16 degrees to 16 degrees. Results regarding pressure results and aerodynamic characteristics are provided.

From Introduction: "The investigation covered a range of Mach numbers from 0.66 to 1.12 and included measurements of angle of attack, pitching moment, normal force, and chord force. The drag at zero lift obtained in this investigation was reported in reference 1, but without the correction for tare of the end plate."

Report discussing testing on a 42 degree swept-back wing to determine its low-speed aerodynamic characteristics in pitch and yaw at high Reynolds numbers. The main effect of increasing the Reynolds number was delayed wing stalling to higher angles of attack. Roughness on the wing leading edge also had a large adverse effect on lift, drag, and pitching-moment characteristics at higher Reynolds numbers.

From Introduction: "The present paper presents the scale effect on the longitudinal aerodynamic characteristics, the aerodynamic characteristics in yaw, and the tuft studies for 0^o and 3.7^o yaw. The results of the effect of leading-edge and trailing-edge flaps on the aerodynamic characteristics of the wing will be presented in later reports."

Report discussing tests to determine the aerodynamic characteristics of a model of a 45 degree swept-wing fighter airplane and to determine the loads on attached stores and detached missiles. An investigation into aileron-spoiler effectiveness, aileron hinge moments, and the effects of wing modifications of aerodynamic characteristics was also carried out at various Mach numbers. Results are presented, but caution is provided in regards to extrapolating results from the model onto a full-scale aircraft.

Memorandum presenting an investigation in the Unitary Plan wind tunnel to determine the aerodynamic characteristics of a model of a 45 degree swept-wing fighter airplane, and to determine the loads on attached stores and detached missiles in the presence of the model. Results also included a determination of aileron-spoiler effectiveness, aileron hinge moments, and the effects of wing modifications on model aerodynamic characteristics. The results are presented with minimum analysis.

From Introduction: "Numerous tests of tip controls on delta wings at transonic and low supersonic speeds have shown that such configurations provide satisfactory rolling-moment effectiveness, and that the hinge can be controlled by proper location of the hinge line (ref. 1). The purpose of the present tests is to determine the characteristics of such a configuration at Mach number of 4.04 and a Reynolds number of 5.8 X 10^6, based on the wing mean aerodynamic chord."

From Introduction: "The purpose of this paper is to provide further information on the effects of Reynolds number on the aerodynamic characteristics of the wing of reference 1 as well as to provide load distributions for the wing at Mach numbers of 1.6 and 1.9."

From Introduction: "The present report is concerned with the characteristics of a body in the two-dimensional flow field of a circular-arc wing of rectangular plan form."

From Introduction: "In order to obtain some insight into the relative merits of canard and outboard-tail control systems at supersonic speeds, a preliminary investigation of a generalized canard and outboard-tail model has been conducted in the Langley 4- by 4-foot supersonic pressure tunnel at a Mach number of 2.01 and the results are presented herein."

"Pressure-distribution and force tests of a circular cylinder have been made in the Langley 11-inch hypersonic tunnel at a Mach number of 6.86, a Reynolds number of 129,000 based on diameter, and angles of attack up to 90 degrees. The results are compared with the hypersonic approximation of Grimminger, Williams, and Young and with a simple modification of the Newtonian flow theory. The comparison of experimental results shows that either theory gives adequate general aerodynamic characteristics but that the modified Newtonian theory gives a more accurate prediction of the pressure distribution" (p. 1).

Report presenting an investigation to determine the aerodynamic characteristics of a cruciform 70 degree delta-wing missile configuration with 70 degree delta canard control surfaces at M = 1.41 in the 4- by 4-foot supersonic pressure tunnel. Modifications to the configuration included variation of the body length and canard area and the substitution of a series of very small span wings for the cruciform delta wings and canard controls.

From Introduction: "The results of two phases of this investigation, presented in references 1 and 2, have indicated possible ways of reducing hull drag without causing large changes in aerodynamic stability and hydrodynamic performance."

"An investigation was made in the Langley 300 MPH 7- by 10-foot tunnel to determine the aerodynamic characteristics of a flying-boat hull of a length-beam ratio of 15 in the presence of a wing. The investigation was an extension of previous tests made on hulls of length-beam ratios of 6, 9, and 12; these hulls were designed to have approximately the same hydrodynamic performance with respect to spray and resistance characteristics. Comparison with the previous investigation at lower length-beam ratios indicated a reduction in minimum drag coefficients of 0.0006 (10 percent) with fixed transition when the length-beam ratio was extended from 12 to 15" (p. 1).

Report presenting an investigation at Mach number 1.61. to determine the aerodynamic characteristics of a full-span trailing-edge control on a 60 degree delta wing with and without a partial-span spoiler mounted on the wing just ahead of the control. Pressure distribution and hinge-moment measurements were made over a range of angles of attack and control deflection. Results indicated that regions of increase pressure due to flow separation ahead of the control at the larger control deflections and ahead of the spoiler exist.

Report discussing an investigation of the aerodynamic characteristics of a model of an escape capsule with and without stabilizing fins for a supersonic bomber-type airplane. Lift, drag, longitudinal and lateral stability characteristics, and photographs of the capsule model are presented.