Five continuous coatings were produced on zirconium coupons using an anodizing technique. These layers appear to be quite adherent and not subject to visible or audible failure caused by flaxion of the basis metal, Their abrasion resistance, though not investigated thoroughly, appears to be moderately good.

The results of this investigation indicate that maximum electric power generation can be obtained by selecting the turbine steam temperature within a range of plus/minus 30 degrees C. from an "idealized" steam temperature. This "idealized" steam temperature is shown to depend primarily on the maximum permissible uranium temperature. The minimum available condenser temperature and the temperature rise of the coolant in the pile effect the selection of the turbine steam temperature to lesser extent.

In connection with different seals for C & D equipment it appears advantageous that many parts could be made of rubber or other elastic polymers. However, data on the deterioration rate of these materials under irradiation are somewhat scant in the available literature. It appears that for neutrons and pure gamma radiation that a good grade of natural rubber stands up best in all the test reported and because the results of the neutron irradiation are so closely correlated with results from gamma it has been proposed that the principal source of damage is caused by secondary irradiation generated within the rubber by the neutrons.

The conventional volumetric micro-determination of phosphate depends upon the precipitation of phosphomolybdate, filtration and washing of the precipitate, and titration with standard base. The method is slow and tedious, subject to many interferences, and is not applicable to samples containing less than 1-2 mg of phosphate. Other weak acid anions, such as carbonate or acetate, interfere in the method. Strong acid anions, such as nitrate, sulfate, and chloride do not interfere.

The hydrogen contents of several types of fabricated uranium have been determined by a vacuum method and expressed in terms of ccH2/ccU. The data indicate that alpha-rolled metal contains about 0.25 ccH2(STP)/ccU whereas beta heat-treated uranium yielded values between 0.30 and 0.37 cc per cc. Restricted efforts were made to determine where in the heat treatment the 5 to 10 cc of hydrogen per slug were taken up. It appears that no one operation is wholly responsible for this additional gas, although reactions between beta heat treated surfaces containing microscopic defects, and nitric acid may possibly play a large role. In general it may be said that slug produced by powder metallurgical techniques contain less hydrogen than pieces produced by rolling and heat treatment.

Observations on sheep representing flocks in Utah adjacent to the Nevada Proving Ground were compared with findings made on experimental sheep exposed to various amounts of radioiodine. The Utah sheep showed no evidence of the radiation damage observed in experimentally treated sheep. Estimations of amounts of radioiodine on vegetation required to cause serious thyroid damage following a contamination event are included.