Report presenting an investigation in the 7- by 10-foot wind tunnel of an NACA 23012 airfoil with an 18.05-percent-chord Maxwell leading-edge slat and with a slotted and a split flap. The main purpose of the investigation was to determine the optimum slot gap of the Maxwell slat for, and the aerodynamic section characteristics of, the airfoil with several deflections of both types of flap.

Description is given of flight tests conducted on gun fairings, designed to correct the detrimental effects of the projecting and submerged wing guns on an F4F-3 fighter. It was found that the installation of unfaired guns on a clean wing resulted in a premature stall that increased the stalling speed in the carrier-approach and landing conditions of flight by suitably fairing the guns, it was possible to reduce the stalling speeds to values approaching very nearly the clean-wing values.

"An investigation of cowlings for long-nose radial engines was made on the Curtiss XP-42 fighter in the NACA full-scale wind tunnel. The unsatisfactory aerodynamic characteristics of all the cowlings with scoop inlets tested led to the development of the annular high-velocity inlet cowlings. Tests showed that ratio of cooling-air velocity at cowling inlet to stream velocity should not be less than 0.5 for this type of cowling and that critical compressibility speed can be extended to more than 500 mph at 20,000 ft altitude" (p. 1).

Report presenting an investigation of the effects of hub drag, solidity, dual rotation, and number of blades on the efficiency of high-pitch propellers. Testing occurred with two, three, four, and six-blade single propellers and four and six-blade dual-rotating propellers equipped with spinners and tested at a range of blade angles from 35 to 65 degrees. Results regarding a comparison of the large and small spinners, effects of spinners, comparison of constant-speed propellers, characteristics of constant-speed propellers, effect of solidity and dual rotation, effect of number of blades, and some peculiarities of four-blade propellers are provided.

Report presenting testing on elbow shapes in airplane carburetor air intake ducts with low losses and good velocity distribution without the use of turning vanes. Results regarding the flow coefficient, velocity distribution, and comparison of a variety of elbow ducts are provided.

Report presenting a theoretical investigation of the influence of changes in vertical tail area and dihedral angle on the lateral flying characteristics of an airplane. Lateral motions were computed for nine different combinations of vertical tail area and dihedral. Results regarding the lateral motions due to applied rolling moment with different amounts of accompanying pawing moment and lateral motions due to applied yawing moment are provided.

Report presenting a study of the aerodynamic factors upon which the ability to perform the maneuver depends in an attempt to obtain a better understanding of the conditions involved and, if possible, to evolve criterions that may be used during design.

"Additional tests as recommended in reference 1 were made in the 7- by 10-foot wind tunnel of the 1/8-scale model of the Brewster F2A airplane to determine the angle of attack of horizontal tail and the elevator angles required for trim with flaps down" (p. 1).

Problem of improving thrust at low speeds is primarily one of reducing angle of attack of operation of sections to improve L/D or reducing blade helix angle. An analysis, based on recent propeller data, is presented for determining improvements in thrust or efficiency which could be obtained by increased number of blades, increased blade width, increased diameter, dual rotation, and two-speed gearing. All methods were found very effective, particularly two-speed gearing.