Memorandum presenting an investigation of thrust augmentation by the injection of water-alcohol mixtures into the compressor inlets of a turbojet engine with a centrifugal-flow-type compressor at altitudes of sea level, 5000 feet, and 10,000 feet. The investigation was made to determine the water-alcohol mixture and the injection rate for optimum thrust augmentation. At a standard NACA altitude of 10,000 feet and an engine speed of 16,000 rpm, the mixture and injection rate for optimum thrust augmentation was found to be 20-percent alcohol to water by weight injected at a rate of approximately 1.45 pounds per second.

From Summary: "An investigation was made by the NACA wing-flow method to determine the longitudinal stability and control characteristics at transonic speeds of a semispan model of the XF7U-1 tailless airplane. The 25-percent chord line of the wing of the model was swept back 35 deg. The airfoil sections of the wing perpendicular to the 25-percent chord line were 12 percent thick. Measurements were made of the normal force and pitching moment through an angle-of-attack range from about -3 deg to 14 deg for several ailavator deflections at Mach numbers from 0.65 to about 1.08."

A 1/5.5-size powered dynamic model of the Columbia XJL-1 amphibian was landed in Langley tank no. 1 in smooth water and in oncoming waves of heights from 2.1 feet to 6.4 feet (full-size) and lengths from 50 feet to 264 feet (full-size). The motions and the vertical accelerations of the model were continuously recorded. The greatest vertical acceleration measured during the smooth-water landings was 3.1g.

From Introduction: "This report presents an analysis based on flight and wind-tunnel test data directed toward the determination of the probable cause of the pitch-up. Wing pressure distribution and stability and control characteristics in the dive are also included."

From Summary: "An investigation has been conducted on a V-1650-7 engine to determine the cylinder temperatures and the coolant and oil heat rejections over a range of coolant flows (50 to 200 gal/min) and oil inlet temperatures (160 to 2150 F) for two values of coolant outlet temperature (250 deg and 275 F) at each of four power conditions ranging from approximately 1100 to 2000 brake horsepower. Data were obtained for several values of block-outlet pressure at each of the two coolant outlet temperatures. A mixture of 30 percent by volume of ethylene glycol and 70-percent water was used as the coolant."

"The problems associated with propeller noise and with the design of propellers that are less noisy than those conventionally used are presented. Three aspects of these problems are discussed: acoustical, aerodynamic, and structural. Some of the factors which must be considered in the design of a quiet propeller are outlined" (p. 1).

From Summary: "The results of numerous unrelated tests of dive-recovery flaps are collected in this report and presented in a form suitable for use in the preliminary design of dive-recovery flap installations. Since the data were obtained for airplane models of quite widely varying configurations, and are limited largely to a Mach number of 0.80, it is recommended that each new installation be carefully flight-tested before final approval. A flight-test procedure is outlined which will insure a maximum degree of safety."

Report presenting a flight investigation conducted to establish the heat requirements for ice prevention on aircraft windshields mounted on the forebody of an airplane at several angles. Electrically heated windshields were used in order to provide accurate measuring of heat input to the windshield. Results regarding the quantity of heat provided, amount of water collection, ideal windshield angle, ranges in airplane velocity, and icing conditions are provided.

"An investigation of the spin and recovery characteristics of a 1/24-scale model of the McDonnell XP-88 airplane has been conducted in the Langley 20-foot free-spinning tunnel. The effects of control settings and movements on the erect and inverted spin and recovery characteristics of the model in the normal loading were determined. Tests of the model in the long-range loading also were made" (p. 1).

"An analysis of the effects of compressibility on the longitudinal stability, control, and trim of airplanes flying at high subsonic speeds and a discussion of the causes of and the means for lessening or preventing the diving tendency are presented. Wind-tunnel results for Mach numbers up to 0.90 are included for purposes of illustration and cover several investigations of longitudinal stability and control, airfoil characteristics, dive-recovery aids, and elevator characteristics. Methods are indicated for compensating for the undesirable control tendencies results from the characteristics of the wing at supercritical speeds by the appropriate choice of elevator contour" (p. 1).

From Summary: "Wind-tunnel tests were made of a 1/25 scale model of the Martin JRM-1 airplane to determine: (1) The longitudinal stability and control characteristics of the JRM-1 model near the water and lateral and directional stability characteristics with power while moving on the surface of the water, the latter being useful for the design of tip floats; (2) The stability and stalling characteristics of the wing with a modified airfoil contour; (3) Stability characteristics of a hull of larger design gross weight; The test results indicated that the elevator was powerful enough to trim the original model in a landing configuration at any lift coefficient within the specified range of centers of gravity."

"By use of the methods of thin airfoil theory, which include effects of compressibility, relations are developed which permit the rapid determination of the pressure distribution over an unstaggered cascade of airfoils of a given profile, and the determination of the profile shape necessary to yield a given pressure distribution for small chord gap ratios. For incompressible flow the results of the theory are compared with available examples obtained by the more exact method of conformal transformation. Although the theory is developed for small chord/gap ratios, these comparisons show that it may be extended to chord/gap ratios of order unity, at least for low speed flows" (p. 1).