None

Strains are introduced into bars by cold working in the straightening operation. If no treatment is applied to relieve the strains after the straightening operation, it is conceivable that they may be relieved in the canning process and cause warped slugs. The purpose of this test was to see if fewer non-seats would occur among slugs machined from bars that were outgassed after straightening. Seven hundred and thirty-five slugs from bars that were straightened before outgassing were caned by the standard procedure. One percent non-seats and 1.9% wrinkled cans were noted at the canning pot. It is recommended that all rods which are to be straightened be passed through the straightening operation before outgassing.

It has been found that warped slugs which produce ``non-seats`` segregated after the centrifuging operation by use of a suitable gauge. The slugs which do not pass the gauge are quenched in water and set aside for later recovery. The purpose of this test was to determine if the rejected slugs could be straightened, degreased and recanned by dipping them directly in the bronze and then through the subsequent steps. One hundred and twenty-nine slugs rejected by the warp gauge were straightened, degreased and recanned by dipping directly into the bronze bath, Eleven non-seats and one Al-Si spill over were rejected at the canning pot.The above procedure is recommended as a possible means of treating slugs rejected in the canning operation because of wrap.

None

None

None

None

None

None

None

None