Summary: "Criticality was considered impossible in any contingency encountered in practice under either of the following conditions which include no safety factor: (a) In any isolated cylinder not more than 5 in. in disruptor, if the total amount of U235 present does not exceed 7.5 Eg. (b) In an isolated vessel of any shape and size, if the total amount of U235 present does not exceed 880 g. An "isolated" vessel is one which does not "see" more than 0.1 [...] other vessels containing fissionable material."

Report that describes the development, design, and operation of a prototype instrument meant to monitor the As76 concentration in reactor cooling water streams.

Laboratory studies involving fluid flow through porous media require use of fluids having low dissolved gas content. Water is the major fluid used in various and box model and soil permeability studies carried out by the Geochemical and Geophysical Research group. Tap water supplied to the 222-U Bldg. contains a large amount of dissolved air. Under the reduced pressure encountered during model studies, the air is released from solution and gradually clogs the pores of the sand or other porous material. This, of course. leads to anomalous results and cannot be tolerated in precious studies. A system was required to effectively remove the air and make available a continuous supply of desired water for the model studies.

This report defines in detail the source of the dose rate of U233 and describes a method by which they may be predicted.

Introduction: "A corrosion test program, to determine the suitability of LaBour B-55 and Worthite for use in the construction of circulating pumps for th UO3 process has been completed and the data are appended."

Large savings in waste storage space may be realized by lowering the pH at which TBP waste is stored. Additional savings in neutralizing chemicals and operating time would also increase the monetary gain from such a process change. However, before such a change could be made, the corrosive effect of TBP waste at a lower pH on the mild steel waste storage tanks had to be determined.

The build up of contaminated film on the internal surfaces of high temperature in-reactor recirculating water loops has created serious radiation exposure problems to operational and maintenance personnel. A considerable amount of work has been applied to develop an effective decontamination process for the decontamination of these loops and their components.

Introduction: "A laboratory investigation of the relative corrosion resistance of several austenitic stainless steels to the RAW stream of the Tributyl Phosphate Waste Metal Recovery Process was made during the first quarter of 1950. The results of this investigation are reported herein; all original data are recorded in laboratory notebook HW-3282-T."

The corrosion resistance of four types of austenitic stainless steels to Purex process first and second acid concentrator bottoms was determined. Although the compositions of the two solutions were very similar, tests in simulated solutions of both compositions were conducted to strengthen the basis for the conclusions which were to be made.

Introduction: Static, total immersion corrosion tests were carried out at room temperatures with Carboloy grades 44-A, 78, 907, X-3119-A and X-3119-B in Redox process solutions (ANL, June 1, 1949 Flowsheet) 1AX, 1AF, and 1AS.

Introduction: A limited test progress on Alloghany-Ludlum type 347 stainless steel plate which failed the Huey test (ASTN A-262-44T) has been completed.

Abstract: "The critical mass both of an untamped and water-tamped sphere with parabolic radial variation of the intrinsic buckling is calculated by a perturbation method. The result is applied to finding the minimum critical mass of plutonium in water suspension with infinite water temper; the calculations show that the minimum critical mass at constant concentration may be reduced by an amount of the order of 7.6% when the concentration of plutonium is permitted to vary throughout the suspension."

The following report examines methods to determine uranium nitrate hexahydrate on pretreated hexone in the range of 0 to 40 g./l. by infrared absorption measurements.

At the request of 234-5 Development, studies of a system for controlling plutonium powder transfer were undertaken by Process Equipment Development. This report presents details of equipment designed to fulfill requirements and proposes equipment for installation on additional Hot Button Line prototypes.

Pressurized water nuclear reactors may be designed based upon either of two concepts: (1) pressure vessel, wherein the entire core is placed in a large, high strength fuel channels within a low pressure container. The Plutonium Recycle Test Reactor is a pressure tube type reactor. Selection of this basic type of pressurized water reactor depended to an appreciable extent upon the availability of suitable pressure tubing.

Basic Studies. It has been reported previously that mixed crystals of PuO2 and UO2 have a higher sintering rate than UO2 alone. However, results to the contrary were obtained on addition to 1/4, 1/2, 1, 2, 5, and 10 w/o PuO2 to PWR grade UO2. Pellets of the above concentrations were heated for one hour in hydrogen at 100 C intervals from 1000 to 1600C.

The majority of two-phase flow problems involving equations of state are solved by use of point-wise utilization steam table values. In this manner, problems involving the use of the various flow equations of continuity, momentum and energy are generally forced into iterative solutions. Considerable effort towards the development of an analytical expression for the state equation seems indicated so as to simplify the analysis of two-phase problems, particularly the transient cases. The question of instability of state and mixture condition is particularly apparent in the analysis of systems undergoing phase transformation as demonstrated by the significant difference between simple theory and experimental critical flow determinations. The assumption of homogeneous, equilibrium mixtures is indicated as a first attack upon the problem.

In conjunction with the fuel element development program at Hanford, it is desired to determine the effects of cladding and core temperatures, cladding thickness, and exposure upon the swelling behavior of unalloyed uranium. To obtain this information, it is proposed to irradiate several fuel rods, clad by coextrusion with Zr-2, in NeK filled stainless steel capsules. The central uranium temperatures are to be monitored by axial thermocouples. Irradiation tests in the MTR and ETR using capsules of similar design have been and are now being conducted. GKH 3-31, a fuel rod, clad with 0.030" Zr-2, operated in the MTR at an average center fuel temperature of 425 C to an exposure of 2100 MWD/T. GKH 3-57, 3-58, and 3-59 are presently undergoing irradiation in the ETR.

aluminum has been considered as a material for cladding fuel elements to be used in reactors cooled by high-temperature recirculating water. Aluminum is abundant, chap, has a relatively low cross section for thermal neutrons, and is readily fabricated into complex shapes. For these reasons, it appears that the use of aluminum rather than steel, Zircaloy or other candidate materials for fuel element cladding, would result in considerable savings in operating expense. The actual economics will of course depend on specific factors such as core materials and design of the reactor/. Aluminum appears particularly attractive for cladding the cores of aluminum-plutonium alloy proposed for the Plutonium Recycle Test Reactor since, in this case, the physical characteristics of the core and cladding would be practically identical.

Objective: "The observations summarized in the present report were made to determine the stability of ferrous and sulfamate ions and sulfamic acid in RA Column scrub solution (RAS) and in aqueous solution comparable to the RA Column feed tee composition (RAFS). Knowledge of the stability of the reducing agent (ferrous iron) is necessary to properly plan the method of preparation and introduction of this component into the RA system and to assure dependable and reproducible performance."

From introduction: "Five appendices, each of which pertains to a separate phase of the Filtration of Radioactive Aerosols by Glass Fibers program."

Measurements were taken to provide experimental evidence for determining the feasibility of a proposed method for converting Pu240 to 241 by exposing shielded plutonium to selectively transmitted pile neutrons.

Report discussing a method of rear face monitoring by television as a form of visual contact and communication between Hanford Works crews. A conclusion and recommendation of the method is given as well as an explanation of necessary materials.

Field tests were conducted to measure short-period pollutant concentrations at several stack heights during conditions of marked atmospheric instability and low wind speeds. The source was a mechanical smoke generator located at the 185-ft level of a tower.