Report presenting a wind-tunnel investigation to explore the possibility of employing boundary-layer suction slots as a means for delaying laminar separation at the leading edge and turbulent separation over the rear portions of the airfoil section at high lift coefficients. Results regarding lift and drag are explored.

Report presenting an investigation in the 7- by 10-foot tunnel of the aerodynamic and hinge-moment characteristics of an untapered, aspect ratio 3, semispan horizontal-tail model with 45 degrees of sweepback through a range of Mach numbers. The model was equipped with an unbalanced and a horn-balanced 25-percent-chord elevator.

From Summary: "A review of the status of the knowledge on turbine-blade cooling and a description of pertinent NACA investigations are presented. The current limitations in performance of uncooled and cooled engines are briefly discussed. Finally, the knowledge available and investigations to increase the knowledge on heat transfer, cooling-flow, and performance characteristics of cooled turbines are discussed."

"Free-flight tests have been made to determine the drag at zero lift of several configurations of a missile having triangular wings and tails. Base-pressure measurements were also obtained for some of the configurations. The results show that increasing the wing thickness ratio from 4 to 6 percent increased the wing drag by about 100 percent at M = 1.3 and by about 30 percent at M = 1.8" (p. 1).

Report presenting an investigation of several fuels in a 16-inch ramjet engine during a free-jet investigation of ramjet performance in a wind tunnel. The fuels used were gasoline, kerosene, blend of 50-percent gasoline and 50-percent propylene oxide, blend of 75-percent kerosene and 25-percent propylene oxide, and isopentane. Results regarding ranges of operation, combustion efficiencies, and weight and volume specific fuel consumptions obtained with various fuels.

Report presenting the results of an investigation to determine the drag, static stability, control effectiveness, boundary-layer conditions, and first-order effects of propeller operation on a scale model of a proposed high-submerged-speed submarine with various bridge-fairwater and tail configurations.

Report presenting an investigation of the effects of many of the parameters significant to wing flutter on several untwisted rotating models to determine their significance with respect to stall flutter of propeller blades. The parameters included torsional stiffness, section thickness ratio, sweepback, length-chord ratio, section center-of-gravity location, blade taper, Mach number, and fluid density. Results regarding the considerations on method of presentation, experimental data and discussion, some possible applications, and a comparison of experiment with classical-flutter theory are provided.

The present paper presents the results of a brief investigation made to determine the effectiveness of a proposed emergency spin-recovery device to be used during demonstration spins of the Northrop XF -89 airplane. The proposed device makes use of split-type ailerons deflected +/-60deg on the outboard wing (left wing in a right spin). Tests made on a model which represented the airplane to a scale of 7 indicated that, if an uncontrollable spin is obtained in the design gross--weight loading, the device is not sufficiently effective to insure recovery,.

A preliminary analytical evaluation of the air and fuel specific-impulse characteristics of hydrogen, a-methylnapthalene, and graphite carbon has been made. Adiabatic constant-pressure combustion flame temperatures for each fuel at several equivalence ratios were calculated for an initial air temperature of 560 degrees R and a pressure of 2 atmospheres.

Memorandum presenting the use of the modified slender-body method to predict the lift and moment interference of triangular wing-body combinations adapted to combinations with other than triangular wings. The methods are applied to the prediction of the lit-curve slopes of nearly 100 triangular, rectangular, and trapezoidal wing-body configurations.

Report presenting the use of the modified slender-body method to predict the lift and moment interference of triangular wing-body combinations to evaluate combinations with non-triangular wings. The method is applied to the prediction of lift-curve slopes of nearly 100 triangular, rectangular, and trapezoidal wing-body configurations.

Report presenting an experimental investigation of the pressure distributions on a hemispherical nose 3.98 inches in diameter, mounted on a cylindrical support, at several Mach and Reynolds numbers. The Reynolds number was based on body diameter and free-stream conditions. Pressure-drag coefficients were calculated and good agreement was obtained with other testing.

The possibility of overshooting the anticipated normal acceleration as a result of the artificial-feel characteristics of the F-89C airplane at a condition of minimum static stability was investigated analytically by means of an electronic simulator. Several methods of improving the stick-force characteristics were studied. It is shown that, due to the lag in build-up of the portion of the stick force introduced by the bobweight, it would be possible for excessive overshoots of normal acceleration to occur in abrupt maneuvers with reasonable assumed control movements. The addition of a transient stick force proportional to pitching acceleration (which leads the normal acceleration) to prevent this occurring would not be practical due to the introduction of an oscillatory mode to the stick-position response. A device to introduce a viscous damping force would Improve the stick-force characteristics so that normal acceleration overshoots would not be likely, and the variation of the maximum stick force in rapid pulse-type maneuvers with duration of the maneuver then would have a favorable trend.

Report presenting an investigation to determine the effect of oxygen concentration of the inlet oxygen-nitrogen mixture on the combustion efficiency of a J33 single combustor operating with gaseous propane fuel. Combustion efficiency data were obtained at a variety of combustion-inlet total pressures, fuel flow rates, and inlet oxygen concentrations. Results regarding combustor data, application of fundamental combustion properties to combustor data, application of simplified reaction kinetics equation to combustor data, comparison of liquid and gaseous fuel data, and limitations of correlation parameters.

Report presenting an investigation at transonic speeds to determine the effects of fences, drooped nose, combination fences and drooped nose, and vortex generators on a 45 degree sweptback wing-fuselage combination. The purpose of undertaking this investigation was due to the pitch-up tendency that results from leading-edge vortex-type flow on thin sweptback wings. The data for each component and their interaction with one another is also provided.

"An experimental investigation has been conducted in the Langley stability tunnel at low speed to deter+nine the yawing stability derivatives of a 1/9-scale powered model of the Convair XFY-1 vertically rising airplane. Effects of thrust coefficient were investigated for the complete model and for certain components of the model. Effects of control deflections and of propeller blade angle were investigated for the complete model" (p. 1).

Memorandum presenting the use of the hypersonic similarity rule to correlate pressure distributions and wave drags for minimum-drag nose shapes derived by Von Karman and Newton. The computed results have been confirmed by comparison with available experimental data. Wave-drag results for both the Karman and Newtonian shapes are compared with each other and with results for ocnes and circular-arc tangent ogives.

Report presenting a series of fence installations tested on a swept-wing jet airplane to determine their effects on the longitudinal instability, or "pitch-up", encountered in high-maneuvering flight. Longitudinal-stability measurements were made at a variety of Mach numbers with nine fence configurations that varied in chordwise extent and spanwise position. Results regarding longitudinal stability, flow phenomena, buffeting and wing dropping, drag, and low-speed stalls are provided.

Report presenting an investigation to determine the aerodynamic characteristics of two three-blade propellers over a range of blade angles and Mach numbers. The thick-blade propeller was more adversely affected by compressibility than the thin-blade propeller, and the maximum efficiency of the thin-blade propeller was higher than the thick-blade propeller.

The zero-lift damping in roll of the Bell MX-776 missile has been measured by a sting-mounted rocket-model technique at Mach numbers from 0.6 to 1.56. The damping-in-roll data, in general, show no unusual variation with Mach number. Aileron rolling-moment effectiveness derived from these data and previously obtained rolling-effectiveness data appear reasonable,.

Report presenting an investigation to determine the longitudinal stability and afterbody pressure characteristics of the TX-14 and TX-16 special weapons at transonic and supersonic speeds. Results regarding dynamic testing and pressure testing are provided.

"An investigation was conducted in the Langley 20-foot free-spinning tunnel on a 1/23-scale model of the McDonnell F3H-1N airplane. The effects of control settings and movements upon the erect and inverted spin and recovery characteristics of the model were determined for the clean condition. Spin-recovery parachute tests were also performed. The results indicated that erect spins obtained on the airplane for the take-off or combat loadings should be satisfactorily terminated if full rudder reversal is accompanied by moving the ailerons to full with the spin (stick full right in a right spin)" (p. 1).

The problem of improving operational reliability of turbojet engines is studied in a series of papers. Failure statistics for this engine are presented, the theory and experimental evidence on how engine failures occur are described, and the methods available for avoiding failure in operation are discussed. The individual papers of the series are Objectives, Failure Statistics, Foreign-Object Damage, Compressor Blades, Combustor Assembly, Nozzle Diaphrams, Turbine Buckets, Turbine Disks, Rolling Contact Bearings, Engine Fuel Controls, and Summary Discussion.

"The National Advisory Committee for Aeronautics has conducted a flight test of a model approximating the McDonnell F3H-1N airplane configuration to determine its pitch-up and buffet boundaries, as well as the usual longitudinal stability derivatives obtainable from the pulsed- tail technique. The test was conducted by the freely flying rocket-boosted model technique developed at the Langley Laboratory; results were obtained at Mach numbers from 0.40 to 1.27 at corresponding Reynolds numbers of 2.6 x 10(exp 6) and 9.0 x 10(exp 6). The phenomena of pitch-up, buffet, and maximum lift were encountered at Mach numbers between 0.42 and 0.85" (p. 1).