A multi-purpose program for processing exponential data has been prepared for the 709 computer. The main purposes of the program is to compute the material buckling from raw data (given counts, time, and counter information) or from previously calculated Athermal's. It is also possible to compute only CeCh (end and harmonic corrections) for a given B11 or series if B11's no counting data being entered. In every case, pile measurements must be submitted as input for corrections.

An addendum to report HW-30390 a additional power generation calculation for P, the rate of energy release, in kilowatts, was derived.

Summary: A method was found for determining calcium concentrations in TBP process streams in spite of serious interferences bysodium, ferrous, uranyl, sulfate, phosphate, and sulfamate ions as well as by TBP. The precision attainable varied from sample to sample, depending upon its composition. In general, errors of 20% or greater occurred. The smallest determinable amount of calcium was about 10 mg/1.

From introduction: The present report describes further refinements of the apparatus and the method to meet a need for a sensitive determination of carbon in plutonium.

From introduction: "This report presents the apparent viscosities of supernate-sludge slurries prepared synthetically to simulate the conditions known to exist in the waste storage tanks, but with fission products and plutonium absent."

Laboratory studies involving fluid flow through porous media require use of fluids having low dissolved gas content. Water is the major fluid used in various and box model and soil permeability studies carried out by the Geochemical and Geophysical Research group. Tap water supplied to the 222-U Bldg. contains a large amount of dissolved air. Under the reduced pressure encountered during model studies, the air is released from solution and gradually clogs the pores of the sand or other porous material. This, of course. leads to anomalous results and cannot be tolerated in precious studies. A system was required to effectively remove the air and make available a continuous supply of desired water for the model studies.

The build up of contaminated film on the internal surfaces of high temperature in-reactor recirculating water loops has created serious radiation exposure problems to operational and maintenance personnel. A considerable amount of work has been applied to develop an effective decontamination process for the decontamination of these loops and their components.

The following report provides data from corrosion tests meant to evaluate the performance of Type 3098Cb stainless steel in BiP04 process dissolver solution containing mercuric ion.

"The attached report summarizes the work performed in the establishment of an improved spectrographic method for determining iron in plutonium."

The following report examines methods to determine uranium nitrate hexahydrate on pretreated hexone in the range of 0 to 40 g./l. by infrared absorption measurements.

Report of data for the distributions of elements 90 through 96 between molten salt solutions of their chlorides and molten aluminum (or alloy) at 725 Celsius.

This article presents data on the effects of gamma radiation on the physical properties of a number of different classes of plastics materials of construction which were screened to determine their capabilities and limitations for service in applications where ionizing radiation exists. The irradiations were carried out in air at ambient temperature at normal atmospheric pressure to various gamma radiation doses up to 1*10^9 r depending upon the stability of the materials to radiation exposure. The different classes of materials and materials within a class are compared.

Results of four experimental heats run at the end of the G-5 contract in the National Carbon Company Clarksburg production furnaces.

From introduction: "In this report an attempt was made to summarize the results of recent research on the effective height of smoke stacks. In this summary attention is paid only to the case in which the density of the stack effluent is the same as that of the surrounding air."

Objective: "The observations summarized in the present report were made to determine the stability of ferrous and sulfamate ions and sulfamic acid in RA Column scrub solution (RAS) and in aqueous solution comparable to the RA Column feed tee composition (RAFS). Knowledge of the stability of the reducing agent (ferrous iron) is necessary to properly plan the method of preparation and introduction of this component into the RA system and to assure dependable and reproducible performance."

Field tests were conducted to measure short-period pollutant concentrations at several stack heights during conditions of marked atmospheric instability and low wind speeds. The source was a mechanical smoke generator located at the 185-ft level of a tower.

From summary: "The relative absorptions of X-rays by various substances are listed as a guide to the application of the X-ray photometric method in chemical analysis and to the estimation of interference by extraneous substances."

This report describes an improved infrared absorption method to analyze aqueous samples and TBP after extraction. The method described in the following pages is the carbon tetrachloride extraction method.

The following report describes work carried out to investigate whether the Hanford IB column as designed in a previous report will decontaminate the uranium adequately from plutonium, particularly if there's any slowness in either the rate of reduction or transfer of the plutonium.

This report follows an investigation of a cargo truck found contaminated by various radioactive material on a routine trip from Arco, Idaho to the Hanford plant on May 8, 1952. The report analyzes the truck's route in an attempt to find the location of the contaminating region.

The design of NPR shows large quantities of carbon steel pipe and fittings in the front and rear face areas. These are also the area where the most work must be done during an outage, and consequently lower radiation levels are needed here than elsewhere in the piping system. A single pass decontamination of the front and rear piping without going through the entire loop is desirable. Because of the quantities of chemicals and available down time, an effective shorty interval process is needed. This report gives some recent laboratory data on this subject.

The Interim Power Fuels Reprocessing Program, as established by the Atomic Energy Commission, provides the service of recovering uranium, thorium, plutonium, etc., from irradiated fuels discharged from non-production reactors of both public and private ownership. To provide this service on an interim basis and at minimum capital investment, the Commission has assigned the processing responsibility for the various fuel types to several AEC sites. The sites are to be assigned fuel types most similar to their normal production. As a result, HAPO has been assigned the responsibility for processing the low enrichment uranium and uranium oxide type fuels with isotopic content up to 5% uranium-235. In addition, some plutonium base fuels will be processed at Hanford.

This paper describes the measurement of control rod strength in the PCTR. The first section outlines the theory and method of such a measurement, and the second section presents the results of the measurement of the Experimental Gas Cooled Reactor (EGCR) control rod strength. The reactor parameter actually inferred is the difference in the infinitive multiplication factor for a control rod supercell with and without the control rod in place in the supercell. These measurements are, therefore, very closely related to the measurement of k∞ for an ordinary lattice cell.

This report presents the final results from the investigation of the ratio of Pu-239 fission cross section to U-235 fission cross section. Three sets of plutonium and uranium foils were prepared at KAPL and were investigated to acquire the final results.