"The hydrodynamic characteristics of a 1/10-size powered dynamic model of the XP5Y-1 flying boat were determined in Langley tank no. 1. Stable take-offs were possible at all practicable positions of the center of gravity and flap deflections. An increase in gross load from 123.5 to 150.0 pounds (21.5 percent) had only a slight effect on the stable range for take-off" (p. 1).

"An investigation has been made in the Langley Unitary Plan wind tunnel at Mach numbers of 1.60, 1.80, and 2.00 to determine the aerodynamic characteristics of a 0.03-scale model of the Avro CF-105 airplane. The investigation included the determination of the static longitudinal and lateral stability, the control and the hinge-moment characteristics of the elevator, rudder, and aileron, as well as the vertical-tail-load characteristics. Although the data are presented without analysis, a limited inspection of the longitudinal control results indicates a loss in maximum lift-drag ratio due to trimming of about 1.8 because of the large static margin" (p. 1).

"A compilation of free-spinning-airplane model data on the spin and recovery characteristics of 111 airplanes is presented. These data were previously published in separate memorandum reports and were obtained from free-spinning tests in the Langley 15-foot and the Langley 20-foot free-spinning tunnels. The model test data presented include the steady-spin and recovery characteristics of each model for various combinations of aileron and elevator deflections and for various loadings and dimensional configurations" (p. 1).

The stator-blade angles in the first four stages of a 16-stage axial-flow compressor were increased in order to decrease the angles of attack of these stages, and thereby to improve part-speed performance. The performance of this modified compressor was compared with that of the same compressor with original blade angles.

Report presenting a linear stability analysis and flight-test investigation on a rolleron-roll-rate stabilization system for a canard missile. This type of damper provides roll damping by the action of gyro-actuated uncoupled wing-tip ailerons. A dynamic roll instability predicted by the analysis was confirmed by flight testing and was subsequently eliminated by introducing control-surface damping about the rolleron hinge line.

From Introduction: "Data are presented in graphical form to show the engine performance over a range of altitudes from 5000 to 50,000 feet and flight Mach numbers from 0.21 to 0.97. Curves are presented to show the windmilling characteristics of the engine. All engine performance data obtained in the investigation are also presented in tabular form."

Report presenting the results of an experimental investigation of the unsteady lift induced on a wing in the downwash field of an oscillating canard control surface. The results indicated that existing theories provide a reliable guide for the estimation of the magnitude of the lift derivatives and centers of pressure at low values of reduced frequency and low angles of attack.

Report presenting an investigation on canopy pressures and canopy-fuselage forces and moments under conditions of combined pitch and sideslip. The canopy configurations tested varied in windshield shape (flat, vee, and round) and were tested at two Mach numbers and Reynolds numbers.

Report presenting measurements of the longitudinal stability, lift, and drag characteristics of an airplane configuration with a 60 degree delta wing and a swept horizontal tail mounted near the wing plane extended at a range of Mach numbers using the rocket-model technique. Comparisons are made to data form a similar model with the tail mounted above the wing plane.

Report presenting zero-lift drag results for two 60 degree delta-wing configurations with air inlets. One had twin conical-shock semi-circular scoops just ahead of the wing-body juncture and one had a modified wing section over the inboard portion to allow installation of modified triangular inlets in the wing leading edge. Results regarding the drag coefficients and mass-flow ratios are provided.

Report presenting an investigation of a configuration with a body of fineness ratio 16.9, a 52.5 degree sweptback wing of aspect ratio 3, taper ratio 0.2, and NACA 65A004 airfoil section, and an incline tail which was aeropulsed continuously in pitching during free flight with and without a sustainer rocket motor operating. The Mach number range covered was from 1.4 to 2.3. Results regarding drag, total normal force and pitching moment, wing normal-force-curve slope, flow conditions at the horizontal tail, and cross coupling are provided.

Report discussing testing of a multijet 60 degree delta-wing airplane configuration with twin-engine exhausts at specified locations under the wing. Data was obtained for jet-on and jet-off conditions between a range of Mach numbers. Results are presented for the effect of jet on drag, jet effect on lift, static longitudinal stability, and dynamic longitudinal stability.

Report presenting an investigation in the 16-foot transonic tunnel to determine the lateral-control effectiveness of differentially deflected horizontal-tail surfaces mounted behind a 45 degree sweptback wing-fuselage combination. The effectiveness of the differentially deflected horizontal tail as a lateral-control device was found to be essentially independent of angle of attack and Mach number even in the transonic region. Results regarding the effects of differential deflection of horizontal-tail surfaces and effects of the vertical tail are provided.

Report presenting an investigation in the transonic pressure tunnel to determine the aerodynamic loading characteristics of a 60 degree delta wing in the presence of a body with and without body indentation in accordance with the transonic-area-rule concept. Tests covered a range of angles of attack and Mach numbers. Results regarding force and moment coefficients and curves are provided.

Memorandum presenting an investigation carried out in the 11-inch hypersonic tunnel to determine the static longitudinal and lateral stability and control characteristics of an airplane configuration with a trapezoidal wing with a modified hexagonal airfoil section and equipped with various tail airfoil sections and tail arrangements. The tests were made at Mach number 6.86 and Reynolds number 343,000 based on the wing mean aerodynamic chord.

Report presenting results from a flight program conducted to obtain information on the airplane response and actual rates and amounts of control motion used by service pilots to perform squadron operational training missions, which are correlated with the airplane handling qualities and calculated maximum dynamic response. Results regarding longitudinal characteristics, rolling characteristics, and sideslip characteristics are provided.

Report presenting two-dimensional aerodynamic lift and moment flutter derivatives for moderate and high angles of attack for several airfoil profiles varying in thickness and thickness distribution. The results indicate that the variables angle of attack, airfoil profile, reduced frequency, and Mach number all have significant interdependent effects.

Report presenting an evaluation of the sea-level static equilibrium performance of an early developmental two-spool turbojet engine and its components and a comparison with a hypothetical two-spool turbojet engine. Results regarding the equilibrium performance of the actual engine, including its compressor performance, turbine performance, component operation, and engine performance and a comparison of those categories with the hypothetical engine are provided.

Report presenting an investigation of the effects of leading-edge camber without twist on an aspect-ratio-3 delta wing of thickness ratio 3, a body with an ogive nose, and a cylindrical afterbody. Results regarding the base pressures and body characteristics and wing-body combinations are provided.

Report presenting an investigation of the effect of reducing the static stability by a practical center-of-gravity shift in swept-wing airplanes of low aspect ratio with no horizontal tail. Results regarding relocating the center of gravity, the effect of lift due to elevator deflection, the effect of increased total elevator effectiveness, and the effect of response characteristics over long time periods are provided.

Report presenting an experimental and analytical investigation of the flutter of uniform sweptback cantilever wings. The experiments used groups of wings sweptback by rotating and by shearing with angles of sweep ranging from 0 to 60 degrees. Results regarding the experimental investigation and a discussion and comparison of the analytical and experimental results are provided.

Report presenting the results of pitching-moment, lift, and drag measurements on a model of the D-558-1 with speed reduction brakes and a symmetrical profile wing at a range of Mach numbers. Only a small decrement in Mach number is produced with no nose-inlet flow and the speed-reduction brakes deflected.

The results of power-off force tests and flight tests of a model with a thin unswept low-aspect-ratio wing are presented. The tests were made with the flaps retracted and deflected. The effects on the lateral flight characteristics of decreasing directional stability were noted.

Report presenting an investigation in the transonic tunnel on the effect of sweepback angle on the wing-body characteristics at a range of Mach numbers. Results regarding lift characteristics, drag characteristics, and pitching-moment characteristics are provided.