This report summarizes investigations taken between October 1, 1959, to September 30, 1960 with the objectives of developing high-tungsten alloys which are readily fabricable into massive and complex shapes and which possess adequate strength for operation at temperatures up to 2000 F. Within this report, studies are divided into two main categories: alloy development and material fabrication techniques

Conclusions from the study: "Radioactive dusts are carcinogenic, and can cause cancer of the lung. complete dose response curves have not yet been determined. All the parameters that render this demonstrably toxic material (radioactive dust) have not yet been evaluated. It is strongly suggested by the experimental data that duration of radiological insult to the lung is an important factor in eliciting lung cancer. The atmospheric tolerance concentrations now in use seem to afford little margin of safety."

An ex-reactor test stimulating the charging of a tubular fuel element in a Zircaloy-2 process tube showed a problem of severe process tube scratching and galling may occur if metal sliding contact fuel element supports are used. Both the fuel supports and the process tubes were autoclaved. Although the conditions of this test were severe in that the sharp edges rather than a flat surface of the supports were in contact with the process tube, it pointed out the potential problem of galling by point on small area contact supports on heavy fuel elements. This difficulty had not been observed with the lighter tubular or cluster fuel elements used in KER irradiation. In addition to the loss of metal and thinning of the process tube after a number of charge-discharge operations, these scratches may lead to localized corrosion or act as points of stress concentration.

This report describes the work carried out in 321 Building semiworks equipment, to define the factors contributing to high corrosion-product contamination and presents recommendations for reducing the impurity level to meet current specifications (maximum of 200 parts total metals per million parts U).

In recognition of the need for an integrated system plan for future development requirements for radiological instrumentation, this information report was written to provide the initial step concerning such a planning. The report is to be considered a basic information analysis of the present in-use plant radiological instrumentation, of the instrumentation now undergoing active development, and of the future development work contemplated.

Information obtained in a survey of control rod applications and operating experience is reported. This survey covered the Army Nuclear Power Program, the Organic Moderated Reactor Experiment, the Yankee Atomic Power Plant, the Shippingport Pressurized Water Reactor and the Argonne Experimental Boiling Water Reactor.

Some results have been obtained which may be of use in studying the escape of fission fragments from slurry particles which contain fissioning material. Assuming that the fission fragments are of fixed range H, that they are generated uniformly and isotopically in a sphere of diameter D, the escape probability , mean path length, and path length distribution function have been derived.

A development program is being carried out in the pilot plant to improve the equipment involved in monitoring, metering and pumping process streams. The equipment under development includes an alpha monitor, a gamma monitor, a waste water monitor, a liquid flow rate meter, a canned rotor pump, a diaphragm pump, air lifts and a pressure tank pump. This report presents the present status of the testing program.

A short-term study was made to investigate the removal of radioiodine vapor from air-steam mixtures as could occur immediately following a nuclear incident in a pressurized water reactor. Activated charcoal traps, designed to simulate a small section of a commercial charcoal canister, were tested at gas velocities of 23.9 to 74.9 ft/min over the temperature range of 75 to 118°C. The iodine removal efficiency was found to range from 99.80 to 99.4% with an average of 99.9%. One test performed at a temperature of 105°C and with gas velocity of 290 ft/min indicated that the iodine removal efficiency was reduced to 99.54%. Activated charcoal exhibits a high efficiency for iodine vapor removal under these test conditions and appears suitable for application in the decontamination of air-steam mixtures.