Nuclear Synthesis of Element 43 (Tc)#x (open access)

Nuclear Synthesis of Element 43 (Tc)#x

The following report on the nuclear synthesis of technetium is based on work performed under contract No. W-7405-eng-26 for the Atomic Energy Project at Oak Ridge National Laboratory.
Date: June 14, 1948
Creator: Motta, E. E. & Boyd, G. E.
System: The UNT Digital Library
The Isolation of Element 43 and Some Observations on Its Chemical Behavior (open access)

The Isolation of Element 43 and Some Observations on Its Chemical Behavior

The following report discusses the renewed element 43, or eka-manganese, whose discovery was heralded in 1925, but whose chemical properties remained unreported until the radiochemical investigations of Perrier and Segre."
Date: June 14, 1948
Creator: Boyd, G. E.; Larson, Q. V. & Motta, E. E.
System: The UNT Digital Library
Indirect Methods for Obtaining Ram-Jet Exhaust-Gas Temperature Applied to Fuel-Metering Control (open access)

Indirect Methods for Obtaining Ram-Jet Exhaust-Gas Temperature Applied to Fuel-Metering Control

Memorandum presenting an analytical method developed that gives two independent means of obtaining the total-temperature ratio across a ram jet or across a turbojet tail-pipe burner without direct measurement of the final gas temperature. Experimental verification of the analysis has been obtained with a 20-inch ram jet over a wide range of operating conditions.
Date: January 14, 1948
Creator: Perchonok, Eugene; Sterbentz, William H. & Moore, Stanley H.
System: The UNT Digital Library
Flight Investigation of a 20-Inch-Diameter Steady-Flow Ram Jet (open access)

Flight Investigation of a 20-Inch-Diameter Steady-Flow Ram Jet

Memorandum presenting a flight investigation conducted on a 20-inch-diameter steady-flow ramjet at a range of altitudes and free-stream Mach numbers. Results regarding the variation of combustion efficiency with fuel-air ratio and pressure altitude, effects of combustion-chamber-inlet velocity, and altitude on the operating range of fuel-air ratio are provided. The ramjet unit operated smoothly over the entire range of velocities and altitudes with the exception of occasional rough operation at excessively rich mixtures.
Date: January 14, 1948
Creator: Disher, John H.
System: The UNT Digital Library
Experimental investigation of thrust augmentation of 4000-pound-thrust centrifugal-flow-type turbojet engine by injection of water and alcohol at compressor inlets (open access)

Experimental investigation of thrust augmentation of 4000-pound-thrust centrifugal-flow-type turbojet engine by injection of water and alcohol at compressor inlets

Report presenting an experimental investigation at zero flight speed and sea-level conditions on a 4000-pound-thrust centrifugal-flow-type turbojet engine to determine the amount of thrust augmentation obtainable at maximum rotor speed by the injection of water, alcohol, and water-alcohol mixtures at the compressor inlets. A maximum thrust augmentation of 26 percent was obtained by the injection of 4.5 pounds per second of water and 2.0 pounds per second of alcohol. Results regarding the tail-pipe gas temperature, air-flow and compressor-outlet pressure, fuel flow, specific liquid consumption, and thrust augmentation are provided.
Date: May 14, 1948
Creator: Jones, William L. & Engelman, Helmuth W.
System: The UNT Digital Library
A fuel-distribution control for gas-turbine engines (open access)

A fuel-distribution control for gas-turbine engines

"The principle of operation of a device to control the distribution of fuel to any number of discharge nozzles of a gas-turbine engine is presented. A description of an experimental model of the device and the results of a bench investigation are presented. This device controlled the flow to four discharge nozzles within 2 percent of perfect distribution over a wide range of fuel flow and was unaffected by uneven discharge-nozzle pressures" (p. 1).
Date: June 14, 1948
Creator: Gold, Harold & Straight, David M.
System: The UNT Digital Library
Wind-Tunnel Investigation of the Stability of Jettisoned Nose Sections of the D-558 Airplane: Phases 1 and 2 (open access)

Wind-Tunnel Investigation of the Stability of Jettisoned Nose Sections of the D-558 Airplane: Phases 1 and 2

Report presenting an investigation of the stability of models of the jettisonable nose sections of D-558 airplanes in two phases. The effects of center-of-gravity location and stabilizing fins of various sizes were also determined. The noses were found to tumble end over end at an approximately horizontal axis, which may be dangerous to the pilot if the nose is jettisoned while the airplane is traveling at a high rate of speed.
Date: January 14, 1948
Creator: Scher, Stanley H.
System: The UNT Digital Library
High-Speed Stability and Control Characteristics of a Fighter Airplane Model with a Swept-Back Wing and Tail (open access)

High-Speed Stability and Control Characteristics of a Fighter Airplane Model with a Swept-Back Wing and Tail

Memorandum presenting wind-tunnel tests conducted to determine the high-speed stability and control characteristics of an airplane model with a sweptback wing and tail. The aerodynamic coefficients and the longitudinal- and lateral-control characteristics of the plain wing-fuselage-tail combination are included. Results regarding lift, drag, and pitching moment, longitudinal characteristics, lateral characteristics, wing leading-edge slate, and fuselage-side dive brakes are provided.
Date: April 14, 1948
Creator: Morrill, Charles P., Jr. & Boddy, Lee E.
System: The UNT Digital Library
The Effectiveness at High Speeds of a 10-Percent-Chord Plain Trailing-Edge Flap on the NACA 65-210 Airfoil Section (open access)

The Effectiveness at High Speeds of a 10-Percent-Chord Plain Trailing-Edge Flap on the NACA 65-210 Airfoil Section

This report contains the results of a high-speed wind-tunnel investigation of the effectiveness of a 10-percent-chord plain flap on the NACA 65-210 airfoil section. The results include an indication of the lift-producing characteristics and the effectiveness of the 10-percent-chord flap. From a comparison of the characteristics of the 10-percent-chord flap with those of a 20-percent-chord flap it was concluded that, although a reduction in flap-chord ratio from 0.20 to 0.10 lessens the severity of the effectiveness loss at supercritical speeds, the 20-percent-chord flap is more effective throughout the entire range of Mach numbers from 0.3 to 0.875.
Date: June 14, 1948
Creator: Ilk, Richard J.
System: The UNT Digital Library
Preliminary Investigation to Determine Propeller Section Characteristics by Measuring the Pressure Distribution on an NACA 10-(3)(08)-03 Propeller Under Operating Conditions (open access)

Preliminary Investigation to Determine Propeller Section Characteristics by Measuring the Pressure Distribution on an NACA 10-(3)(08)-03 Propeller Under Operating Conditions

"An investigation has been made in the Langley 16-foot high-speed tunnel to determine the propeller-section characteristics by measuring the pressure distribution on the airfoil sections of a rotating propeller. The pressures were measured at nine radial stations on an NACA 10-(3)(08)-03 design two-blade propeller. This paper presents the results of the pressure measurements in the form of normal-force and moment coefficients and covers a range of nominal angle of attack (simple blade element theory) from 0 degrees to 4 degrees for a section Mach number range of approximately 0.6 to 1.15 for the outboard stations and approximately 0.3 to 0.6 for inboard stations" (p. 1).
Date: July 14, 1948
Creator: Evans, Albert J. & Liner, George
System: The UNT Digital Library
Present Status of Polonium Tolerance Estimations (open access)

Present Status of Polonium Tolerance Estimations

From abstract: "This report contains a summary of biological information on distribution, excretion, and toxicity of polonium; a comparison of results obtained when maximum permissible exposure rates for man are calculated from available data by different methods; and a critical evaluation of the present status of Po tolerance estimates."
Date: October 14, 1948
Creator: Hursh, John B. & Stannard, J. Newell
System: The UNT Digital Library
Preliminary Results of Nene II Engine Altitude-Chamber Performance Investigation 2 - Altitude Performance Using 18.41-Inch Diameter-Jet Nozzle (open access)

Preliminary Results of Nene II Engine Altitude-Chamber Performance Investigation 2 - Altitude Performance Using 18.41-Inch Diameter-Jet Nozzle

"An investigation is being conducted to determine the altitude performance characteristics of the Nene II engine and its components. The present paper presents preliminary results obtained using a jet nozzle of 18.41 inches in diameter, giving an area equal to 96.4 percent of the area of the standard jet nozzle of this engine. The test results presented are for conditions simulating altitudes from seal level to 50,000 feet and ram-pressure ratios from 1.00 to 2.70. The ram pressure ratios correspond to flight Mach numbers between zero and 1.28" (p. 1).
Date: June 14, 1948
Creator: Armstrong, John C.; Wilsted, H. Dean & Vincent, Kenneth R.
System: The UNT Digital Library