From Introduction: "The altitude performance characteristics of the prototype J40-WE-8 turbojet engine were determined in the NACA Lewis altitude wind tunnel. The altitude operational characteristics of the engine are presented herein. The results of a brief study of the effect of the two different grades of fuel (MIL-F-5624A grades JP-3 and JP-4) on steady-state engine performance at an altitude of 45,000 feet and a flight Mach number of 0.20 are also given."

The results of an analytical investigation of the theoretical air specific impulse performance and adiabatic combustion temperatures of several possible ram-jet fuels over a range of equivalence ratios, inlet-air temperatures, and combustion pressures, is presented herein. The fuels include octane-1, 50-percent-magnesium slurry, boron, pentaborane, diborane, hydrogen, carbon, and aluminum. Thermal effects from high combustion temperatures were found to effect considerably the combustion performance of all the fuels. An increase in combustion pressure was beneficial to air specific impulse at high combustion temperatures. The use of these theoretical data in engine operation and in the evaluation of experimental data is described.

Drag and longitudinal trim at low lift of the North American YF-100A airplane at Mach numbers from 0.76 to 1.77 as determined from the flight test of a 0.11-scale rocket model are presented herein. Also included are some longitudinal stability and some qualitative pitch-damping data.

Memorandum presenting an investigation conducted in the 4- by 4-foot supersonic pressure tunnel at Mach number 2.01 to determine the static stability and control characteristics of a canard-type missile configuration with large deflections of the canard controls and with deflection of wing-tip controls. The results of the investigation indicated that with a 30 degree deflection of the canard control a maximum trim normal-force coefficient of 0.4 and a maximum trim angle of attack of 12 degrees might be obtained for the optimum center-of-gravity location.

Report presenting an investigation in the 16-foot transonic tunnel to determine the effect of leading-edge chord-extensions on the aerodynamic characteristics of a sweptback wing-fuselage combination at several Mach numbers. Results regarding the effect of chord-extensions on longitudinal stability for wing-normal configuration, effect of chord extensions on lift for wing-normal configurations, effect of chord-extensions on drag and lift-drag ratios of wing-normal configurations, effect of chordwise fences on the aerodynamic characteristics of a wing-normal configuration, and effect of chord-extensions on the pitching moment and lift characteristics of a wing-art configuration are provided.

Report presenting an experimental investigation using a 1 7/8-inch diameter burner to determine the effects of particle size and stabilizing additives on the combustion performance of magnesium-hydrocarbon slurry fuels. Results regarding an evaluation of the sampling method, blow-out velocity, and combustion efficiency are provided.

Report presenting testing of the effectiveness of transpiration cooling of an 8 degree total angle conical body with water removed onto the surface through a porous section near the nose. Results regarding a reference test without cooling, a cooling test with 0.010 pound of water per second, a cooling test with 0.0025 pound of water per second, a hypothesis of the phenomena of liquid transpiration cooling, water consumption are provided.

Report presenting cold-flow free-flight tests at zero lift to investigate the possibility of flutter of simulated wing-ram-jet-nacelle configurations which were 1/9-scale models of the wing and ramjet nacelles of the Grumman XSSM-N-6a missile. Testing was performed on three different configurations. Results regarding Mach number, velocity, aerodynamic density, and flutter are provided.

Report presenting an investigation in the transonic tunnel to determine the influence of a change in body shape on the effects of twist and camber. Twist and camber were found to greatly improve the maximum lift-drag ratios of the wing-modified fuselage configuration through the speed range, but reduced the ratios for a wing-curved fuselage configuration. Results regarding basic aerodynamic data are also provided.

Report presenting an investigation conducted with several 73-percent semispan inboard spoiler ailerons, projecting 4 percent of the local wing chord from the wing surface, and located at the 70-percent chord line of a 45 degree sweptback wing-fuselage combination. Results regarding the effect of upper-surface spoilers on basic model characteristics, effect of gap on spoiler characteristics, comparison of upper- and lower-surface spoiler characteristics, comparison of upper-surface spoiler with oppositely deflected spoilers, effect of Mach number on spoiler effectiveness, and a comparison of spoiler effectiveness with aileron effectiveness are provided.

Report presenting an investigation of the feasibility of modifying the transient portion of the stick force in abrupt maneuvers in order to eliminate inadvertent normal-acceleration overshoots. The modification consists of additional stick force proportional to a quantity which leads the normal acceleration. The characteristics introduced by the inclusion of the force were considered to be very desirable by pilots.

Report presenting an investigation of a constant-area, circular 90 degree elbow of mean radius of curvature equal to its diameter with several arrangements of simple, nontwisted, rectangular vortex generators. The inlet flow had a boundary layer of about one-tenth the duct diameter. Results regarding an elbow with no vortex generators and an elbow with vortex generators are provided.

Report presenting an investigation to determine the lateral control characteristics of constant-percent-chord trailing-edge elevons on a tailless wing-body combination with a pointed wing of aspect ratio 2. The effectiveness of inset tabs in reducing the elevon hinge moment was also determined. Results include the lift, drag, pitching moment, rolling moment, elevon hinge moment, tab moment, elevon load, and center of pressure of elevon load.

Results are presented, in graphical and tabular form, from a wind tunnel investigation of the lift, drag, and pitching moment characteristics of thin, low-aspect-ratio wings in combination with a body at Mach numbers from 0.25 to as high as 1.9. The following are analyzed and compared with existing theoretical results: 1. Effects of aspect ratio on 3-percent-thick triangular wings; 2. Effects of plan form on 3-percent-thick triangular, sweptback, and unswept wings of aspect ratios 2 and 3; 3. Effects of wing thickness on triangular wings of aspect ratio 2; 4. Effects of profile shape on triangular, sweptback, and unswept wings; and 5. Effects of camber and twist on triangular wings of aspect ratios 2 and 4.

Report presenting performance characteristics of three similar canard-type, long-range ram-jet missiles to evaluate the relative merits of several types of engine installation. Some of the engine installations included a twin-engine nacelle-type installation strut-mounted above and below the fuselage, a twin-engine nacelle-type installation mounted on the wing, and a single-engine fuselage-contained installation with an underslung scoop-type inlet.

The performance of a turbojet engine with a two-stage turbine, an adjustable first-stage turbine stator, and a variable-area exhaust nozzle was investigated at selected constant engine speeds and two simulated flight conditions. For the particular component characteristics of the engine investigated, little improvement in thrust levels of interest by use of an adjustable rather than an optimum fixed first-stage turbine stator.

From Summary: "The literature pertaining to the preparation, physical properties, corrosiveness, thermal stability, constitution, and analysis of various nitric acids is reviewed primarily with respect to their use as rocket oxidants. Conflicting data are evaluated and recommendations for additional experimental work are indicated. Reactions of nitric acid which could occur during the starting and steady-stage phases of rocket operation are discussed and probable mechanisms are selected on the basis of reported thermal and kinetic data."

Report presenting an investigation to determine the effect of turbulence generated by different sizes of wire grid on the minimum spark-ignition energy of a flowing propane-air mixture. Gas-stream velocity, size of turbulence promoter, and distance from the promoter plate to the electrodes on minimum ignition energy were evaluated and the effects are shown in figures.

An analytical evaluation of the air and fuel specific-impulse characteristics of magnesium, magnesium octene-1 slurries, aluminum, aluminum octene-1 slurries, boron, boron octene-1 slurries, carbon, hydrogen, alpha-methylnaphthalene, diborane, pentaborane, and octene-1 is presented. While chemical equilibrium was assumed in the combustion process, the expansion was assumed to occur at fixed composition.