The fact that material transport does occur under conditions of finite temperature difference in a flowing molten metal system was established. The rate mass transfer was thought to be either diffusion limited or solution rate limited. It is believed that the mass transfer of structural materials in Na or NaK systems is solution rate limited. The limiting process has not been qualitatively or quantitatively confirmed for the Inconel-Na or Inconel-NaK system. Increasing the maximum system wall temperature increases the amount of mass transfer, at least above 1300 deg F. The effect of the total temperature difference across the system on the amount of mass transfer was determined.

A method was developed for calculating shield induced gamma radiation escaping through openings in a biological shield. The method was applied to the HRT and the results indicated that the contribution to the dose from induced activity in the HRT shield was around 0.1 r/hr and was insignificant in comparison to to other mechanisms contributing to the escape of gamma rays through shield openings.

Several experiments have been performed at ORNL with light water solutions of uranyl nitrate (highly enriched in either U^233 or U^235) in an essentially bare sphere 27 inches in diameter. This report presents the results of several calculations with elementary bare reactor theory and a discussion of the observed discrepancies between the calculated and experimental results. If the observed critical concentration is used in the calculations, the calculated effective multiplication constant is less than unity' thus a higher critical concentration would be predicted than is actually observed.

The thermophysical properties of Armco iron such as thermal conductivity, electrical resistivity, and Seebeck coefficient have been extensively investigated and reviewed up to 1000 degrees C. Few investigations of such properties have been made on high purity iron. If such a study is made using the same apparatus to determine the properties of two purity levels of iron, then several significant intercomparisons can be made which add meaning to data on a single material. The systemic errors for a single apparatus are the same, therefore comparison of a property of two similar materials is more significant. A comparison of the property changes with temperature and purity can show the effects of impurities on the mechanisms contributing to a property and allows prediction of the properties of iron as a function of purity. For these reasons a study was initiated on the high-purity iron for comparison to Armco iron.

The circuits described herein and shown functionally in Fig. 1 are to be added to the HRT control circuit to provide control and protection for the revised HRT cooling water system. The circuitry will provide protection against excess pressure in the demineralized cooling water loop and cooling water activity, will initiate action to insure containment of activity in event of an explosion and will provide emergency cooling water from the tower basin when required.

The OCUSOL-A program (ORNL-CF-57-6-4) for Univac is a modification of the Eyewash (ORNL-1925) multi-group, multi-region reactor code. The group=energy-lethargy-temperature relationship are given in Table A. The element code numbers are given in Table B. The cross sections now on the sigma-tape are given in tables in the Appendix numbered with the element code number. This technical report explains the bases for choosing the cross sections.

A general program has been written to plot curves on the Oracle curve plotter. A description of the code and complete instructions for preparation of input tapes and operation of the code are given. The code tape is available from the Mathematics Panel or from the author.

Sanderson & Porter have carried out a series of studies over the last four years which indicate that the pebble-bed reactor way be an attractive way to obtain low-cost power. At the request of the Atomic Energy Commission, two design studies have been carried out on this concept at the Oak Ridge National Laboratory. The first of these a preliminary design of a 10-Mw(t) reactor experiment, the PRRE, was initiated September 10, and a report on the study was issued November 1960. The second phase of the work, a conceptual design study of a 330-Mw (e) central station, was initiated November 1, and is the subject of this report.

A carrier containing 138.99 liters of solution, uranium concentration 202.04 g/liter with an isotopic concentration of 97.3% U-233, was prepared for shipment. The total uranium was 28,062 +/- 60 g (95% confidence level) and the U-233, 27,305 +/- 66 g (95% confidence level).

A portable shield has been designed, developed, fabricated and shop tested to provide the HRT with a facility for direct dry maintenance operations. It provides temporary replacement for any one of the lower roof plugs and should permit many operations to be performed without flooding the reactor cell with water.

The use of mercury as a solvent in the recovery of uranium from spent fuels is of the interest at Oak Ridge National Laboratory. The vapor pressure of mercury is lowered by increased concentration of uranium. By dew-point measurements, the vapor pressure at 175°C was found to very between 2 and 8mm of mercury, and at 375°C, between 300 and 1100 mm of mercury, depending upon composition as described below. Plots of the log of mercury vapor pressure vs. the reciprocal of absolute temperature gave a family of straight lines. Each line corresponded to one of the composition: UHg2, UHg3, UHg4, and a saturated solution of UHg4 in Hg. No Mutual solubility of the intermetallics was indicated.

The enthalpies and heat capacities of seventeen fluoride mixtures in the liquid state have been determined using Bunsen Ice Calorimeters and copper block calorimeters. The fluoride mixtures were composed of the fluorides of two or more of the following metals: lithium, sodium, potassium, beryllium, zirconium, and uranium. The enthalpies and heat capacities of most of these mixtures were studied in the solid state also. Estimates of the heat of fusion have been made. General empirical equations have been developed which represent the enthalpies and heat capacities of the fluoride mixtures in the liquid and in the solid state.

Experiments in the controlled melting of irradiated fuel specimens, particularly of the APPR, STR, and MTR types, have confirmed that prolonged heating in air at temperatures in excess of the melting point results in the release of a large portion of the radioactivity. On the other hand, a moderate amount of heating in air or steam sufficient only to melt a specimen results mainly in the partial volatilization of rare gases, iodine, bromine, cesium, and rubidium. In the presence of air or water vapor, strontium and other fission products are not released. At trace concentration of fission products, slow melting of the APPR plate at 1525 C in air or steam effected the release of 50% of the rare gases, 33% of the iodine, 9% of the cesium, and traces of strontium. After 25% burn-up, the cesium value increased to about 60%. Aluminum alloy of the MTR type, also at trace concentration, upon melting at 700 C released up to 2% of the iodine, 10% of the rare gases, and negligible portions of other fission products. Zirconium alloy of the STR type after 15% burn-up, when melted at 1850 C, released up to 95% of the rare gases, 90% of …

The technique of high-frequency titrimetry has been applied to the determination of thorium, uranium, sulfate, and free acid. In Part I of this report, the reproducibility of the method for the titration of standard solutions which contained 50mg of thorium in the absence of interferences is established. The coefficient of variation of the method, under these conditions, was found to be less than one per cent. In Part II, the effect of uranium on the high-frequency titration of thorium, as well as the application of the method to actual samples, is discussed. Uranium in a ratio of 5 to 1 to thorium can be tolerated. When the method is applied to the analysis of representative samples, the coefficient of variation is one per cent.

This technical report describes development work done on method of particle separation by the Biology Division of the Oak Ridge National Laboratory and the Oak Ridge Gaseous Diffusion Plant during the period January 1 to June 30, 1963, under the Joint National Institute for Health-Atomic Energy Commission Zonal Centrifuge Development Program. The central effort has been to develop zonal centrifuge systems for the separation of cells and sub-cellular particles, including viruses, and bio-colloids, including proteins and nucleic acids.

The effect of adding small quantities of fuel or poison to the HRT has been estimated using perturbation theory. The results have been reduced to a single relation and a set of graphs which make the estimation of added reactivity relatively simple. The perturbation theory results are compared with multigroup results and reasonable agreement is demonstrated; however, there is some question concerning the prompt neutron lifetime.

"This symposium is concerned with the basic aspects of radiation effects. When we turn to the genetic effects of radiation in mammals, there are so few aspects on which there is any information that the problem of sorting out the fundamental findings has hardly arisen. In this paper it will, therefore, be possible to survey most of what is known and pass on to a consideration of what is needed next. Since one of the purposes of this symposium is an interchange of views between investigators in different fields, an attempt will be made to avoid technical details. Among the practical needs in mammalian radiation genetics is a pressing one for more data on which to base estimates of the genetic hazards of radiation in man. The present paper will be concerned largely with this problem. Our own work is directed primarily in this direction, our objective being to uncover some of the basic facts in at least one mammal-the mouse. Before discussing the experimental work, however, it seems desirable to consider some of the general features of the genetic hazard of radiation."

The methods of analysis given in this report are those which were used in the Analytical Chemistry Division of the Oak Ridge National Laboratory for analyzing samples which were derived from the experimental work on the separation of the isotopes of boron by chemical exchange. The samples consisted principally of boron trifluoride solutions in anisole (methyl phenyl ether, CH30C6H5). The boron concentration ranged from a few parts per million to 5 or 6 per cent. Boron was determined on all samples. During the early stages of the project, iron and copper were occasionally determined, while a limited number of aqueous solutions and water extracts of anisole solutions of BF3 were analyzed for fluoboric and hydroxyfluoboric acids, boric acid, total boron, and total fluoride. Boron was determined by the use of either a spectrophotometric or volumetric method, depending on the amount available. Initially, if the amount of sample and boron concentration were such as to provide a total of at least 2 to 4 mg of boron, the volumetric method was utilized and found to be satisfactory. For smaller amount, the spectrophotometric method was used. Later, because of its greater speed and simplicity, the spectrophotometric method was used for samples in …

From July 7 to August 31, 1955, 20 tons of uranium and 1,200 g of plutonium were recovered in 47 days of plant operation at an average rate of 833 lb/day of uranium and at a cost of $2.60/lb of uranium. Uranium and plutonium recoveries were, respectively, 99.9 and 95.5 per cent.

The continuous dissolution of 304 stainless steel and stainless steel-UO2 alloy in dilute aqua regia was studied with subsequent stripping of the dissolver product to remove chloride ion. The process has the advantage of producing, by means of a simple head end treatment, a solvent extract feed in a conventional nitric acid medium so that existing solvent extraction processes, materials of construction and waste disposal methods can be used. The purposes of this study were to investigate the variables affecting the dissolution process and to obtain dissolver scale-up data, and to investigate the removal of chloride from the dissolver product and the variables affecting the stripping operation. A continuous flooded pot dissolver was used. It has the advantages of stability of operation and ease of control in comparison with column dissolvers and requires a minimum of mechanical processing prior to dissolution. Stripping of the dissolver product to remove chloride ion was studied in a 4-in. diameter Pyrex bubble-cap column containing 12 single bubble cap plates. Continuous dissolution rates and dissolver product stainless steel loading were correlated with aqua regia feed composition, acid feed rate and surface area exposed to reaction. Profiles of chloride concentration down the stripping column were obtained …

An annual report is given on the operation and costs of waste-disposal facilities at ORNL laboratories and operating buildings in the Bethel Valley area. The operations of the hot-chemical and metal-waste systems, the process-waste system, and the radioactive-gas-disposal system which utilized the 250-ft stack located in the Radioisotope area are discussed. The miscellaneous operations which include the SS (source and special nuclear) material control, SS material recovery, off-shift service for research divisions, water demineralization plant operations, and hydrogen liquefaction are included. However, the disposal of cooling water from LITR, off-gases from the Hot Pilot Plant, and the ORNL Graphite Reactor building are not covered by the report.

An investigation of the causes of observed explosive reaction of zirconium-coated uranium dioxide on dissolution in nitric acid was conducted. It was concluded that such a reaction is to be expected. Possible but unconfirmed methods of alleviating the problem are suggested.

In the operation of nuclear reactors, nuclear fuel reprocessing plants and in-pile experiments, special provision must be made for disposal of gaseous fission products to prevents contamination of the atmosphere to an unacceptable degree. A disposal process is described in which the noble gas fission products, krypton and xenon, are delayed relative to the sweep gas by physical adsorption as they pass through an adsorbent such as activated charcoal. A theoretical plate analysis, and has been verified experimentally. The retention time for a gas present in trace concentration is proportional to the amount of charcoal in the adsorber bed and to the adsorption coefficient which is evaluated experimentally for a particular combination of materials and conditions. The retention time is inversely proportional to the volume flow rate if the sweep gas.

After two batches (~ 340 kg) of fluoride salt from the ARE were reprocessed, pilot plant operations were terminated because of a leak through which an estimated 780 g of uranium (as UF6) escaped. Of the 21 kg of highly enriched uranium in the feed, 93.12% was collected as UF6 product, 0.13% represented measured losses, and 3.72% was unaccounted for (leak). An additional 3.03% was reclaimed from NaF beds and equipment washes. The product met both chemical purity and activity specifications for product level UF6. Decontamination from fission products was essentially complete. A gross gamma D.F. was apparently limited by the low activity of the feed salt.