From Introduction: "This paper presents the results of the investigation of the wing-alone and wing-fuelage configurations employing a wing with the quarter-chord line swept back 60^o, aspect ratio 4, taper ratio 0.6, and an NACA 65A006 airfoil section parallel to the free stream."

Report presenting a two-dimensional wind-tunnel investigation of a 6-percent-thick symmetrical circular-arc airfoil with leading-edge and trailing-edge high-lift devices. The purpose of the investigation was to determine the effects on maximum section lift coefficient of different leading-edge slats and drooped-nose flaps when used in combination with a plain trailing-edge flap. Results regarding slat configuration, drooped-nose-flap configurations, and a comparison of slat and drooped-nose-flap configurations are provided.

Memorandum presenting an investigation of the low-speed static stability characteristics of a canard model with a 45 degree sweptback wing and a 60 degree triangular horizontal control surface. Results regarding longitudinal stability and control and lateral stability and control are provided.

A typical inlet axial-flow compressor inlet stage, which was designed on the basis of constant total enthalpy with symmetrical velocity diagram at all radii, was investigated. At a tip speed of 1126 feet per second, a peak pressure ratio of 1.28 was obtained at an efficiency of 0.76. At a tip speed, the highest practical flow was 28 pounds per second per square foot frontal area with an efficiency of 0.78. Data for a rotor relative inlet Mach number range of from 0.5 to 0.875 indicates that the critical value for any stage radial element is approximately 0.80 for the stage investigated.

Report presenting a pressure-distribution investigation in the high-speed tunnel of a wing-fuselage configuration as part of an NACA research program to determine effects of wing geometry on aerodynamic characteristics and to explore the nature of flow over the configuration. Measurements were made on a fuselage and wing-fuselage combination for a range of Mach numbers. Results regarding accuracy, figures of pressure distributions, pressure distributions on the wing and fuselage, results at several angles of attack, section loading characteristics, normal-force characteristics, pitching-moment characteristics, pressure-drag characteristics, and fuselage skin-friction drag are provided.

Report presenting a wind-tunnel investigation to determine the low-speed longitudinal and lateral control characteristics of a model with a triangular wing with NACA 65(06)-006.5 airfoil sections, aspect ratio 2.31, and constant-chord control surfaces. The values of the hinge-moment parameters were found to be of somewhat greater magnitude than would be expected on unswept wings with the same aspect ratio.