Report presenting a continuous sampling-probe technique used to determine the percentage of JP-5 fuel spray evaporated under conditions common in ramjet engines. Fuel was injected contraststream from a multiple-orifice injector and sampling data were obtained at several distances downstream of the injector. An expression is generated for a description of this phenomenon.

Report presenting three types of aerodynamic interference originating from forward components of airplanes, which are shown to contribute to decreased vertical-tail effectiveness.

From Introduction: "It is the purpose of this report to assemble principles of induction-system design for flight to a Mach number of 2 and to use existing data to show the consequences of compromising them."

Report presenting an investigation on a transonic bump to determine the aerodynamic characteristics of a series of triangular wings. Four basic triangular-wing plan forms with different aspect ratios, taper ratios, and combinations of tip clipping were tested over a range of Mach and Reynolds numbers. Results regarding angle of attack, drag coefficient, pitching-moment coefficient with lift coefficient, and various curves are provided.

"The trajectories of waterdrops in air flowing over airfoils are determined for three airfoil - angle-of-attack combinations using the differential analyzer to solve the differential equations of motion of the waterdrops. From these trajectories the rate of water impingement, the area of impingement, and the distribution of impingement are determined as functions of two dimensionless moduli. Comparisons are made of the rate of water impingement on these airfoils and the rate of water impingement on cylinders" (p. 1).

"An investigation of the rolling effectiveness of spoiler and aileron aerodynamic controls on a fighter-type airplane has been conducted at Mach numbers from 0.6 to 1.5 by the Langley Pilotless Aircraft Research Division by utilizing rocket-propelled test vehicles. No effects of mutual interference between the midspan spoiler and the outboard aileron were detectable. Above the speed of sound, the ailerons were relatively ineffective as compared with the spoiler because of wing twisting" (p. 1).

Memorandum presenting an experimental study of the effects of several variations in configuration geometry on the aerodynamic characteristics of flat-top wing-body combinations. Generally, the configurations consist of one half of a body of revolution mounted beneath a wing of essentially arrow plan form. Results regarding the effect of trailing-edge sweep, effect of the addition of auxiliary bodies, effect of tip-flap deflection, effect of dihedral, effect of leading-edge sweep, effect of fuselage fineness ratio, effect of fuselage profile shape, and static longitudinal stability characteristics are provided.

Memorandum presenting two right circular cylinders tested in axial free flight over a Mach number range of 0.4 to 1.7 by using the rocket-boosted-model technique. Results regarding time history, basic data cross plots, center of pressure, and drag are provided.

Report of theoretical values of performance parameters for liquid hydrogen and flourine as a rocket propellant for a wide range of fuel-oxidant and expansion ratios. Parameters computed include specific impulse, combustion-chamber temperature, nozzle-exit temperature, equilibrium composition, mean molecular weight, characteristic velocity, coefficient of thrust, ratio of nozzle-exit area to throat area, specific heat at constant pressure, coefficient of viscosity, and coefficient of thermal conductivity.

Memorandum presenting the tail-pipe fuel ratio, mass flow of combustion gas, and radial fuel flow distribution on cooling requirements of tail-pipe burner with annular cooling-air passage.

Memorandum presenting an investigation of three models of a delta-wing airplane designed for a long-range subsonic cruise and a supersonic dash. Results regarding the aerodynamic characteristics of the models and effect of elevon deflection on aerodynamic characteristics of the four-engine model are provided.

Memorandum presenting three types of aerodynamic interference originating from forward components of airplanes, which are shown to contribute to decreased vertical-tail effectiveness. The vorticity originating from a slender fuselage ahead of the wing resulted in a marked reduction in vertical-tail effectiveness with angle of attack for one model.

Memorandum presenting a correlation of analyses of the effect of distributed surface injection on the heat transfer and skin friction associated with the turbulent boundary layer at high speeds to eliminate the effects of Mach and Reynolds number. Data for heat transfer and skin friction at three Mach numbers are compared with the analyses and the agreement is good.

Report presenting an investigation to evaluate the overall performance characteristics of several annular nose inlets in the supersonic wind tunnel at a Mach number of 3.85. The four experimental configurations investigated consisted of a one-cone, a one-cone with low angle cowl, a two-cone, and an isentropic inlet. Results regarding the internal-flow performance, force measurements at zero angle of attack, overall performance comparison at zero angle of attack, and angle-of-attack force measurement are provided.

Memorandum presenting an investigation in the 4- by 4-foot supersonic pressure tunnel to determine the effects of various vertical locations of the wing and horizontal tail on the aerodynamic characteristics in pitch and of a supersonic airplane configuration at Mach number 2.01. The model was equipped with a wing and horizontal tail, each having a 45 degree sweep and an aspect ratio of 4. The configurations investigated included a high-wing, a mid-wing, and a low-wing arrangement, each with four different horizontal tail locations varying from a position 0.208 semispan below to 0.556 semispan above the body center line.

Report presenting a preliminary study to determine the possibility of utilizing a wingless configuration as a guided missile. The results indicated that the maximum trimmed lift coefficient developed by the wingless missile was somewhat smaller than that of the winged missile at a Mach number of 2.4.

Report presenting an experimental investigation in the transonic blowdown tunnel to determine effects of center-of-gravity location on the transonic flutter characteristics of a 45 degree sweptback-wing plan form of aspect ratio 4.0 and taper ratio 0.6. Solid-construction models with streamwise NACA 65A004 airfoil sections and center-of-gravity locations at three different chords were fluttered at a range of Mach numbers.

Report presenting the effects of a straightening operation on the life of Inconel 500 buckets in a J33-9 engine. Results regarding engine performance and bucket-failure mechanism are provided.

Report presenting an investigation of an airplane configuration model with a 45 degree swept wing of aspect ratio 4.0 and a taper ratio 0.3 with a low swept horizontal tail to determine its longitudinal stability. Longitudinal aerodynamic coefficients and stability derivatives are presented as functions of Mach number over the test range. The results are compared to wind tunnel and rocket model data and generally show good agreement.

Report presenting an investigation at two Mach numbers for a range of Reynolds numbers to determine the pressure distributions at several spanwise stations for a series of 25.4-percent-chord trailing-edge controls on a trapezoidal wing with a 23 degree sweptback leading edge, aspect ratio of 3.1, and taper ratio of 0.4. The report contains the tabulated pressure data for the complete range of test variables.

Memorandum presenting an investigation of the effect of various metallic additives on the molten sodium hydroxide - nickel system. The hydrogen evolved from such systems was measured and the evolution was correlated with the effect of the metal on mass transfer. Results regarding a check with standard tests, purging, presence of two valences for chromium, reaction time of the additive, and pressure within nickel crucibles are provided.

Report presenting an experimental investigation to determine the effect of boundary-layer control and inlet lip shape on the performance of a side-inlet air-induction system for a fighter-type airplane. Two methods of boundary layer control and three inlet lip shapes were investigated at a range of Mach numbers and mass-flow ratios. Results regarding net propulsive thrust are also provided.

Memorandum presenting static crucible tests with additions of the reducing agents sodium chromite Na(sub 3)CrO(sub 4) and manganese dioxide MnO(sub 2) indicate that salts soluble in sodium hydroxide may be added to inhibit mass transfer in nickel. The metals manganese, vanadium, and molybdenum were also investigated in static crucibles and found to be ineffective.

Report presenting an investigation to determine the aerodynamic characteristics of a sting-mounted Douglas Aircraft Company store in the presence of an unswept semispan cantilevered wing of aspect ratio 4.0. Results regarding wing loads and store loads are provided.