Report describes the lubrication characteristics of an aircraft-type piston as visually studied in a V-type engine with a glass cylinder. Information about the movement of the piston, the piston rings, and the oil-control rings and their effect on lubrication is included.

Report presenting an analysis of the effects of heat and compressibility in the flow through the internal systems of aircraft. Equations and charts are developed whereby the flow characteristics at key stations in a typical internal system may be readily obtained.

Report presenting an investigation in the 19-foot pressure tunnel to determine the nacelle drag, the cowling-air flow, and the propeller characteristics of a model of a high-performance military airplane. The model is fitted with NACA D(sub S)-type engine cowlings and with propellers embodying NACA 16-series airfoil sections. Results regarding the propeller characteristics, drag and cowling-air flow with the propeller removed, the effect of propeller on flow through cowling, and the influence of cooling requirements on airplane performance are provided.

From Introduction: "The purpose of this analysis was to investigate the use of function of intake-manifold temperature and pressure, exhaust back pressure, and engine speed in place of a ventri as a means of measuring engine air consumption and to determine if this function is suitable for automatic mixture control."

Report presenting a convenient technical method to evaluate changes in the airfoil characteristics resulting from an extension of the chord at the trailing edge of a propeller blade section. The method determines the change in the angle of zero lift, the ideal angle of attack, and the difference in these angles as a function of the angle and length of the trailing-edge extension.

Report presenting tests made in the 4- by 6-foot vertical wind tunnel of an NACA 0009 airfoil with a 30-percent-chord flap with a medium amount of aerodynamic overhanging balance. In this investigation, the effects of the shape of the flap-nose overhang and the gap at the nose of the flap have been determined. The results indicate that, generally, the lift effectiveness of the aerodynamically balanced flap was increased slightly over that of a plain flap when a blunt or medium flap nose was used on the balanced flap.

From Summary: "Tests on the B-34 fin-rudder-tab assembly were performed in the NACA 8-foot high-speed tunnel. Two cases of tab flutter were studied. It was shown conclusively that the frequency of the original or heavy tab was too low and caused coupling with one of the lower bending frequencies. A general conclusion was made that the tab frequency should be considerably higher than the lower modes of the fin-rudder assembly because there is generally a weaker coupling between the tab and the higher mode responses."

Report presenting force-test measurements in two-dimensional flow in the 4- by 6-foot vertical tunnel to determine the characteristics of an NACA 0015 airfoil equipped with a straight-contour plain flap with a chord 30 percent of the airfoil chord. Results regarding the lift, hinge moment of flap, pitching moment, and drag are provided.

Report presenting 10 practical-construction models of sections of helicopter rotor blades tested in the NACA two-dimensional low-turbulence pressure tunnel at atmospheric pressure. Lift, drag, and pitching-moment characteristics of blades representing the present method of construction of the YR-4A helicopter were determined.

Report presenting two low-drag airfoils, the NACA 747A315 and the NACA 747A415, which are designed to have reduced pitching moments about the quarter-chord point and moderately high values of the design lift coefficient and are tested in the tow-dimensional low-turbulence pressure tunnel.

Report presenting a method for predicting from basic airplane characteristics the elevator deflection required to maintain optimum landing attitude. Charts for evaluating the components of the equation for elevator deflection and a comparison of computed and measured values for 15 airplanes are included. The computed deflection is considered the minimum value required to maintain landing attitude due to variations in piloting technique.

Report presenting hinge moment, lift, and pressure-distribution measurements made on a Frise aileron on an NACA 23012 airfoil in the two-dimensional test section of the stability tunnel. Speeds up to 360 miles per hour corresponding to a Mach number of about 0.470 were used.

Report presenting a series of related flying-boat hull forms with various combinations of aerodynamic and hydrodynamic requirements that were tested in an NACA tank and high-speed tunnel. Effects explored included varying the height of the bow, varying the height of the stern, increasing the angle of dead rise at the bow, decreasing the angle of dead rise on the afterbody, increasing the depth of step, increasing the angle of afterbody keel, adding chine flare, adding a third planing surface, and rounded chines at the bow.

A preliminary investigation made to study the hydrodynamic properties and general behavior of simple hydrofoils. Six plain, rectangular hydrofoils were tested in a tank at various speeds, angles of attack, and depths below the water surface. The results are presented as curves of the lift and drag coefficients plotted against speed for various angles of attack and depths for which the hydrofoils were tested.

Report describing the behavior of the heat meter when it is used in thermal circuits which are under the influence of transient potentials. Three scenarios are considered: a heat meter suddenly placed on a hot surface, a heat meter mounted on the interior surface of the cabin wall of an uninsulated airplane climbing through air of decreasing temperature, and a heat meter mounted on the interior surface of the composite cabin wall of an airplane climbing through air of decreasing temperature.

Report presenting wind-tunnel tests to determine the aerodynamic section characteristics of an NACA 0009 airfoil with a plain flap with a chord 25 percent of the airfoil chord and a balancing tab with a chord 50 percent of the airfoil chord or 200 percent of the flap chord so linked that the tab would deflect at a given rate with respect to the flap. Three linkage ratios were tested on the model. Results regarding theory and test results including lift and hinge moments are provided.

Tests were conducted on hydrofoil assemblies approximating an arrangement for use under seaplanes or surface boats. A series of hydrofoils, each supported by two struts, was towed at various depths ranging from partial submersions to a depth of 5-chord lengths. At depths greater than 4 or 5 chords, the influence of the surface of the water is small; hydrofoils operating at low speed will have characteristics similar to those of airfoils of the same section.

"As a part of a general investigation of control boosters, preliminary calculations were made to indicate the sizes of control boosters necessary to move the controls of airplanes of various sizes. The analysis was based on the assumption that the controls were moved with a rapidity and amplitude equal to that measured with a fighter airplane in simulated combat. A corollary purpose consisted in determining the effect on reducing booster-power unit size of incorporating an energy accumulator in the booster system" (p. 1).

"Aileron and elevator stick forces and rudder pedal forces for the Bell XP-83 airplane in spins have been calculated. The results indicate that the aileron and elevator stick forces may be excessive unless some suitable booster or more highly balanced control surfaces are used. The pilot will be able to move the surfaces only slightly from their normal floating locations" (p. 1).

Report presenting the effect of Reynolds number on the aerodynamic characteristics of a low-drag airfoil section tested under conditions of relatively high stream turbulence. The data are presented as curves of section angle of attack, section profile-drag coefficient, and section pitching-moment coefficient against section lift coefficient for various flap deflections.

From Summary: "Tests were made of an 0.309-chord double-slotted flap on an NACA 65, 3-118, a equals 1.0 airfoil section to determine drag, lift, and pitching-moment characteristics for a range of flap deflections. Results indicate that combination of a low-drag airfoil and a double-slotted flap, of which the two parts moved as a single unit, gave higher maximum lift coefficients than have been obtained with plain, split, or slotted flaps on low-drag airfoils. Pitching moments were comparable to those obtained with other high-lift devices on conventional airfoils for similar lift coefficients."

Report presenting a theoretical study of the effects of aileron adverse yawing moment on lateral maneuverability at a high lift coefficient. The study included the effects of changes in effective dihedral angle, vertical-tail area, and tail length.

"Two methods are presented for determining the horizontal location of the stick-fixed neutral point from wind-tunnel data. One method involves the solution of a mathematical equation; whereas the other method is a graphical solution for the same mathematical equation. The combined horizontal and vertical variation of the neutral point completely describes the stick-fixed longitudinal stability of airplanes that have large allowable center-of-gravity shifts" (p. 1).

Bulletin presenting the results of bending tests on a monocoque box with the door on the compression side. The results indicate that the effectiveness of a stress-carrying door depends on the intended function of the door.